An ab initio calculation of symmetric bending and stretching vibrational states of the H3O+ and D3O+ ions

Calculations are reported for the symmetric bending and stretching vibrational states of H₃O⁺ and D₃O⁺ including coupling between these two modes. The calculations were carried out by using a potential surface calculated by the SCF CI method and expressed in terms of symmetric internal coordinates. The transition energy of the ν₂ (1^? ← 0⁺) inversion mode is found to be 985 cm^?1, which is comparable to the experimental value of 954.417 cm^?1 observed by Haese and Oka. The calculated inversion doubling of the lowest state is 51 cm^?1.     

Monolithic octadecylsilyl-silica gel column for the high-speed ion chromatographic determination of acidity

A monolithic ODS-silica gel column modified by saturating it with lithium dodecylsulfate (Li-DS) was used to demonstrate the high-speed separation of H+ from other mono- and divalent cations, such as Na+, NH4+, K+, Mg2+ and Ca2+ using ion chromatography (IC). Using a 5 mM EDTA-2K solution containing 0.10 mM Li-DS (pH 4.80) as eluent, H+ was eluted with a sharp and symmetrical peak within 1.0 min before other cations at a flow-rate of 1.5 ml min(-1). The rapid elution of H+ and its conductimetric detection could be attributed to the presence of EDTA (HY2-), which can convert H+ ions as anions. i.e. H(+) + H2Y(2-) --> H3Y(-). The acidity of rainwater and deionized water samples was determined using this IC system with satisfactory results.     

Monomer-isomerization polymerization. XXIII.. Monomer-isomerization polymerization of 5-phenyl-2-pentene with ziegler–natta catalysts

5-Phenyl-2-pentene (5Ph2P) was found to undergo monomer-isomerization polymerization with TiCl₃–R₃Al (R = C₂H₅ or i-C₄H₉, Al/Ti > 2) catalysts to give a polymer consisting of exclusively 5-phenyl-1-pentene (5Ph1P) unit. The geometric and positional isomerizations of 5Ph2P to its terminal and other internal isomers were observed to occur during polymerization. The catalyst activity of alkylaluminum examined to TiCl₃ was in the following order: (C₂H₅)₃Al > (i-C₄H₉)₃Al > (C₂H₅)₂AlCl. The rate of monomer-isomerization polymerization of 5Ph2P with TiCl₃–(C₂H₅)₃Al catalyst was influenced by both the Al/Ti molar ratio and the addition of nickel acetylacetonate [Ni(acac)₂], and the maximum rate was observed at Al/Ti = 2.0 and Ni/Ti = 0.4 in molar ratios.     

Reaction of poly(vinyl chloride) with magnesium and grignard reagents

Reaction of poly(vinyl chloride) with magnesium under various conditions was attempted, but poly(vinyl chloride) did not react with magnesium. The reactions of poly(vinyl chloride) with benzylmagnesium chloride and allylmagnesium chloride as Grignard reagents were carried out in tetrahydrofuran at reflux temperature. It was found that the chlorine atoms in the poly(vinyl chloride) were replaced by benzyl and allyl groups by the coupling reaction, and a small amount of Grignard reagent of poly(vinyl chloride) was formed by the magnesium–halogen exchange reaction. The extent of the substitution increased with increasing reaction time and concentration of the Grignard reagent.     

Determination of l-lactate by differential pulse polarography with covalently immobilized enzyme on Chitopearl

Summary The covalent bonding of l-lactate oxidase (no E.C.) to cross-linked copolymers of chitosan (Chitopearl) using the glutaraldehyde method is described and applied to the determination of l-lactate in serums of diseased and normal animals. The bioreactor packing of the immobilized enzyme is stable for at least 4 months and can be continuously used for the rapid and simple determination of l-lactate. The reduction current of pyruvate, corresponding to the product of enzymatic reaction, is determined by differential pulse polarography. The reproducibility (RSD) for 10 mol/l l-lactate is 0.78% (n=6) and the detection limit is 0.62 mol/l (k=2, confidence level 97.72%).     

Li ion diffusion in Li4Ti5O12 thin film electrode prepared by PVP sol-gel method

Li₄Ti₅O₁₂ thin films for rechargeable lithium batteries were prepared by a sol-gel method with poly(vinylpyrrolidone). Interfacial properties of lithium insertion into Li₄Ti₅O₁₂ thin film were examined by cyclic voltammetry (CV), electrochemical impedance spectroscopy (EIS), and potentiostatic intermittent titration technique (PITT). Redox peaks in CV were very sharp even at a fast scan rate of 50 mV s⁻¹, indicating that Li₄Ti₅O₁₂ thin film had a fast electrochemical response, and that an apparent chemical diffusion coefficient of Li⁺ ion was estimated to be 6.8×10⁻¹¹ cm² s⁻¹ from a dependence of peak current on sweep rates. From EIS, it can be seen that Li⁺ ions become more mobile at 1.55 V vs. Li/Li⁺, corresponding to a two-phase region, and the chemical diffusion coefficients of Li⁺ ion ranged from 10⁻¹⁰ to 10⁻¹² cm² s⁻¹ at various potentials. The chemical diffusion coefficients of Li⁺ ion in Li₄Ti₅O₁₂ were also estimated from PITT. They were in a range of 10⁻¹¹-10⁻¹² cm² s⁻¹.     

Synthesis of 6-phenyl-5,6,7,8-tetrahydro-4H-1,3,2,6-dioxathiazocine 2-oxides

Four 6-phenyl-5,6,7,8-tetrahydro-4H-1,3,2,6-dioxathiazocine 2-oxides were synthesized by the reaction of the corresponding N,N-bis(2-hydroxyethyl)aniline with thionyl chloride in the presence of triethylamine.     

Synthesis of polyanionic glycopolymers for the facile assembly of glycosyl arrays

Polyanionic glycopolymers were synthesized aiming at establishing a simple process for assembling glycosyl arrays. The synthetic glycopolymers carry the key carbohydrate epitopes of α-d-galactobioside (Gb₂), β-lactoside, and α-d-mannopyranoside, each of which serves as a ligand of bacterial toxins and adhesion proteins. The Gb₂ epitope, prepared from penta-O-acetyl-d-galactopyranose, was coupled with poly(ethylene-alt-maleic anhydride) in a polymer reaction to afford a Gb₂-embedded glycopolymer having also carboxylate (COO⁻) polyanions at the side chain. The polyanionic glycopolymer was then applied to a preparation of sugar-coated gold electrodes, which involves an alternating layer-by-layer adsorption based on electrostatic interactions. The presence of the Gb₂-coat on the surface was evidenced by Fourier transform infrared reflection absorption spectroscopy. The Gb₂-coated glyco-chip was stable in 10 mM HEPES buffer containing 150 mM NaCl aq. Other glycopolymers carrying the β-lactoside and α-d-mannopyranoside epitopes were applied to the same assembling process. The derived glycosyl arrays will be useful for detecting Shiga toxins, other pathogenic toxins and viruses when applied as glyco-chips for surface plasmon resonance or quartz crystal microbalance technique.     

ALL-trans β-CAROTENE-5,6-EPOXIDE IN THYLAKOID MEMBRANES

All- trans β-carotene-5,6-epoxide has been found in the thylakoid membranes of spinach and of the cyanobacterium Synechococcus vulcanus Copeland. The epoxide was extracted from the thylakoid membranes with acetone, and was isolated by high-performance liquid chromatography (HPLC). The structure of the epoxide was identified by means of mass, Raman, and electronic absorption spectroscopy. Changes in the amount of the epoxide, as a result of epoxidation and (apparent) de-epoxidation reactions in the membranes, were traced by analysis of extracts on HPLC. In isolated thylakoid membranes, only the epoxidation reaction took place. The reaction was caused by irradiation or by the addition of ferricyanide, suggesting that electron transport reactions in the membranes are involved in the epoxidation. In intact spinach leaves, however, both epoxidation and de-epoxidation took place; the extent of epoxidation correlated with the intensity of light incident on the leaves. The epoxidation and de-epoxidation of all- trans β-carotene are contrasted with those of xanthophylls (in the violaxanthin cycle).