Synthesis and surface properties of self-crosslinking core–shell acrylic copolymer emulsions containing fluorine/silicone in the shell

Stable emulsions of a core–shell acrylic copolymer (non-crosslinkable V0, and crosslinkable V2, V4, V6, and V8, where the numbers indicate the wt% of crosslinking agent based on the total acrylate monomer content) containing butyl acrylate (BA, 45 wt%), glycidyl methacrylate (GMA, 45 wt%), heptadecafluorodecyl methacrylate (PFA, 10 wt%), and various contents of crosslinking agent (vinyltriethoxysilane, VTES) were synthesized using a three-stage seeded emulsion polymerization process with a small amount of surfactant. The average particle size and viscosity of emulsions increased significantly with increasing VTES content. This study examined the effects of the VTES content on the surface/mechanical properties of self-crosslinked copolymer film samples containing a fixed acrylate monomer content to find the optimum VTES content. XPS showed that the film–air surface of the copolymer samples had a higher fluorine/silicone content than the film–dish interface. The tensile strength/modulus, thermal stability, and two Tgs (α and β Tgs) of the film samples increased significantly with increasing VTES content. The contact angle of the film samples increased with increasing VTES content up to approximately 6 wt%, and then decreased slightly. The optimum VTES content was approximately 6 wt% based on the total acrylate monomer content to obtain a high water/oil repellent coating material (V6) with the highest water/methylene iodide-contact angles (118.2°/81.8°) and lowest surface energy (18.4 mN/m).     

A discussion on mass resolution in secondary ion mass spectrometry

Mass resolution is a very important parameter for mass spectrometry. It is necessary to compare the mass resolution between the newly developed TOF-SIMS and the conventionally high-performance magnetic SIMS. However, the definitions of mass resolution for these two types of instruments are quite different. Whether it is possible to compare mass resolution and how to do such comparison is a challenge. This problem was raised officially during the 2012 ISO/TC 201 meeting at Tampa, Florida, the United States and the long-term cooperation with ISO started afterwards. The definition of mass resolution is one of the most important and fundamental problems for mass spectrometry and should attract significant attention. Here, some detail discussions on mass resolution as well as the related experimental studies in the past few years, including the collaborations with ISO/TC 201/SC6 and SC1 are summarized. This summary covers the common problem for almost all the current existing and still used definitions of mass resolution. A reasonable new definition for mass resolution considering the peak shape or resolution function has been proposed, which has also been confirmed by using experimental studies of the mass resolution comparison between TOF and magnetic SIMS. This study lays a foundation for the future mass resolution comparisons between different mass spectrometry.     

Expanding the chemical space: Discovery of new anticancer 3-arylbenzofuran derivatives

A new chemical space was generated via C₂-functionalization of 3-arylbenzofurans. Mannich reaction of 3-arylbenzofurans with secondary amines and formaldehyde allowed for installation of aminomethyl unit at C₂ position of benzofurans. A formyl group at C₂ site introduced as a result of Vilsmeier-Haack formylation of 3-arylbenzofurans was employed as a reacting partner for three-component Kabachnik-Fields reaction with various amines and triethyl phosphite to give a wide variety of aminomethylphosphonates. Furthermore, several benzo[d]oxazoles and pyrrolo[1,2-a]quinoxalines were prepared by using the formyl group. Biological screening of the synthesized compounds revealed that the benzofuran bearing a pyrrolo[1,2-a]quinoxaline moiety ( 5b ) most potently inhibited the viability of human blood cancer cells, but not solid tumor cells. Caspase activity assay, analysis of Annexin V-positive cells, and Western blot analysis indicated that 5b -induced death of human lymphoma U937 cells could result from its potential to induce the caspase-dependent apoptotic death of blood cancer cells with inhibition of ERK activation.     

Whole-Cell Photoenzymatic Cascades to Synthesize Long-Chain Aliphatic Amines and Esters from Renewable Fatty Acids

Long-chain aliphatic amines such as (S,Z)-heptadec-9-en-7-amine and 9-aminoheptadecane were synthesized from ricinoleic acid and oleic acid, respectively, by whole-cell cascade reactions using the combination of an alcohol dehydrogenase (ADH) from Micrococcus luteus, an engineered amine transaminase from Vibrio fluvialis (Vf-ATA), and a photoactivated decarboxylase from Chlorella variabilis NC64A (Cv-FAP) in a one-pot process. In addition, long chain aliphatic esters such as 10-(heptanoyloxy)dec-8-ene and octylnonanoate were prepared from ricinoleic acid and oleic acid, respectively, by using the combination of the ADH, a Baeyer–Villiger monooxygenase variant from Pseudomonas putida KT2440, and the Cv-FAP. The target compounds were produced at rates of up to 37 U g⁻¹ dry cells with conversions up to 90 %. Therefore, this study contributes to the preparation of industrially relevant long-chain aliphatic chiral amines and esters from renewable fatty acid resources.     

A Highly Efficient All‐Solid‐State Lithium/Electrolyte Interface Induced by an Energetic Reaction

The energetic chemical reaction between Zn(NO₃)₂ and Li is used to create a solid‐state interface between Li metal and Li_6.4La₃Zr_1.4Ta_0.6O₁₂ (LLZTO) electrolyte. This interlayer, composed of Zn, ZnLi_x alloy, Li₃N, Li₂O, and other species, possesses strong affinities with both Li metal and LLZTO and affords highly efficient conductive pathways for Li⁺ transport through the interface. The unique structure and properties of the interlayer lead to Li metal anodes with longer cycle life, higher efficiency, and better safety compared to the current best Li metal electrodes operating in liquid electrolytes while retaining comparable capacity, rate, and overpotential. All‐solid‐state Li||Li cells can operate at very demanding current–capacity conditions of 4 mA cm^?2–8 mAh cm^?2. Thousands of hours of continuous cycling are achieved at Coulombic efficiency >99.5 % without dendrite formation or side reactions with the electrolyte.     

Vibro-impact analysis of two adjacent cantilever beams

Nonlinear Dynamics - This study analyzes the vibro-impact behavior of two adjacent cantilever beams subjected to vibration generated by applying harmonic excitation to their rigid base. For the...     

Trace determination of beta-lactam antibiotics in surface water and urban wastewater using liquid chromatography combined with electrospray tandem mass spectrometry

A sensitive and reliable method using liquid chromatography-electrospray tandem mass spectrometry has been developed and validated for the trace determination of beta-lactam antibiotics in natural and wastewater matrices. Water samples were enriched by solid-phase extraction. The analytes included amoxicillin (AMOX), ampicillin (AMP), oxacillin (OXA), cloxacillin (CLOX) and cephapirin (CEP). Average recoveries of beta-lactams (BLs) in fortified samples were generally above 75% (except amoxicillin) with the standard deviations lower than 10% in water matrices. Amoxicillin was not quantified due to poor recovery (less than 40%) in the investigated water matrices. Matrix effects were found to be minimal when measuring these compounds in water matrices. The accuracy, within- and between-run precision of the assay fell within acceptable ranges of 15% absolute. The method detection limit (MDL) was estimated to range between 8 and 10 ng/L in surface water, 13 and 18 ng/L in the influent and 8 and 15 ng/L in the effluent from a wastewater treatment plant. A large number of actual water samples were analyzed using this method in order to evaluate the occurrence of the beta-lactams in a river and a wastewater treatment plant in northern Colorado. Most of the samples were negative for all analytes. These compounds were found at 15-17 ng/L in the three influent samples and at 9-11 ng/L in three surface water samples out of a total of 200 samples. This indicates that contamination by beta-lactam antibiotics is of minor importance to the small mixed-watershed.     

巯基化合物自组装单分子层的研究进展

超薄层有机材料的制备与研究￣［１］受到人们的广泛关注，有关研究结果和进展正在不断丰富着人类对表面结构与性质关系的理解和认识。与其它制备单分子层的技术相比，自组装技术是一种较新的制备方法，在８０年代后期，迅速成为有关学科的研究焦点。采用此技术制备的超薄层体系主要有两类：一类是巯基化合物在金、银、铜、铂表面吸附形成的单层￣［２，３］，一类是在硅、玻璃、金属氧化物表面通过硅烷化反应形成的单层￣［４］。其中，硫醇类分子自组装单层（ｓｅｌｆ－ａｓｓｅｍｂｌｅｄｍｏｎｏｌａｙｅｒ，３ＡＭ）是被研究得最为广泛和深入的体系。本文主要综述十年来巯基化合物ＳＡＭ的研究进展。     

Numerical Analysis of Air Flows for Korean Traditional House

The present investigation is to examine the thermal behaviors of air flows inside Korean traditional house made of the construction materials transmitted. The research methodology is numerical predictions of air flows depend on the temperature distribution inside the house. The transient numerical experiments are performed along with the different house types, weather condition, and operating time of heating. Thermal properties of building units have been obtained by the parallel measurements and utilized in the numerical works. Consequently, the details of flows and temperature of air in the houses illustrate the thermal design of the traditional Korean house satisfy the requirements of human living. Main interest of the present investigation lies on the looking for optimum arrangements of contact region, such as a window and door are made of traditional materials, with the outside. The model shows equivalent thermal performance to the figure of the modern house using concrete structure and composite insulations. Observation and validation have been carried out by numerical predictions according to turning of the seasons. Details of flows both inside and outside of the house are prepared for the explanations of the merits of the traditional unit for Hanok. In addition, insulating flow patterns inside a room of Hanok are depicted for prefixed probe region.