Enhancement mode InP MISFET's with sulfide passivation andphoto-CVD grown P3N5 gate insulators

High performance enhancement mode InP MISFET's have been successfully fabricated by using the sulfide passivation for lower interface states and with photo-CVD grown P₃N₅ film used as gate insulator. The MISFET's thus fabricated exhibited exhibited pinch-off behavior with essentially no hysteresis. Furthermore the device showed a superior stability of drain current. Specifically under the gate bias of 2 V for 10⁴ seconds the room temperature drain current was shown to reduce from the initial value merely by 2.9% at the drain voltage of 4 V. The effective electron mobility and extrinsic transconductance are found to be about 2300 cm ²/V·s and 2.7 mS/mm, respectively. The capacitance-voltage characteristics of the sulfide passivated InP MIS diodes show little hysteresis and the minimum density of interface trap states as low as 2.6×10¹⁴/cm² eV has been attained     

Simple ASK transmitter using a 790 nm self-pulsating laser diodefor local area networks

A simple amplitude shift keying (ASK) optical link is demonstrated by using a low-cost self-pulsating laser diode and an envelope detector for a low-cost broadband local area network. A link sensitivity of -22 dBm was achieved at 200 Mbit/s. Because the self-pulsation frequency can be tuned by the bias current, frequency division multiplexing can be simply implemented for multiuser applications     

A fully distributed power control algorithm for cellular mobilesystems

Several distributed power control algorithms that can achieve carrier-to-interference ratio (CIR) balancing with probability one have been proposed previously for cellular mobile systems. In these algorithms, only local information is used to adjust transmitting power. However, a normalization procedure is required in each iteration to determine transmitting power and, thus, these algorithms are not fully distributed. In this paper, we present a distributed power control algorithm which does not need the normalization procedure. We show that the proposed algorithm can achieve CIR balancing with probability one. Moreover, numerical results reveal our proposed scheme performs better than the algorithm presented in Grandhi et al. [1994]. The excellent performance and the fully distributed property make our proposed algorithm a good choice for cellular mobile systems     

Ultra-wideband (from DC to 110 GHz) CPW to CPS transition

A new ultra-wideband, low-loss and small-size coplanar waveguide (CPW) to coplanar strip (CPS) transition which can be used from DC to 110 GHz is presented. The proposed transition connects CPW with CPS by the reformed air-bridge. Two ground planes of CPW are tied at their ends by a line and the centre of the line is connected to the ground strip of CPS by another line. Owing to the symmetry of the proposed structure, the currents of two ground planes of CPW are combined with the same phase and transferred to the ground strip of CPS. With height of 3 μm, the signal line of CPW passes over two connecting lines and is connected to the signal strip of CPS. For the back-to-back transition structure, insertion loss <1 dB and return loss >15 dB are obtained from 0.5 to 110 GHz     

A fast motion estimation algorithm based on the block sum pyramid

In this correspondence, a fast approach to motion estimation is presented. The algorithm uses the block sum pyramid to eliminate unnecessary search positions. It first constructs the sum pyramid structure of a block. Successive elimination is then performed hierarchically from the top level to the bottom level of the pyramid. Many search positions can be skipped from being considered as the best motion vector and, thus, the search complexity can be reduced. The algorithm can achieve the same estimation accuracy as the full search block matching algorithm with much less computation time.     

Parallel BIST architecture for CAMs

A new parallel test algorithm and a built-in self test (BIST) architecture for efficient testing of various types of functional faults in content addressable memories (CAMs) are developed. The results show that efficient and practical testing with very low complexity and area overhead can be achieved     

Simple approximations of the DC flux influence on the core losspower electronic ferrites and their use in design of magnetic components

The effect of DC flux on the core loss is examined for the practical range of power and frequency. Relevant core loss equations are derived and applied to an optimization algorithm to determine the minimum core loss at a given ratio of s (DC flux density to AC peak flux density). It has been found that the curves of hysteresis loss density versus the ratio of s exhibit a peak at a critical ratio. Below or above this critical ratio, the loss density decreases drastically. On the other hand, the curves of eddy-current loss density versus the ratio of s exhibits a minimum point at a critical ratio. Below or above this critical ratio, the loss density increases gradually     

On detecting the presence of fetal R-wave using the moving averagedmagnitude difference algorithm

An efficient algorithm detecting the presence of a fetal QRS complex is presented. The proposed fetal QRS detection method computes the averaged magnitude of the difference between the fetal ECG signal and the reference signal to detect the fetal QRS event. The detected fetal QRS complexes are exponentially averaged to generate the template signal which can track the slowly varying shape of the fetal ECG signal. As an effort to obtain improved detection performances, two approaches of normalizing the fetal ECG signal and the template are considered.     

Control of circulating current in two parallel three-phase boost rectifiers

One unique feature in parallel three-phase converters is a potential zero-sequence circulating current. To avoid the circulating current, most present technology uses an isolation approach, such as transformers or separate power supplies. This paper proposes a parallel system where individual converters connect both AC and DC sides directly without additional passive components to reduce size and cost of the overall parallel system. In this case, the control of the circulating current becomes an important objective in the converter design. This paper: (1) develops an averaged model of the parallel converters based on a phase-leg averaging technique; (2) a zero-sequence model is then developed to predict the dynamics of the zero-sequence current; (3) based on the zero-sequence model, this paper introduces a new control variable, which is associated with space-vector modulation; (4) a strong zero-sequence current control loop is designed to suppress the circulating current; and (5) simulation and experimental results validate the developed model and the proposed control scheme.