Chiral Lewis acid-catalyzed asymmetric Baylis-Hillman reactions

An effective chiral Lewis acid-catalyzed asymmetric Baylis-Hillman reaction is described. Good to high enantioselectivities were obtained using 3 mol % chiral catalyst. Novel camphor-derived dimerized ligands were prepared from the condensation of (+)-ketopinic acid with the corresponding diamines and hydrazine under acidic conditions. When alpha-naphthyl acrylate was used as a Michael acceptor, the reaction is complete within 20 min with high stereoselectivity and in reasonable chemical yields.     

Assessment of corrosion resistance of surface-coated galvanized steel by analysis of the AC impedance spectra measured on the salt-spray-tested specimen

In the present work, corrosion resistance of surface-coated galvanized steel was quantitatively determined by an analysis of the alternating current (AC) impedance spectra measured on the salt-spray-tested specimen. To evaluate the corrosion resistance of the surface-coated galvanized steel, AC impedance spectroscopy was performed on the salt-spray-tested specimen previously exposed to salt-sprayed corrosive environment. From the analysis of the impedance spectra, the area fraction transient of white rust θ ₂(t) was theoretically derived from the equivalent circuit equation by using two fitting parameters. The values of the two fitting parameters were determined by fitting the empirical transient equations to the area fraction of the resin coating layer and to the total resistance obtained from the impedance spectra measured, respectively. From the analyses of θ ₂(t) for four kinds of surface-coated galvanized steels with various resin coating layers, it is indicated that as the values of the two fitting parameters decrease in the order of CP, GI, OD and OM (commercial trade names) specimens, the corrosion resistance increases in that order as well. Furthermore, from the quantitative comparison of the two fitting parameters with the polarization resistance of the upper resin coating layer R _p determined from the potentiodynamic polarization curve, it is suggested that the two fitting parameters decrease in value as well with increasing R _p.     

Effect of Fiber-Polymer Interactions on Fracture Toughness Behavior of Carbon Fiber-Reinforced Epoxy Matrix Composites

The effect of anodic oxidation on high-strength polyacrylonitrile-based carbon fibers has been studied in terms of fiber surface energetics and fracture toughness of the composites. According to contact angle measurements based on the wicking rate of a test liquid, anodic oxidation leads to an increase in surface free energy, mainly due to the increase of its specific (or polar) component. For the carbon-fiber-reinforced epoxy resin matrix system, a direct linear relationship is shown between the specific component and the critical stress intensity factor measured by the single edge notched beam fracture toughness test. From a surface-energetic point of view, the anodic treatment may be suitable for carbon fibers incorporated in a polar organic matrix, resulting in an increased specific component of the surface free energy. Good wetting plays an important role in improving the degree of adhesion at interfaces between fibers and matrices of the resulting composites. Copyright 2000 Academic Press.     

Oxidative Addition vs. Ligand-Exchange: Fe(II)-Mixed-Phenylchalcogenolate Complexes fac-[PPN][Fe(CO)3(TePh)n(SePh)3-N] (n = 1, 2)

Diphenyldichalcogenides (PhE)₂ (E = Te, Se) react with Fe(0)-phenylchalcogenolate [PPN] [PhEFe(CO)₄] to yield the products of oxidative addition, Fe(II)-mixed-phenylchalcogenolate fac- [PPN][Fe(CO)₃(TePh)_n(ScPh)_3-n] (n = 1, 2). Reactions of [PPN][REFe(CO)₄] (E=Se, R=Me; E=S, R=Et) and diphenyldichalcogenides yielded ligand-exchange products [PPN][PhEFe(CO)₄] (E=Te, Se, S). The compounds [Fe(CO)₃(TePh)(ScPh)₂]^? (l) and [Fe(CO)₃(TePh)₂ (2) crystallize in the isomorphous monoclinic space group C_2/e, with a = 32.035(8), b = 11.708(6), c = 28.909(6) Å, Z = 8, R = 0.048, and R_w = 0.044 (1); with a = 32.089(5), b= 11.745(2), c = 28.990(8) Å, Z = 8, R = 0.048, and R_w = 0.048 (2). The complexes 1 and 2 crystallize as discrete cations of PPN⁺ and anions of [Fe(CO)₃(TcPh)_u(ScPh)_3-n] (n=1, 2), and one half solvent molecule THF. The geometry around Fe(II) is a distorted octahedron with three carbonyl groups and three phenylchalcogenolate ligands occupying facial positions.     

Experimental evidence of structural transition from fcc to bulk bcc in nanophase metal clusters of (Fe)n, (Cr)n, (Mo)n and (W)n produced by CO2 laser multiphoton decomposition of metal carbonyls

We have produced nanophase metal clusters, (Fe)_n, (Cr)_n, (Mo)_n and (W)_n, by multiphoton decomposition of the corresponding metal carbonyls with a 10.6 μm CO₂ laser in the presence of Ar and SF₆. The size distribution was narrow and the average diameter was 6, 3.5, 2 and 1 nm for Fe, Cr, Mo and W clusters, respectively. The structure was found to be bcc for both Fe and Cr clusters, fcc for Mo clusters, and amorphous for W clusters (note that all the bulk metals have bcc structure). Considering the cluster sizes (9630, 1870, 230 and 30 for Fe, Cr, Mo and W clusters, respectively) estimated from their average diameters, it is likely that there exists a structural transition from fcc to bulk bcc with increasing cluster size in these metal clusters.     

Microphase separation of cationic poly(N-isopropylacrylamide) copolymers in water: Effect of the migration of charges

The structures of aqueous copolymer solutions have been examined through small angle neutron scattering. The copolymers contained mostly N-isopropylacrylamide (NIPAM) monomers. Poly (NIPAM) solutions have a lower critical solution temperature (LCST), above which the macromolecules separate from water. A small fraction of ionizable N,N-[(dimethylamino) propyl] methacrylamide (MADAP) monomers was introduced into the macromolecules. This had dramatic consequences on the solution behavior at temperatures above the LCST of PNIPAM, where phase separation would have been expected for the homopolymer. When all MADAP monomers were ionized, it was found that the solutions resisted the phase separation. At short spatial scales, the chains were collapsed but at large scales they formed branched aggregates that did not separate out of water. When only half of the MADAP monomers are ionized, the electrical charges were able to redistribute themselves along the chains. In this case, the rise in temperature caused a microphase separation where the electrical charges were relocated on a fraction of the chains that remained in solution.The other chains (or section of chains) formed large nodules of a polymer rich phase.     

Six-coordinate and five-coordinate Fe(II)(CN)(2)(CO)(x) thiolate complexes (x = 1, 2): synthetic advances for iron sites of [NiFe] hydrogenases

The dicyanodicarbonyliron(II) thiolate complexes trans,cis-[(CN)(2)(CO)(2)Fe(S,S-C-R)](-) (R = OEt (2), N(Et)(2) (3)) were prepared by the reaction of [Na][S-C(S)-R] and [Fe(CN)(2)(CO)(3)(Br)](-) (1). Complex 1 was obtained from oxidative addition of cyanogen bromide to [Fe(CN)(CO)(4)](-). In a similar fashion, reaction of complex 1 with [Na][S,O-C(5)H(4)N], and [Na][S,N-C(5)H(4)] produced the six-coordinate trans,cis-[(CN)(2)(CO)(2)Fe(S,O-C(5)H(4)N)](-) (6) and trans,cis-[(CN)(2)(CO)(2)Fe(S,N-C(5)H(4))](-) (7) individually. Photolysis of tetrahydrofuran (THF) solution of complexes 2, 3, and 7 under CO led to formation of the coordinatively unsaturated iron(II) dicyanocarbonyl thiolate compounds [(CN)(2)(CO)Fe(S,S-C-R)](-) (R = OEt (4), N(Et)(2) (5)) and [(CN)(2)(CO)Fe(S,N-C(5)H(4))](-) (8), respectively. The IR v(CN) stretching frequencies and patterns of complexes 4, 5, and 8 have unambiguously identified two CN(-) ligands occupying cis positions. In addition, density functional theory calculations suggest that the architecture of five-coordinate complexes 4, 5, and 8 with a vacant site trans to the CO ligand and two CN(-) ligands occupying cis positions serves as a conformational preference. Complexes 2, 3, and 7 were reobtained when the THF solution of complexes 4, 5, and 8 were exposed to CO atmosphere at 25 degrees C individually. Obviously, CO ligand can be reversibly bound to the Fe(II) site in these model compounds. Isotopic shift experiments demonstrated the lability of carbonyl ligands of complexes 2, 3, 4, 5, 7, and 8. Complexes [(CN)(2)(CO)Fe(S,S-C-R)](-) and NiA/NiC states [NiFe] hydrogenases from D. gigas exhibit a similar one-band pattern in the v(CO) region and two-band pattern in the v(CN) region individually, but in different positions, which may be accounted for by the distinct electronic effects between [S,S-C-R](-) and cysteine ligands. Also, the facile formations of five-coordinate complexes 4, 5, and 8 imply that the strong sigma-donor, weak pi-acceptor CN(-) ligands play a key role in creating/stabilizing five-coordinate iron(II) [(CN)(2)(CO)Fe(S,S-C-R)](-) complexes with a vacant coordination site trans to the CO ligand.     

Two-particle friction in a mesoscopic solvent

The effects of hydrodynamic interactions on the friction tensors for two particles in solution are studied. The particles have linear dimensions on nanometer scales and are either simple spherical particles interacting with the solvent through repulsive Lennard-Jones forces or are composite cluster particles whose atomic components interact with the solvent through repulsive Lennard-Jones forces. The solvent dynamics is modeled at a mesoscopic level through multiparticle collisions that conserve mass, momentum, and energy. The dependence of the two-particle relative friction tensors on the interparticle separation indicates the importance of hydrodynamic interactions for these nanoparticles.     

Towards two-dimensional electrophoresis mapping of the cerebrospinal fluid proteome from a single individual

We test the ability of state-of-the-art two-dimensional electrophoresis (2-DE) technology to enable the proteome mapping of ante mortem cerebrospinal fluid (CSF) from a single individual. Using the sensitive technologies of a fluorescent protein stain and fluorescence laser scanning of 2-DE gels, combined with matrix-assisted laser desorption/ionization-time of flight/time of flight-mass spectrometry (MALDI-TOF/TOF-MS) for protein identification, a highly detailed 2-DE map of the CSF proteome was created. The 2-DE map contains 600 identified spots representing 82 different proteins. Of the 82 proteins identified, 25 have not appeared in any previously published 2-DE map of CSF, and 11 have not been previously reported to exist in CSF. Most of the identifications originate from an ante mortem CSF sample collected from a single hydrocephalus patient. A supplemental map created from neurologically normal patients is also presented. A webpage with protein identification and scoring information from both maps is available at http://www.leelab.org/csfmap.