622Mbps ATM网络线路加密机设计构想

介绍了一种可以加密ATM网络的声音、数据、图像信息,其上限速率为622Mbps的ATM网络线路加密机设计构想,设计构想考虑了密钥管理功能的实现。     

无催化纳米氧化锌的制备及其光学性质研究

本文采用无催化剂直接蒸发高纯Zn粉,在800℃氧气氛条件下,在Si(111)衬底上生长得到以四角状为主的纳米ZnO(T-ZnO)。T-ZnO纳米线每个角约互成110°,长度约为1.5μm,直径100nm左右;Raman分析表明E2(H)普遍存在于各形态的ZnO;光致发光光谱表明,T-ZnO纳米线的光致发光除了与材料性质有关,还与杂质缺陷有关,蓝绿光带是ZnO的缺陷产生的。     

低压宽温高频铝电解电容器工作电解液

在传统的己二酸铵/乙二醇加水体系中,通过增加水的含量实现高电导率,同时在电解液中添加多种有机高分子物质形成复合添加剂,改善工作电解液的高温稳定性,使电容器上限工作温度扩展到105℃,形成高频宽温低阻抗工作电解液。     

在SQUID心磁测量中基于奇异值分解和自适应滤波的噪声消除法

采用矩阵奇异值分解(singular value decomposition, SVD)的方法，对高温射频超导量子干涉仪(HTc rf-SQUID)采集到的单通道心磁信号进行处理.证明了对于近似周期性的心磁信号，在无参考噪声的情况下矩阵奇异值分解的方法与自适应窄带陷波相结合有较好的消除广谱噪声的效果. 关键词： 高温射频超导量子干涉仪 心磁信号 奇异值分解 噪声消除     

0.351μm激光辐照Au盘靶吸收、散射规律的实验研究

在“星光Ⅱ”激光装置上，利用80只分立式探测器研究了约0.8ns，0.351μm激光辐照Au盘靶的吸收、散射．结果表明，强度约为5×10¹⁴W/cm²的激光以10°角入射，吸收可达90%以上；但是，以45°角入射，吸收仅为75%左右，散射高达25%．散射主要来自未被等离子体充分吸收的激光在弯曲临界面上的反射，同时伴随少量受激布里渊散射．吸收的理论计算与实验结果进行了比较，两者符合较好． 关键词：     

CSR外靶实验终端中子流测量的模拟

随着兰州重离子加速器冷却储存环(HIRFL-CSR)外靶实验终端中子墙的建立, 为实验测量高能中子提供了机遇. 为确定CSR外靶实验终端对中子流测量的可行性, 基于BUU理论模型分别对对称系统(Ni+Ni, Pb+Pb)和非对称系统(Pb+Ni)进行了模拟计算, 发现当系统能量达到几百MeV/u时, 中子流信号相当明显, 并与碰撞参数有明显的依赖关系. 模拟结果表明, 在前角20°的覆盖范围内, 可以较好地实现中子流测量所需要的反应平面确定及碰撞参数选择. 对双击事件及其对中子流的影响进行了简单的讨论.     

Bloch Oscillations of Two-Component Bose-Einstein Condensates in Optical Lattices

We study the Bloch oscillations of two-component Bose-Einstein condensates trapped in spin-dependent optical lattices. The influence of the intercomponent atom interaction on the system is discussed in detail Accelerated breakdown of the Bloch oscillations and revival phenomena are found respectively for the repulsive and attractive case. For both the cases, the system will finally be set in a quantum self-trapping state due to dynamical instability.     

In Situ Observation of Skeletal Shape Transition during BaB2O4 Crystal Growth in High-Temperature Solution

The transition from a fiat solid-liquid interface to a skeletal shape during BaB2O4 （BBO） single crystal growth in Li2B4O7 flux is observed in real time by an optical high-temperature in-situ observation system. The movement of crystal step is also investigated. The observation results demonstrate that the steps propagate along and parallel to the fiat interface when the crystal size is small. Nevertheless, they will ‘bend＇ close to the face centre if the crystal size becomes greater. Atomic force microscopy reveals that more deposition places near the face centre give rise to the bending of advancing steps and thus the formation of a vicinal interface structure. Measurements of step velocity show that the velocity keeps nearly constant at different moments for one specific step, whereas the step on a newly formed layer advanced faster than that on a previously formed one when the crystal size is larger than 210μm or so. Thus interracial morphological instability occurs and a skeletal interface is obtained.     

氢化非晶硅磷掺杂工艺条件的研究

本文对氧化非晶硅磷掺杂的工艺条件进行了研究，得出掺磷氢化非晶硅的电导率随衬底温度、气体流量、气体压力、射频功率、淀积时间的变化关系，为非晶硅的有效掺杂和器件研究提供了依据。