La掺杂浓度对PLZT薄膜红外光学性质的影响

采用溶胶-凝胶法在Pt/Ti/SiO2/Si衬底上制备了不同La掺杂浓度PLZT(x/40/60)薄膜- x射线衍射分析表明制备的PLZT(x/40/60)薄膜是具有单一钙钛矿结构的多晶薄膜- 通过红外椭圆偏振光谱仪测量了波长为2-5—12-6μm范围内PLZT薄膜的椭偏光谱，采用经典色 散模型拟合获得PLZT薄膜的红外光学常数，同时也拟合获得PLZT薄膜的厚度- 随着La掺杂浓 度的增大，折射率逐渐减小- 而消光系数除PLZT(4/40/60)薄膜外，呈现逐渐增大的趋势- 分析表明这些差异主要与PLZ 关键词： PLZT薄膜 红外光学性质 红外椭圆偏振光谱     

Dependence of the driving current on the harmonic behavior of giant magneto-impedance voltage of Co-based amorphous wires

The frequency and the amplitude of the driving AC current dependence on the harmonic behavior of the giant magneto-impedance (GMI) voltage of Co-rich amorphous wire have been studied. Single-peak, two-peak and three-peak behavior in the GMI characteristics was studied with the change of amplitude and frequency of the AC current. GMI ratio was calculated from the first harmonic signals which were initially increased and then decreased monotonically with the increase of frequency (f) and the amplitude (I_AC) of the driving current. The response of the GMI voltage was found non-linear with the generation of higher harmonics at higher amplitude of the driving current. The second and third harmonic signals were also evaluated and their dependence on the driving current amplitude and frequency were presented in the paper. The experimental results were analyzed using single domain rotational model. The voltage harmonics were calculated through Fourier transform of the time derivative of the estimated circular magnetization of the sample.     

偏硅酸钙中Pr3+的4f5d态的光谱特性及Pr3+→Gd3+的能量传递

合成了高效发射UV光的CaSiO3:Pr^3 新型荧光体，研究了室温下Pr^3 的4f5d态的发射和激发光谱，Pr^3 的4f5d态的最低子能级向4f^2组态的^3H4，^3H6和^1G4能级跃迁产生UV发射，并不伴随有4f-4f能级跃迁的可见光发射。Pr^3 的浓度猝灭是由于辐射和无辐射能量传递造成的，同时，在CaSiO3中，存在Pr^3 →Cd^3 的能量传递，探讨了其能量传递特性。     

部分相干光束通过硬边光阑的推广光束传输M2因子

给出部分相干光通过硬边光阑后的强度二阶矩的计算公式，由此可得到部分相干光通过硬边光阑后的推广光束传输M^2因子。以部分相干高斯－谢尔模型光束为例，推导出相应的M^2因子，并作了数值计算和分析讨论。     

Magnetism in SiC implanted with high doses of Fe and Mn

High concentrations (0.1–5 at.%) of Mn or Fe were introduced into the near-surface region (≤2000 Å) of 6H-SiC substrates by direct implantation at ～300°C. After annealing at temperatures up to 1000°C, the structural properties were examined by transmission electron microscopy (TEM) and selected-area diffraction pattern (SADP) analysis. The magnetic properties were examined by SQUID magnetometry. While the Mn-implanted samples were paramagnetic over the entire dose range investigated, the Fe-implanted material displayed a ferromagnetic contribution present at <175 K for the highest dose conditions. No secondary phases were detected, at least not to the sensitivity of TEM or SADP.     

A Successful Implementation of Locating Passive Cooling Facilities: The Case of Northern Thailand

This paper reports the actual implementation of a location-allocation study, which is one aspect of the overall Passive Cooling (Thailand) Project conducted in Northern Thailand since 1985. The goal has been to generate decision supports for ‘optimal’ placements of cooling facilities and the assignment of sites to these facilities as part of the post-harvest handling-chain operation of agricultural products. The basic questions addressed in this work are the issues of how many facilities to set up and where to locate them for maximum utility. Our selected approach is to use discrete location-allocation modelling, as, among other reasons, the problem at hand has a most natural network setting. Direct methods as well as efficient heuristics are examined, and sample numerical results are reported as illustrations of the continual implementation.     

Nonminimum phase channel equalization using noncausal filters

The Viterbi algorithm is the optimum method for detection of a data sequence in the presence of intersymbol interference and additive white Gaussian noise. Since its computational complexity is very large, several simplifications and alternative methods have been proposed, most of which are more effective when dealing with minimum phase channels. We present a novel technique for the equalization of nonminimum phase channels that employs noncausal all-pass filters operating in reversed time. The impulse response of the equalized channel approximates a minimum phase sequence with higher energy concentration at its left-hand end than at the right-hand end. The method can be modified to obtain a desired impulse response with few nonzero samples with only minor variations in noise level, providing significant complexity reduction in the Viterbi algorithm for detection. In addition, a twopass decoding strategy is developed, leading to significant improvement in performance with little increase in computational cost. Simulation results are included to verify the advantages of the proposed techniques     

A multigrid method for predicting periodically fully developed flow

The use of multigrid methods in complex fluid flow problems is still under development. In this paper a full multigrid procedure has been incorporated in a finite volume solution for predicting fully developed fluid flow in a streamwise periodic geometry. Steady computations in two-dimensional body fitted co-ordinates have shown considerable savings in computation time by this multigrid method.     

Selective and nonselective wet etching of Zn0.9Mg0.1O/ZnO

Wet etch rates at 25°C for Zn_0.9Mg_0.1O grown on sapphire substrates by pulsed laser deposition (PLD) were in the range 300–1100 nm · min⁻¹ with HCl/H₂O (5×10⁻³−2×10⁻² M) and 120–300 nm · min⁻¹ with H₃PO₄/H₂O (5×10⁻³−2×10⁻² M). Both of these dilute mixtures exhibited diffusion-limited etching, with thermal activation energies of 2–3 kCal · mol⁻¹. By sharp contrast, the etch rates for ZnO also grown on sapphire by PLD were much slower in similar solutions, with rates of 1.2–50 nm · min⁻¹ in HCl/H₂O (0.01–1.2 M) and 12–54 nm · min⁻¹ in H₃PO₄/H₂O (0.02–0.15 M). The etching was reaction limited over the temperature range 25–75°C, with activation energies close to 6 kCal · mol⁻¹. The resulting selectivity of Zn_0.9Mg_0.1O over ZnO can be a high as ∼400 with HCl and ∼30 with H₃PO₄.     

Characterization and comparison of PECVD silicon nitride and silicon oxynitride dielectric for MIM capacitors

In this letter, we report on the electrical characteristic and the comparison of the metal-insulator-metal (MIM) capacitors with PECVD silicon nitride (SiN) and silicon oxynitride (SiON). Both capacitors are found to exhibit low leakage and high breakdown field strength, as well as absence of dispersive behavior, good linearity, and comparable quality factor behaviors.