The relation between luminous properties and oxygen content inZnS:TbOF thin-film electroluminescent devices fabricated byradio-frequency magnetron sputtering method

The purpose of this paper is to study the relationship between the oxygen concentration and brightness degradation in ZnS:TbOF green thin-film electroluminescent (EL) devices. The characteristics including crystallinity, optical, and electrical properties were discussed. The brightness-voltage (B-V) measurement results shelved that with higher oxygen-content in ZnS:TbOF phosphor layer, lower brightness was measured. It was consistent with the poor crystallinity, worse photoluminescent intensity, and easier to get moisture in the oxygen-rich (O/Tb>1) phosphor film. Furthermore, deep level transient spectroscopy (DLTS) measurements identified that when the O/Tb ratio was greater than 1, the oxygen-related deep hole traps E_H1 and/or E_H2 could be detected in the ZnS:TbOF phosphor layer. These E _H1 and/or E_H2 traps were believed to be the main killers for the brightness of the device since they capture most of the holes from the generated electron-hole pairs. This evidence strongly supports that the modified energy transfer model is more dominant than direct impact excitation during the luminescent process     

Multidimensional augmented current equation including velocityovershoot

The augmented drift-diffusion current equation, which includes velocity overshoot effects through the space derivatives of the electric field, cannot be directly extended beyond one dimension. A new formalism is developed which considers the carrier heating and the distribution relaxation effects to obtain a multidimensional augmented drift diffusion current equation. The equivalent mobility containing the velocity overshoot correction is derived from the perturbation analysis on the carrier temperature using the energy balance equation. The issues related to the numerical implementation of this generalized model and the validity of the assumptions are also discussed     

光孤子相互作用对压缩态的影响

在线性近似条件下，量子化了非线性薛定谔方程，用后向传播法数值求解了光孤子相互作用对压缩比的影响。数值结果表明，在碰撞距离附近，压缩比显著增加。     

中央电视台第一个数字化演播室视频系统介绍

数字电视系统在提高图像质量方面已显示出极大的优越性。因此，世界各国电视台都已开始数字化的进程，中国也不例外。本文详细介绍了中央电视台第一个数字化演播室－８００ｍ＾２演播室的视频系统，包括视频系统数字信号格式的确定，主要设备的特点以及演播室数字视频系统的主要特点等，供广大同行参考。     

Loss performance of tagged and normal ATM cells at a partiallyshared buffer

The loss performance of tagged and normal ATM cells at a first-in-first-out (FIFO) buffer is studied. The authors show that if a partial buffer sharing mechanism is adopted the loss probability of normal cells can be firmly guaranteed, regardless of the traffic intensity of tagged cells     

彩色PDP用玻璃基板

本文讨论了彩色ＰＤＰ现用钠钙玻璃的热稳定性，指出由于这种玻璃在热处理过程中易变形和收缩，因而不适合作大面积彩色ＰＤＰ基板材料，介绍了彩色ＰＤＰ基板玻璃的制造方法和特点。最后介绍了日本旭硝子公司和美国康宁公司各自为彩色ＰＤＰ新开发的玻璃基板材料ＰＤ２００和ＣＳ２５。     

精密角位移传感器及其可靠性研究

从理论上探讨了磁阻率效应，叙述了精密角位移传感器的工作原理及结构设计。传感器的分辨率已达０．０１°，通过可靠性寿命试验，传感器的失效率λ（ｔ）＜１×１０－７／ｈ。     

Passive gain-equalized wide-band erbium-doped fiber amplifier using samarium-doped fiber

A passive gain-equalization technique of erbium-doped fiber amplifier (EDFA) using a samarium-doped fiber to obtain wide-band flattened gain operation is reported. In the wavelength range from 1529-1559-nm, small inter-channel gain variations can be achieved. This simple technique is suitable for multiwavelength wide-band in-line-amplifier cascaded transmission applications.     

Si_（1－x）Ge_x／Si定向耦合器的研制

在运用ＳｉＧｅ脊形波导单模条件和有效折射率法分析ＳｉＧｅ／Ｓｉ定向耦合器结构参数的基础上，采用分子束外延和各向异性腐蚀技术制备出Ｓｉ１－ｘＧｅｘ／Ｓｉ（ｘ＝０．０５）单模定向耦合器．在波长为１．３μｍ时，平均串音小于－１８．１ｄＢ，输出功率耦合效率达到９８．１％     

Deep levels,electrical and optical characteristics in SnTe-Doped GaSb Schottky Diodes

The GaSb layers investigated were grown directly on GaAs substrates by molecular beam epitaxy (MBE) using SnTe source as the n-type dopant. By using admittance spectroscopy, a dominant deep level with the activation energy of 0.23-0.26 eV was observed and its concentration was affected by the Sb₄/Ga flux ratio in the MBE growth. A lowest deep-level concentration together with a highest mobility was obtained for GaSb grown at 550°C under a Sb₄/Ga beam equivalent pressure (BEP) ratio around 7, which should correspond to the lowest ratio to maintain a Sb-stabilized surface reconstruction. In the Hall measurement, an analysis of the temperature-dependent mobility shows that the ionized impurity concentration increases proportionally with the sample’s donor concentration, suggesting that the ionized impurity was introduced by an SnTe source. In addition, optical properties of an undoped p-, a lightly and heavily SnTe-doped GaSb layers were studied by comparing their photoluminescence spectra at 4.5K.