离子注入中污染的产生及防护

本文概述了离子注入过程中污染产生的原因和防止污染的措施，特别强调了对微粒污染和金属污染的防护以满足ＵＬＳＩ加工对离子注入的要求。     

Improved Yen-Joye's authenticated multiple-key agreement protocol

An authenticated multiple-key agreement protocol is proposed. The protocol is not only secure against the unknown-key attack but also more efficient than other protocols.     

GaN and AlGaN high-voltage rectifiers grown by metal-organic chemical-vapor deposition

In this paper, we report the study of the electrical characteristics of GaN and AlGaN vertical p-i-n junctions and Schottky rectifiers grown on both sapphire and SiC substrates by metal-organic chemical-vapor deposition. For GaN p-i-n rectifiers grown on SiC with a relatively thin “i” region of 2 μm, a breakdown voltage over 400 V, and forward voltage as low as 4.5 V at 100 A/cm² are exhibited for a 60-μm-diameter device. A GaN Schottky diode with a 2-μm-thick undoped layer exhibits a blocking voltage in excess of ∼230 V at a reverse-leakage current density below 1 mA/cm², and a forward-voltage drop of 3.5 V at a current density of 100 A/cm². It has been found that with the same device structure and process approach, the leakage current of a device grown on a SiC substrate is much lower than a device grown on a sapphire substrate. The use of Mg ion implantation for p-guard rings as planar-edge terminations in mesageometry GaN Schottky rectifiers has also been studied.     

Fabrication of 1.55 μm VCSELs on Si using metallic bonding

Using AuGeNiCr multilayered metals as the wafer bonding medium, long-wavelength GaInAsP/InP vertical cavity surface emitting lasers employing Al-oxide/Si as the upper and lower distributed Bragg reflectors were fabricated on Si substrate with the bonding interface formed outside the vertical cavity surface emitting laser cavity. Laser emission at 1.545 μm was measured under pulsed operations near room temperature. The low-temperature metallic bonding process demonstrates a great potential in device fabrication     

Coplanar waveguide-fed uniplanar bow-tie antenna

The design of coplanar waveguide (CPW)-fed bow-tie antenna for the 2.4-GHz ISM band is described. A coplanar waveguide-to-coplanar strips (CPW-to-CPS) balun is used to obtain the balanced feed line for the printed bow-tie. An analysis method based on the mixed potential integral equation method is used to characterize the input characteristics of the bow-tie antenna. The numerical results obtained are in good agreement with the experimental data. Through experiments with bow-tie antennas of various extended angles, the bow-tie antenna with a 90° extended angle exhibits the widest bandwidth in the desired frequency band which has a bandwidth of 17% for a VSWR <1.5:1     

Color image retrieval based on hidden Markov models

In this correspondence, a new approach to retrieving images from a color image database is proposed. Each image in the database is represented by a two-dimensional pseudo-hidden Markov model (2-D PHMM), which characterizes the chromatic and spatial information about the image. In addition, a flexible pictorial querying method is used, by which users can paint the rough content of the desired images in a query picture. Image matching is achieved by comparing the query picture with each 2-D PHMM in the database. Experimental results show that the proposed approach is indeed effective.     

Handling multimedia information with VLSI

Identifies the basic technological components of multimedia communications. Among these technologies, multimedia processing and transmission already benefit heavily from VLSI advances. in fact, these two technologies could not have matured without special-purpose VLSI chips. We have examined basic processing required in these technologies and some VLSI architectures. The focus has been on standard-compliant VLSI chips, because the eventual goal of communications is to allow everyone to reach others without constraints. There are still a number of evolving standards, which means that we might witness yet another wave of VLSI chips for multimedia communications     

Comparison of stimulated-emission-pumping fluorescence dip spectrometry and conventional fluorescence spectrometry in application to supersonic jet spectrometry

Summary A supersonic jet spectrum of 9,10-dichloroanthracene is measured by stimulated-emission-pumping fluorescence dip spectrometry and conventional fluorescence spectrometry. The performance obtained is compared for these spectrometric methods, providing same information concerned with the energy level of the ground state. The former is more preferential for measurement of a high-resolution spectrum, since the spectral resolution is determined by the linewidth of the dumping laser. On the other hand, the latter is more preferential for measurement with better sensitivity at the expense of the spectral resolution, since the fluorescence throughput can be improved by increasing the slit width of the monochromator.Dedicated to Professor Dr. Wilhelm Fresenius on the occasion of his 80th birthday     

Recursive partition and amalgamation with the exponential family: Theory and applications

The theory of tree-growing (RECPAM approach) is developed for outcome variables which are distributed as the canonical exponential family. The general RECPAM approach (consisting of three steps: recursive partition, pruning and amalgamation), is reviewed. This is seen as constructing a partition with maximal information content about a parameter to be predicted, followed by simplification by the elimination of ‘negligible’ information. The measure of information is defined for an exponential family outcome as a deviance difference, and appropriate modifications of pruning and amalgamation rules are discussed. It is further shown how the proposed approach makes it possible to develop tree-growing for situations usually treated by generalized linear models (GLIM). In particular, Poisson and logistic regression can be tree-structured. Moreover, censored survival data can be treated, as in GLIM, by observing a formal equivalence of the likelihood under random censoring and an appropriate Poisson model. Three examples are given of application to Poisson, binary and censored survival data.     

Spontaneous magnetization of the Ising model on a 4–8 lattice

The spontaneous magnetization of the Ising model on a 4–8 lattice with six different coupling constants and two different magnetic moments is studied. A formula for the spontaneous magnetization is proposed. The result agrees with the exact low-temperature series expansions up to the 12th order.