Olive mill wastewater treatment by a pilot-scale subsurface horizontal flow (SSF-h) constructed wetland

Performances of a pilot-scale reed bed for the olive mill wastewater (OMW) treatment were investigated, by monitoring influent and effluent pH, total suspended solids (TSS), chemical oxygen demand (COD), total Kjeldahl nitrogen (TKN), total phosphorus and polyphenols. In order to reduce the suspended matter concentration and to avoid clogging, OMW was pre-treated by adding lime putty, calcium hydroxide and hydraulic lime. The best results were obtained with 2 g/L of hydraulic lime. Pre-treated OMW was dosed in the reed bed at dilution ratios of 1/3 and 1/10 (v/v), pointing up that the latter only did not give rise to reed suffering and allowed to obtain good and durable removal efficiencies, above all for COD (74.1+/-17.6%) and polyphenols (83.4+/-17.8%). Recycling of the effluent was quite effective for the improvement of the wastewater quality, allowing a further removal of 26-70%, depending on the parameter taken into account. A post-dosage study, carried out by feeding the reed bed with the effluent of an activated sludge plant, pointed up a rapid decreasing of the outlet concentrations of the investigated parameters to values compatible with Italian regulations concerning wastewater discharge in surface water. Polyphenols were the exception, being their outlet concentration at the end of post-dosage study around 2 mg/L.     

Digests or extracts?—Some interesting but conflicting results for three widely differing polluted sediment samples

Three sets of samples have been investigated in some detail. One set is from a river polluted by mine workings, containing substantial levels of Fe, Mn,Cu, Zn and Ni with traces of many other metals. The second set consists of typical estuarine sediments contaminated from a wide range of industrial sources, and the third set consists of oily drilling cuttings from the sea bottom in the vicinity of a North Sea oil production platform.These samples have been subjected to treatment 1) with EDTA at two different pH's (extracts) 2) with HNO₃/H₂O₂ 3) with HNO₃/HCl and 4) with HNO₃/HCl/HF (digests). EDTA recoveries, compared toaqua regia digests, are often very reproducible, not dependent on pH, and usually significantly low. Nitric/peroxide andaqua regia digests often give very close results suggesting that these are meaningful values indicating the maximum levels of polluting metals in the sediments. However, the triple acid digest with HF does sometimes give higher values (and reasonable agreement for CRM's such as MESS-1) but with poorer reproducibility.     

Role of catechin on collagen type I stability upon oxidation: a NMR approach

Abstract

The study focuses on the understanding, at molecular level, the mechanism of interaction between protein and flavonoids. Collagen and catechin interactions were investigated by NMR in solution and solid state. The effect of catechin on the stability of collagen to oxidation was also explored. Collagen was treated with two concentrations of catechin solutions. Oxidation was carried out by incubation of collagen solution with three oxidation systems: Fe(II)/H₂O₂, Cu(II)/H₂O₂, and NaOCl/H₂O₂. The effects of oxidation systems were evaluated by high resolution 1?D and 2?D proton spectroscopy and solid state NMR (¹³C CP MAS) experiments. Interactions between collagen and catechin preferentially occur between catechin B ring and the amino acids Pro and Hyp of collagen. Results showed that both iron and copper oxidation systems were able to interact with collagen by site specific attack. Moreover, catechin protects collagen proline from oxidation by metal/H₂O₂ systems, preventing copper and iron approach to collagene molecule;this behaviour was more evident for the copper/H₂O₂ system.     

Is the ring conformation the most critical parameter in lipase-catalysed acylation of cycloalkanols?

CAL-B catalysed the resolution of several five and six-membered cyclic beta-hydroxy esters efficiently with the exception of the cis-cyclohexanol (+/-)-4. When employing molecular modelling techniques the conformation turned out to be the most important determinant for their reactivity towards O-acetylation. In all cases, the R enantiomers reacted faster than the S enantiomers since the reactive intermediates of the former can adopt more favourable ring conformations and thus experience less steric hindrance in the active site. Furthermore, the minimised structure for the main conformer of R-4 showed that the axial hydrogens in the 3 and 5-positions with respect to the hydroxyl group prevent the enzymatic reaction.     

One-step electrochemical synthesis of pure poly(2,5-dicyano-p-phenylenevinylene) films

In this communication we describe the electrochemical synthesis of poly(2,5-dicyano-p-phenylenevinylene) (DCNPPV) polymer films on indium tin oxide substrates. We investigate the purity, morphology, absorption and emission properties of the film. The purity was checked by infrared spectroscopy. The film formed presented spectroscopic purity equivalent to the chemically prepared PPV that was dialyzed for one week. Scanning electron microscopy of the surface revealed a grain-like morphology. The absorption and emission spectra showed absorption and emission bands at 420 nm and 575 nm, respectively, with the absorption onset at 422 nm, which corresponds to an energy gap of 2.25 eV. The electrochemical determination of the energy gap gives 2.05 eV, thus quite close to the optical energy gap at the onset of absorption. The EA and IP were determined by electrochemical measurements and are 3.46 eV and 5.51 eV, respectively.

The mass spectra of [17-13C]phyllocladene and [3-13C]methylenecholestane—III

The mass spectra of [17-¹³C]phyllocladene and [3-¹³C]methylenecholestane have been examined. It is shown that there are some rearrangements at 70 e V as in the case of [17-¹³C]kaurene. However, no extensive randomization is evident at the molecular ion level. The results are interesting because very little is known about ¹³C randomization in polycyclic aliphatic hydrocarbons. The percentage retention of label was calculated for each ion.     

Electrokinetic molecular separation in nanoscale fluidic channels

This report presents a study of electrokinetic transport in a series of integrated macro- to nano-fluidic chips that allow for controlled injection of molecular mixtures into high-density arrays of nanochannels. The high-aspect-ratio nanochannels were fabricated on a Si wafer using interferometric lithography and standard semiconductor industry processes, and are capped with a transparent Pyrex cover slip to allow for experimental observations. Confocal laser scanning microscopy was used to examine the electrokinetic transport of a negatively charged dye (Alexa 488) and a neutral dye (rhodamine B) within nanochannels that varied in width from 35 to 200 nm with electric field strengths equal to or below 2000 V m-1. In the negatively charged channels, nanoconfinement and interactions between the respective solutes and channel walls give rise to higher electroosmotic velocities for the negatively charged dye than for the neutral dye, towards the negative electrode, resulting in an anomalous separation that occurs over a relatively short distance (<1 mm). Increasing the channel widths leads to a switch in the electroosmotic transport behavior observed in microscale channels, where neutral molecules move faster because the negatively charged molecules are slowed by the electrophoretic drag. Thus a clear distinction between "nano-" and "microfluidic" regimes is established. We present an analytical model that accounts for the electrokinetic transport and adsorption (of the neutral dye) at the channel walls, and is in good agreement with the experimental data. The observed effects have potential for use in new nano-separation technologies.     

Inoculum studies in production of penicillin g acylase by Bacillus megaterium ATCC 14945

This article reports studies concerning the production of penicillin G acylase (PGA) by Bacillus megaterium. This enzyme has industrial use in the hydrolysis of penicillin G to obtain 6-aminopenicillanic acid, an essential intermediate for the production of semisynthetic β-lactam antibiotics. Although most microorganisms produce the enzyme intracellularly, B. megaterium provides extracellular PGA. The enzyme production by microorganisms involves several steps, resulting in a many operational variables to be studied. The study of the inoculum is an important step to be accomplished, before addressing other issues such as culture optimization and downstream processing. In this study, using a standard inoculum as reference, several runs were performed aiming at the definition of operational conditions in the PGA production. Cell concentration and PGA activity in the production medium were measured after 24, 48, and 72 h of the beginning of the production phase. This study encompasses the duration of the inoculum germination phase and the concentration of cells used to startup the germination. Based on these results, PGA productivity during the production phase was maximized. The selected values for these variables were 1.5 × 10⁷ spores/mL of germination medium, germination during 24 h, and 72 h for the production phase.     

A Total Synthesis of FK-506(1)

A total synthesis of FK-506 (1) is presented. The synthesis features a highly convergent approach utilizing a block coupling strategy. Top and bottom half sections of the molecule are coupled by addition of a vinyl cuprate with a spiroenone. The alpha-allyl aldol functionality is revealed by a reductive opening of the spiroenone system. The labile alpha,beta-diketoamide hemiketal portion of the molecule is prepared by a late stage generation and oxidation of a masked enediol. Top and bottom half segments are themselves derived by coupling of smaller subunits, resulting in a very convergent route.