Influence of substrate bias voltage on structure and properties of the CrAlN films deposited by unbalanced magnetron sputtering

The CrAlN films were deposited on silicon and stainless steel substrates by unbalanced magnetron sputtering system. The influence of substrate bias on deposition rate, composition, structure, morphology and properties of the CrAlN films was investigated. The results showed that, with the increase of the substrate bias voltage, the deposition rate decreased accompanied by a change of the preferred orientation of the CrAlN film from (2 2 0) to (2 0 0). The grain size and the average surface roughness of the CrAlN films declined as the bias voltage increases above −100 V. The morphology of the films changed from obviously columnar to dense glass-like structure with the increase of the bias voltage from −50 to −250 V. Meanwhile, the films deposited at moderate bias voltage had better mechanical and tribological properties, while the films deposited at higher bias voltage showed better corrosion resistance. It was found that the corrosion resistance improvement was not only attributed to the low pinhole density of the film, but also to chemical composition of films.     

Stochastic partial functional differential equations with locally monotone coefficients,locally Lipschitz non-linearity and delay

In this paper, we study the existence and uniqueness of strong solutions for stochastic partial functional differential equations with locally monotone coefficients, locally Lipschitz non-linearity, and time delay. Our results extend previous results obtained by Liu–Röckner, Caraballo et al. and Taniguchi et al. Examples are given to illustrate the wide applicability of our results.     

Intelligent Information‐Centric Networking routing scheme under imprecise information

Information‐Centric Networking (ICN) has been accepted to overcome some weaknesses of the current Internet architecture, showing that “what is being exchanged” is more important than “who are exchanging information.” Given the inadequate considerations on Quality of Service (QoS) and energy saving in ICN routing, we propose in this paper a routing algorithm to enhance the two aspects. At first, on one hand, Cauchy distribution is used as a fuzzy model to evaluate users' QoS requirements, such as bandwidth, delay, and error rate; on the other hand, we formulate energy saving problem to evaluate the green quality of routing algorithm. Then, we design a link selection approach by considering QoS and energy saving, which belongs to a multi‐objective decision problem resolved by intelligent drops algorithm. Finally, we implement the proposed algorithm and compare it with the famous adaptive forwarding mechanism in terms of some significant metrics, and the experimental results reveal that the proposed algorithm is more efficient.     

Ultranarrow Bandwidth Organic Photodiodes by Exchange Narrowing in Merocyanine H‐ and J‐Aggregate Excitonic Systems

Ultranarrowband organic photodiodes (OPDs) are demonstrated for thin film solid state materials composed of tightly packed dipolar merocyanine dyes. For these dyes the packing arrangement can be controlled by the bulkiness of the donor substituent, leading to either strong H‐ or strong J‐type exciton coupling in the interesting blue (H‐aggregate) and NIR (J‐aggregate) spectral ranges. Both bands are shown to arise from one single exciton band according to fluorescence measurements and are not just a mere consequence of different polymorphs within the same thin film. By fabrication of organic thin‐film transistors, these dyes are demonstrated to exhibit hole transport behavior in spin‐coated thin films. Moreover, when used as organic photodiodes in planar heterojunctions with C₆₀ fullerene, they show wavelength‐selective photocurrents in the solid state with maximum external quantum efficiencies of up to 11% and ultranarrow bandwidths down to 30 nm. Thereby, narrowing the linewidths of optoelectronic functional materials by exciton coupling provides a powerful approach to produce ultranarrowband organic photodiodes.     

适用于高阶QAM解调的载波恢复算法及其实现验证

高阶正交幅度调制（QAM）系统中,随着QAM信号阶数的提高,频偏和相偏对系统解调性能的影响越敏感,其对同步性能的要求也越来越高。因此,必须在接收端对系统中的频偏和相偏进行更精确的补偿,使得接收端与发送端的载波信号达到同频同相,来提高解调系统的性能。本文首先简单介绍了两种常用两种面向判决的载波相位恢复算法,并利用MATLAB／Simulink为该算法搭建了系统仿真模型进行分析,然后给出了具体的实现方法并对其性能进行了分析。仿真结果表明,面向判决的载波恢复算法实现简单,稳态时抖动较小,非常适用于高阶QAM解调系统。     

自启动、宽调谐的ps掺Yb双包层光纤激光器

对连续泵浦的自启动、宽调谐的ps脉冲掺Yb^3＋双包层光纤激光器进行了实验研究。采用20m单模掺Yb^3＋双包层光纤作为增益介质,利用77MHz射频信号的声光调制器（AOM）作为频移器以及体光栅构成外腔,得到了重复频率为1GHz、平均功率为56．3mW以及脉宽小于60ps的脉冲,激光器的调谐范围超过40nm。     

可靠性预计方法及思考

本文介绍了可靠性预计的目的,并对当前较为常见的可靠性预计模型或方法做了比较和说明,也对造成可靠性预计局限性的原因做了分析,最后对在可靠性工程工作中对待可靠性预计的态度做了探讨.     

Exosome-Coated Zeolitic Imidazolate Framework Nanoparticles for Intracellular Detection of ATP

The intracellular delivery of metal-organic frameworks(MOFs)encapsulated with functional biomolecules represents a promising av-enue in the field of biomedicine...     

Investigations of the optical and EPR spectra for VO2+ in LiKSO4 crystals

The optical spectra and EPR spectra (characterized by the spin-Hamiltonian parameters g(//), g(perpendicular), A(//) and A(perpendicular)) for the molecular ion VO2+ in LiKSO4 crystals are calculated from two microscopic theory methods, one of which is the complete diagonalization (of energy matrix) method (CDM) and the other is the perturbation theory method (PTM). The calculated three optical absorption bands and four spin-Hamiltonian parameters from the two methods are not only close to each other, but also in reasonable agreement with the experimental values. It appears that both theoretical methods are effective in the explanation of optical and EPR spectra for 3d1 ions in crystals. The negative signs of hyperfine structure constants A(//) and A(perpendicular) for VO2+ in LiKSO4 crystals are also suggested from the calculations.     

Shape-specific detection based on fluorescence resonance energy transfer using a flexible water-soluble conjugated polymer

We present the detection of the shape-specific conformation of DNA based on the fluorescence resonance energy transfer (FRET) by using a novel flexible water-soluble cationic conjugated polymer (CCP). The flexible backbone of CCP has more conformational freedom with the potential to be responsive to analyte shape by electrostatic interaction between flexible CCP and negatively charged DNA. The analyte shape dependent recognition is accomplished by structural changes that compressed or extended the flexible CCP. The morphology-dependent spectral properties of the novel flexible polymer related to the analyte shapes are investigated in detail, where two types of chromophores, referred to as "isolated" segment and "packed" segment aggregates, within the flexible polymer are identified by means of ensemble and single molecule measurements upon binding with different geometric DNA. The change in fluorescence intensity upon binding with shape-specific DNA without obvious color shifts makes this novel flexible polymer a suitable CCP donor for FRET measurements. The results provide insights for understanding the spectral properties of flexible water-soluble CCP and CCP/DNA interaction related to the geometry of target analyte.