Zn(BTZ)2白色有机电致发光材料的合成及其器件制备

以PCl₃为脱水剂,将邻氨基硫酚与水杨酸脱水环化合成出2-(2-羟基苯基)苯并噻唑,并进一步将所得产物与乙酸锌反应合成出2-(2-羟基苯基)苯并噻唑螯合锌(Zn(BTZ)₂)材料。以该配合物作为发光层制备出结构为ITO/PVK:TPD/Zn(BTZ)₂/Al近白色电致发光器件,其色坐标位于白场之内(x=0.242,y=0.359),在驱动电压为16V时,亮度达3200cdm²,对应的量子效率为0.32%。进一步在Zn(BTZ)₂中掺入橙红色染料Rubrene,制成ITO/PVK:TPD/Zn(BTZ)₂:Rubrene/Al结构器件,实现了纯白色发光(色坐标值:x=0.324,y=0.343),非常接近于白色等能点,且量子效率达0.47%。最后对上述器件的发光和电学性能进行了深入的研究和探讨。     

ns脉冲激光对K9玻璃的破坏实验

 采用高速PIN光电探测器和高带宽的数字存储示波器，实时检测透射光脉冲和散射光脉冲的变化特征，并将之用作材料破坏的光学判据，测量得到K9玻璃在1.06μm纳秒脉冲激光作用下的能量损伤阈值约18mJ，相应的能量密度阈值为1.0kJ/cm²。通过分析透射光脉冲和散射光脉冲的特征，给出了材料的破坏时刻，并推断出K9玻璃所能承受的极限光强为10¹⁵W/m²。研究了能量透过率与泵浦能量的关系，并初步探讨了透明材料的破坏机理。结果表明：在多纵模激光的作用下，透明光学材料破坏是电离击穿与自聚焦效应综合作用的结果。     

连续照明时成像对比度与气象条件的关系

 通过同轴激光连续照明成像模型分析了大气后向散射对成像对比度的影响，得出了考虑散射因素时成像对比度的计算公式。基于不同气象条件下大气粒子散射特点，讨论了霾和雾两种不同天气时成像对比度随照明距离的变化规律，并与实验结果进行了对比，计算结果与实验吻合较好。     

Isolation of 2-Chloro-5-methylpyridine from its Isomer 2-Chloro-3-methylpyridine by Formation of its Copper(II) Complex

2-Chloro-5-methylpyridine is an important intermediate for the preparation of biological active compounds, especially insecticides1, e.g. imidacloprid2, and is usually manufac- tured from 3-methylpyridine N-oxide. However, the manufacturing process also forms the by-products: 3-methylpyridine and its isomer 2-chloro-3-methylpyridine3. The pro- perties of the isomers are similar, it is difficult to separate by ordinary methods, such as distillation. Scheme 1 79.4%13.6%5.2%NClCH3NCH3ClNC…     

Baker＇s Yeast Mediated Reduction of Optically Active Diketone

Baker‘s yeast mediated reduction of optically active diketone is described. The two keto groups are efficiently differentiated and the ee value of the recovered material is considerably raised. It affords highly optically active key intermediates efficiently for the synthesis of natural polyhydroxylated agarofuran products.     

The First and Facile Synthesis of (±) Syringaresinol

The first and facile synthesis of (±)syringaresinol was described.     

Boundedness of Multilinear Operators on Herz Type Spaces： Extreme Cases

In this paper, two classes of closely related multilinear singular and fractional integrals,which include the commutators as special cases, are studied and their boundedness on Herz type spaces is discussed. In fact, it is proved that these operators are actually not bounded in certain extreme cases.     

花丝内插物强化竖直管内凝结换热的实验研究

1前言大空隙率多孔体管内插物-绕花丝内插物，被认为是强化管内凝结换热的最有效途径之一[1]．但以往的研究，由于实验雷诺数范围较小，蒸汽速度较低，要正确全面评价其性能尚显不够。本文在原有工作的基础上，进一步完善了实验系统，改进了测试手段，扩大了实验雷诺数范围，并测试了其阻力性能，对花丝内插物强化管内凝结换热进行了较深入全面的实验研究，以全面评价花丝内插物对管内凝结换热的强化效果。2实验系统本文实验系统如图1所示。实验段是一个竖直套管冷凝器，如图2所示．本试验研究蒸汽完全凝结时的传热。凝结水流量采用容积法计…     

三维流动传热空隙率计算程序FASTOR—3D开发研究

1引言大粘度（大r）和大系数（ss和sc）法是处理流动区域中障碍物的常用方法山。但当流动区域中障碍物数量较多时，宜采用空隙率来模拟障碍物，如模拟反应堆流动传热的商用程序COMMIX［’］。我们根据空隙率模拟的基本概念，针对采用交错网格的压力校正法，自行编制了多障碍物流动传热三维计算的全部源程序代码，应用于某核反应堆钠池流动传热的数值模拟，获得了比较合理的结果。2数学模型和数值方法2．1控制方程空隙率修整的质量、动量、能量及湍流动能与耗散率的守恒方程通式的三维柱坐标形式为其中中一1，。，。，。，T，k，。分别表…     

一种辐射源距离的估算方法

提出利用测量设备与辐射源相对运动速度及测量设备所接收到的辐射功率的估算测量设备到辐射源距离的一种方法。对计算精度进行了分析，通过算例对理论分析进行了检验。