Current R & D activities at TRCRE in polymer processing by EB

The current status of the R & D activities is presented on electron beam processing of polymers being carried out at TRCRE. Topics included are sterilization of medical products, graft polymers for selective separation or absorbents and curing of liquid prepolymer-monomer systems.     

Kinetic and thermodynamic considerations of the bracketing method: Entropy-driven proton-transfer reactions in a Fourier transform mass spectrometer

Several reports of experimentally derived proton affinity values and gas-phase basicity values for amino acids and peptides have recently appeared in the literature. Here, we show that the thermodynamic quantity that is measured by the Fourier transform mass spectrometry proton transfer bracketing of amino acids and peptides is gas-phase basicity and not proton affinity. Both experimental and theoretical evidence supports this conclusion. The difference between the values determined by proton transfer bracketing measurements for lysine versus leucine is consistent with a difference in gas-phase basicity rather than proton affinity. The rate of proton transfer from protonated lysine to a series of reference compounds have been measured. Entropy-driven, endothermic proton transfer is found to occur at the collision rate. Recent ab initio and semi-empirical calculations of the proton affinity of lysine are found to agree with the value that is derived from bracketing studies when one assumes that gas-phase basicity is measured. While entropy-driven reactions have been observed previously in high-pressure mass spectrometers, this is the first evidence for such reactions at low pressure in a Fourier transform mass spectrometer.     

Jitter reduction through feedback for picosecond pulsed InGaAsPlasers

Following a comparison of picosecond-pulse generation techniques, feedback schemes are reported for the generation of picosecond pulse trains with improved jitter for both multicontact and conventional single-contact InGaAsP-InP lasers. Subpicosecond jitter is achieved for Q-switched laser sources using a novel optoelectronic feedback scheme. The use of resonant electrical feedback is shown to improve the timing jitter of gain-switched pulses by up to six times. Pulse-to-pulse timing jitter as low as 250 fs is demonstrated for a hybrid of optical and electrical feedback schemes. Limits for timing jitter in diode lasers are established for optoelectronic, electrical, and optical feedback schemes, and the key picosecond pulse generation schemes are compared in terms of timing jitter for the first time     

Silicon-substrate microelectrode arrays for parallel recording ofneural activity in peripheral and cranial nerves

A new process for the fabrication of regeneration microelectrode arrays for peripheral and cranial nerve applications is presented. This type of array is implanted between the severed ends of nerves, the axons of which regenerate through via holes in the silicon and are thereafter held fixed with respect to the microelectrodes. The process described is designed for compatibility with industry-standard CMOS or BiCMOS processes (it does not involve high-temperature process steps nor heavily-doped etch-stop layers), and provides a thin membrane for the via holes, surrounded by a thick silicon supporting rim. Many basic questions remain regarding the optimum via hole and microelectrode geometries in terms of both biological and electrical performance of the implants, and therefore passive versions were fabricated as tools for addressing these issues in on-going work. Versions of the devices were implanted in the rat peroneal nerve and in the frog auditory nerve. In both cases, regeneration was verified histologically and it was observed that the regenerated nerves had reorganized into microfascicles containing both myelinated and unmyelinated axons and corresponding to the grid pattern of the via holes. These microelectrode arrays were shown to allow the recording of action potential signals in both the peripheral and cranial nerve settings, from several microelectrodes in parallel     

Nonlinear dynamics of femtosecond optical solitary wave propagationat the zero dispersion point

A perturbed nonlinear Schrodinger equation, describing nonlinear pulse propagation of femtosecond duration in optical fibers at the zero dispersion point, is considered. This equation is reduced to an ordinary differential equation, which is treated by means of Hamiltonian dynamics techniques. Conditions for solitary wave formation, as well as the solutions themselves, namely, a bright soliton, a rarefaction soliton, and a pair of dark solitons, are derived analytically. The shifts of the solitary wave velocity, the angular frequency, and the wavenumber, as well as the peak power required to launch a bright soliton are also obtained. The connection among the point initial conditions of the pulse and the type of solitary wave that can be excited is finally presented     

Silicon bipolar chipset for SONET/SDH 10 Gb/s fiber-opticcommunication links

High-speed multiplexers, demultiplexers, frequency dividers, mixers, and amplifiers are key electronic components in high-speed fiber-optic communications systems such as SONET/SDH. In this paper, we present several important digital and analog integrated circuits (IC) which have been developed for use in SONET/SDH 10 Gb/s optical communication links. The circuits have been fabricated in MOSAIC 5E, an advanced silicon bipolar technology (f_T=26 GHz). The resulting chipset which amounts to a total of 10 IC's consists of multiplexers, demultiplexers, a regenerative frequency divider (2:1), a dual output limiting amplifier, and two different types of mixers for clock extraction. Specifically, the design and performance of these IC's and a hybrid clock recovery module are discussed. The high performance and potential low cost of this research chipset show that advanced silicon bipolar circuit technology can play an important role in future multigigabit fiber-optic communication systems     

Layout-synthesis techniques for yield enhancement

Several yield-enhancement techniques are proposed for the last two stages of VLSI design, i.e., topological/symbolic and physical layout synthesis. Our approach is based on modifications of the symbolic/physical layout to reduce the sensitivity of the design to random point defects without increasing the area, rather than fault tolerance techniques. A layout compaction algorithm is presented and the yield improvement results of some industrial layout examples are shown. This algorithm has been implemented in a commercial CAD framework. Some routing techniques for wire length and via minimization are presented, and the results of wire length reduction in benchmark routing examples are shown. We demonstrate through topological optimization for PLA-based designs that yield enhancement can be applied even at a higher level of design abstraction. Experimental results show that it is possible to achieve significant yield improvements without increasing the layout area by applying the proposed techniques during layout synthesis     

Number of small solutions of a homogeneous linear congruence

Translated from Matematicheskie Zametki, Vol. 50, No. 4, pp. 102–107, October, 1991.