QoS provisioning in cellular networks based on mobility prediction techniques

In cellular networks, QoS degradation or forced termination may occur when there are insufficient resources to accommodate handoff requests. One solution is to predict the trajectory of mobile terminals so as to perform resource reservations in advance. With the vision that future mobile devices are likely to be equipped with reasonably accurate positioning capability, we investigate how this new feature may be used for mobility predictions. We propose a mobility prediction technique that incorporates road topology information, and describe its use for dynamic resource reservation. Simulation results are presented to demonstrate the improvement in reservation efficiency compared with several other schemes.     

Origin of the threshold voltage instability in SiO/sub 2//HfO/sub 2/ dual layer gate dielectrics

The magnitude of the V/sub T/ instability in conventional MOSFETs and MOS capacitors with SiO/sub 2//HfO/sub 2/ dual-layer gate dielectrics is shown to depend strongly on the details of the measurement sequence used. By applying time-resolved measurements (capacitance-time traces and charge-pumping measurements), it is demonstrated that this behavior is caused by the fast charging and discharging of preexisting defects near the SiO/sub 2//HfO/sub 2/ interface and in the bulk of the HfO/sub 2/ layer. Based on these results, a simple defect model is proposed that can explain the complex behavior of the V/sub T/ instability in terms of structural defects as follows. 1) A defect band in the HfO/sub 2/ layer is located in energy above the Si conduction band edge. 2) The defect band shifts rapidly in energy with respect to the Fermi level in the Si substrate as the gate bias is varied. 3) The rapid energy shifts allows for efficient charging and discharging of the defects near the SiO/sub 2//HfO/sub 2/ interface by tunneling.     

Effect of exponentially graded base doping on the performance ofGaAs/AlGaAs heterojunction bipolar transistors

The authors have fabricated n-p-n GaAs/AlGaAs heterojunction bipolar transistors (HBTs) with base doping graded exponentially from 5×10¹⁹ cm^-3 at the emitter edge to 5×10¹⁸ cm^-3 at the collector edge. The built-in field due to the exponentially graded doping profile significantly reduces base transit time, despite bandgap narrowing associated with high base doping. Compared to devices with the same base thickness and uniform base doping of 1×10¹⁹ cm^-3 , the cutoff frequency is increased from 22 to 31 GHz and maximum frequency of oscillation is increased from 40 to 58 GHz. Exponentially graded base doping also results ill consistently higher common-emitter current gain than uniform base doping, even though the Gummel number is twice as high and the base resistance is reduced by 40%     

Rotative quadrature phase-shift keying

A rotative quadrature phase-shift keying (RQPSK) modulation scheme is proposed. By rotating the QPSK signal constellation by pi /2 either clockwise or anticlockwise during a symbol duration, the conventional QPSK scheme can be modified to transmit 3 bits per symbol to achieve both power and bandwidth efficiency.<>     

Synthesis and adsorption properties of gold nanoparticles within pores of surface‐functional porous polymer microspheres

Mesoporous polymer microspheres with gold (Au) nanoparticles inside their pores were prepared considering their surface functionality and porosity. The Au/polymer composite microspheres prepared were characterized by transmission electron microscope (TEM), X‐ray diffraction (XRD), and Brunauer–Emmett–Teller (BET) techniques. The results showed that the adsorption of Au nanoparticles could be increased by imparting the pore structure and surface‐functional groups into the supporting polymer microspheres (in this study, poly (ethylene glycol dimethacrylate‐co‐acrylonitrile) and poly (EGDMA‐co‐AN) system). Above all, from this study, it was established that the porosity of the polymer microspheres is the most important factor that determines the distribution and adsorption amount of face‐centered cubic (fcc) Au nanoparticles in the final products. Our study showed that the continuous adsorption of Au nanoparticles with the aid of the large surface area and surface interaction sites formed more favorably the Au/polymer composite microspheres. The BET measurements of Au/poly(EGDMA‐co‐AN) composite microspheres reveals that the adsorption of Au nanoparticles into the pores kept the pore structure intact and made it more porous. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 5627–5635, 2004     

Analysis on plasma chemistry and particle growth in corona discharge process for NO/sub x/ removal using discrete-sectional method

The particle formation and growth combined with plasma chemistry in the pulsed corona discharge process (PCDP) to remove NO/sub x/ were analyzed by the discrete-sectional model. In the PCDP, most of the NO is converted into NO/sub 2/ and, later, into HNO/sub 3/ which reacts with NH/sub 3/ to form the NH/sub 4/NO/sub 3/ particle. In the beginning of the reactor, we have the high concentration of small size particles and, later, the particle size distribution in the reactor becomes bimodal with the large size and small size particles and, finally, becomes monodisperse with the large size particles. As the average electron concentration increases, it takes a shorter reactor length to remove the NO/sub x/. As the initial NO and H/sub 2/O concentrations decrease, the NH/sub 3/ is consumed more slowly to form the ammonium nitrates particles. As the averaged electron concentration and initial H/sub 2/O concentration increase, the large size particles grow more quickly and the particle size distribution becomes bimodal earlier. As the initial NO and NH/sub 3/ concentrations increase, the diameter of large size particles becomes larger by the faster coagulation between particles. The predicted NO/sub x/ conversion and particle size distribution were in close agreements with the published experimental results at the averaged electron concentration of 2/spl times/10/sup 5/ cm/sup -3/ in this study.     

A high-capacity broadband packet switch architecture based on a multilink approach

Broadband packet networks based on asynchronous transfer mode (ATM) are expected to provide a wide range of services, including motion video, voice, data and image. When these networks become prevalent, some applications such as motion video and high-speed LAN interconnections will place a very large bit rate requirement on the channels. Currently, the physical layer supported by the synchronous optical network (SONET) allows the transmission of up to 2.4 Gbit/s with the OC-48 optical interface. However, it is not feasible for the electronic packet switch to route packets at this rate on a single link. In this paper we present a design of a broadband packet switch that uses multiple links in parallel to realize a high-speed channel. This implementation permits the switch to operate at the lower link rate, which can be at 150 Mbit/s, while having the ability to support a virtual circuit at a higher rate (up to 2.4 Gbit/s). The main contribution of the design is that packet sequence on a channel is still maintained even though packets are allowed to use any of the links belonging to the same channel. Besides allowing the switch to function at a slower rate than the transmission channel rate, the implementation of the multilinks benefits from statistical multiplexing gain. Analytical results show the performance advantages of multilink design with respect to delay, throughput and packet loss probability.     

The effect of olefinic terminal chains on the mesomorphic properties of 4,4'-disubstituted diphenyldiacetylenes

New diphenyldiacetylenes of the type with A, B = H and/or F; m = 0, 1; n = 1-4; and X = C n H 2n + 1 , F, CF 3 or CN were synthesized and their mesomorphic properties determined by hot stage polarizing microscopy and DSC. When m = 0, all of these compounds showed only a nematic phase except when X = CF 3 when both nematic and smectic A phases were seen. Both clearing and melting temperatures were higher than those reported for substitution with the corresponding alkyl chains but the much larger increase in clearing temperatures produced considerably wider nematic phases. Eutectic mixtures of a few of these olefins yielded nematic materials also having much wider temperature ranges and higher clearing temperatures than the eutectic mixtures of the alkyl compounds, while retaining their high birefringence and low viscosities. Such materials are of interest for beam-steering devices.

Four of the diacetylenes with m = 1 ( A, B = H) were also prepared ( X = C 6 H 13 , F, n = 2, 3). When X was C 6 H 13 ( n = 2), the nematic range was smaller in the 2- than in the 1-olefin but wider than in the alkyl series. When X = F, either no nematic phase or a monotropic one was observed, whereas the 1-olefins gave a much wider nematic phase. Both transition temperatures were lower than those for the corresponding 1-olefin and alkyl analogues. The compound with X = C 6 H 13 and n = 2 had a melting temperature below room temperature.     

89-GHz fT room-temperature silicon MOSFETs

The authors report the implementation of deep-submicrometer Si MOSFETs that at room temperature have a unity-current-gain cutoff frequency (f_T) of 89 GHz, for a drain-to-source bias of 1.5 V, a gate-to-source bias of 1 V, a gate oxide thickness of 40 Å, and a channel length of 0.15 μm. The fabrication procedure is mostly conventional, except for the e-beam defined gates. The speed performance is achieved through an intrinsic transit time of only 1.8 ps across the active device region     

Game theoretic analysis of the bargaining process over a long-term replenishment contract

This paper presents supplier–buyer models to describe the bargaining process between a supplier and a buyer over a long-term replenishment contract. Two different models are developed: one for the situation where the supplier has superior bargaining power over the buyer, and the other for the reverse situation. For each model, a method is derived that employs game theory-based analysis to determine the best strategy for each agent. A computational experiment is conducted to estimate the efficiency of the methods and to determine the economic implications of the results. The result indicates that each algorithm is very efficient compared to other strategies. We also verify that the solutions derived from each model are Nash equilibrium. Significantly improved outcomes are obtained for both agents by agreeing to the terms generated by the algorithms over the terms selected in the usual manner.