On trading wavelengths with fibers: a cost-performance based study

We consider the effect of multiple fibers on wavelength division multiplexing networks without wavelength conversion. We study networks with dynamic wavelength routing and develop accurate analytical models to compare various possible options using single- and multiple-fiber networks. We use results of an analytical model and simulation-based studies to evaluate the blocking performance and cost of multifiber networks. The number of fibers required providing high performance in multifiber networks and their costs are compared. A case is made for using multiple fibers in each link with fewer wavelengths instead of using a single fiber with many wavelengths. In particular, we show that a network with four fibers per link and with four wavelengths on each fiber without any wavelength conversion on any node yields similar same performance as the networks with one fiber per link and 16 wavelengths per fiber on each link and with full wavelength conversion capability on all nodes. In addition, the multifiber network may also offer the cost advantage depending on the relative cost of components. We develop a parametric cost model to show that multiple fibers in each link are an attractive option. Finally, such multifiber networks also has fault tolerance, with respect to a single fiber failure, already built into the system.     

Passive alignment method of polymer PLC devices by using a hot embossing technique

A novel fabrication process using a hot embossing technique has been developed for micromechanical passive alignment of polymer planar lightwave circuit (PLC) devices. With only one step of embossing, single-mode waveguide straight channels and micropedestals for passive aligning are simultaneously defined on a polymer thin film with an accuracy of /spl plusmn/0.5 /spl mu/m. This process reduces the steps for fabricating alignment structures. A fabricated polymer PLC chip and fibers are combined on a v-grooved silicon optical bench (SiOB) in a flip-chip manner. The process provides a coupling loss as low as 0.67 dB per coupling face and a cost-effective packaging solution for various polymer PLC devices.     

High-performance MIM capacitor using ALD high-k HfO/sub 2/-Al/sub 2/O/sub 3/ laminate dielectrics

For the first time, we successfully fabricated and demonstrated high performance metal-insulator-metal (MIM) capacitors with HfO/sub 2/-Al/sub 2/O/sub 3/ laminate dielectric using atomic layer deposition (ALD) technique. Our data indicates that the laminate MIM capacitor can provide high capacitance density of 12.8 fF//spl mu/m/sup 2/ from 10 kHz up to 20 GHz, very low leakage current of 3.2 /spl times/ 10/sup -8/ A/cm/sup 2/ at 3.3 V, small linear voltage coefficient of capacitance of 240 ppm/V together with quadratic one of 1830 ppm/V/sup 2/, temperature coefficient of capacitance of 182 ppm//spl deg/C, and high breakdown field of /spl sim/6 MV/cm as well as promising reliability. As a result, the HfO/sub 2/-Al/sub 2/O/sub 3/ laminate is a very promising candidate for next generation MIM capacitor for radio frequency and mixed signal integrated circuit applications.     

正交数字上变频器AD9857的使用

介绍数字正交上变频器AD9857的原理、功能和基本使用方法以及如何通过单片机8051实现对它的编程控制。     

Combining ideal beamforming and Alamouti space-time block codes

The simplest Alamouti space-time block code is coupled with a larger number of transmit antennas via ideal beamforming to achieve higher diversity gain. It is shown that the combined system can remain both full diversity and full code rate without orthogonality loss. Simulation results show a significant performance gain over the conventional space-time block codes.     

SiGe VCOs operating up to 88 GHz, suitable for automotive radar sensors

VCOs fully integrated in an SiGe preproduction technology are presented. By cutting interconnection lines a wide frequency range can be covered, up to 88.4 GHz. Special effort has been made to meet the demands for 77 GHz automotive radar. In the corresponding tuning range from 75.3 to 79.6 GHz, an output power of about 11 dBm (with -2.2 dBm potential measurement uncertainty) was achieved for each of the two complementary outputs, i.e. in total 14 dBm. The phase noise is about -94 dBc/Hz at 1 MHz offset frequency.     

网络管理中事件关联检测机制的研究

网络事件的关联检测是网络管理需要解决的一个关键问题,本文根据分布式网络管理的特点,首次明确定义了网络事件的基本关联关系,在此基础上提出了一种基于Petri Net的事件关联检测机制,实现了基于事件内容的细粒度关联检测,并且在事件检测中充分考虑了时间因素,有效地提高了事件关联检测的准确性。     

Analysis of the time response of multiconductor transmission lineswith frequency-dependent losses by the method ofconvolution-characteristics

A new method for analysis of the time response of multiconductor transmission lines with frequency-dependent losses is presented. This method can solve the time response of various kinds of transmission lines with arbitrary terminal networks. Particularly, it can analyze nonuniform lines with frequency-dependent losses, for which no effective method for analyzing their time response exists. This method starts from the frequency-domain telegrapher's equations. After decoupling and inversely Fourier transforming, then a set of decoupled time-domain equations including convolutions are given. These equations can be solved with the characteristic method. The results obtained with this method are stable and accurate. Two examples are given to illustrate the application of this method to various multiconductor transmission lines     

氢化丁苯共聚物结构的核磁共振波谱表征Ⅱ.微观结构的定量计算

在氢化丁苯共聚物¹³C-NMR谱脂肪碳部分谱带归属的基础上,根据各谱带的主要来源,推导出六个二单元浓度的计算公式。计算出二单元、一单元的相对含量,各结构单元的数均序列长度、嵌段含量和其它结构参数。加氢前后的¹H-和¹³C-NMR谱的组成计算结果基本一致。初步探讨了作为粘度指数改进剂的氢化丁苯共聚物微观结构与性能的关系,为合成提供了依据。     

The correlation of texture and magnetic properties in Co-Cr films

This investigation focuses on the correlation between the crystallographic orientation of grains with respect to magnetic properties in Co-Cr films. Based on a distribution measured for the (0002) crystallographic pole densities, modified formulae describing the texture were used to calculate the coercivity Hc, the squareness ratio Rs (Mr⊥/TMs) and the anisotropy field Ha for Co-Cr films. In general, calculated values for the coercive force He agreed well with the measured values. The calculated Rs⊥. values were much larger than the measured ones, however, indicating that the influence of the demagnetizing field and the magnetostriction on the orientation of the magnetization cannot be neglected. On leave from Institute of Computing Technology, Academia Sinica, P.O.Box 2704-6, Beijing, P.R. China.