Data retention characteristics of sub-100 nm NAND flash memory cells

In contrast to the conventional theories, we have revealed that the most distinguished mechanism in the data retention phenomenon after Fowler-Nordheim (FN) stress in sub-100 nm NAND Flash memory cells is the annihilation of interface states. Interface state generation rate increases rapidly as the channel width of NAND flash cell decreases. Comparison of interface states and stress-induced leakage current (SILC) component during retention mode shows that the annihilation of interface states strongly affects data retention characteristics of the programmed cells.     

Robust Space Time Receiver for CDMA-based Antenna Arrays

In this paper, we propose a new robust code division multiple access (CDMA) receiver of which weight vector is obtained by projecting the effective spatio-temporal signature waveform onto the signal subspace of the data covariance matrix. We verified our proposed algorithm by the field measured data obtained with a custom-built wideband CDMA test-bed. It will be shown that the proposed algorithm is robust to the signal mismatch.     

Longitudinal Wave Propagation in Dielectric Waveguide Array

Based on the established rigorous theory for two-dimensionally periodic (2DP) medium, Longitudinal propagation in Dielectric Waveguide Array (DWA) was analyzed in detail. Firstly, given longitudinal wave vector (k _z), Brillouin dispersion relations between transversal wave vectors were analyzed. Interactions between space harmonics were also studied. Secondly, on condition that transversal wave vector k _x equaled k _y, dispersion relations between longitudinal and transversal wave vectors were analyzed in detail. Because of interactions between space harmonics increasingly getting stronger with k _z or modulation coefficients increasing, stop-bands could be distinctly displayed and thus longitudinal propagation in DWA could be comprehensively analyzed. The applications about longitudinal propagation in DWA were also discussed.     

Presenting information on the small-screen interface: effects of table formatting

This study explored strengths and limitations of table formatting choices by engaging twenty-eight participants in information searches in online tables, presented on a small-screen interface (Palm IIIc). Table length across conditions was held constant at three screens long (24 rows total) but varied from one to three screens wide (approximately 35, 70, and 105 characters per line). Target information was positioned in either the upper left, lower left, upper right, or lower right quadrants. Data collected were time on task, error rate, and level of participants' confidence in their answers. Experimenters found that increased horizontal scrolling imposed the heaviest burden on information search. This study supports restricting table widths to one screen on handheld computers. If necessary, however, tables can go to two screens wide without critical detriment to usability. While ruled line formatting is slightly better than interface character in providing visual support for the burden of horizontal scrolling, neither formatting option adequately compensates for the added burden.     

Training ratio and comparison of trained vector quantizers

The vector quantizer (VQ) codebook is usually designed by clustering a training sequence (TS) drawn from the underlying distribution function. In order to cluster a TS, we may use the K-means algorithm (generalized Lloyd (1982) algorithm) or the self-organizing map algorithm. In this paper, a survey of trained VQ performance is conducted to study the effect of the training ratio on training quantizers. The training ratio, which is defined by the ratio of the TS size to the codebook size, is dependent on the VQ structure. Hence, different VQs may show different training properties, even though the VQs are designed for the same TS. A numerical comparison of trained VQs is then conducted in conjunction with deriving their training ratios. Through the comparison, it is shown that structured VQs can achieve better performance than the full-search scheme if the codebooks are trained by a finite TS. Further, we can derive a design or comparison guideline that maintains equal training ratios in training different VQs.     

QoS provisioning in cellular networks based on mobility prediction techniques

In cellular networks, QoS degradation or forced termination may occur when there are insufficient resources to accommodate handoff requests. One solution is to predict the trajectory of mobile terminals so as to perform resource reservations in advance. With the vision that future mobile devices are likely to be equipped with reasonably accurate positioning capability, we investigate how this new feature may be used for mobility predictions. We propose a mobility prediction technique that incorporates road topology information, and describe its use for dynamic resource reservation. Simulation results are presented to demonstrate the improvement in reservation efficiency compared with several other schemes.     

Origin of the threshold voltage instability in SiO/sub 2//HfO/sub 2/ dual layer gate dielectrics

The magnitude of the V/sub T/ instability in conventional MOSFETs and MOS capacitors with SiO/sub 2//HfO/sub 2/ dual-layer gate dielectrics is shown to depend strongly on the details of the measurement sequence used. By applying time-resolved measurements (capacitance-time traces and charge-pumping measurements), it is demonstrated that this behavior is caused by the fast charging and discharging of preexisting defects near the SiO/sub 2//HfO/sub 2/ interface and in the bulk of the HfO/sub 2/ layer. Based on these results, a simple defect model is proposed that can explain the complex behavior of the V/sub T/ instability in terms of structural defects as follows. 1) A defect band in the HfO/sub 2/ layer is located in energy above the Si conduction band edge. 2) The defect band shifts rapidly in energy with respect to the Fermi level in the Si substrate as the gate bias is varied. 3) The rapid energy shifts allows for efficient charging and discharging of the defects near the SiO/sub 2//HfO/sub 2/ interface by tunneling.     

Effect of exponentially graded base doping on the performance ofGaAs/AlGaAs heterojunction bipolar transistors

The authors have fabricated n-p-n GaAs/AlGaAs heterojunction bipolar transistors (HBTs) with base doping graded exponentially from 5×10¹⁹ cm^-3 at the emitter edge to 5×10¹⁸ cm^-3 at the collector edge. The built-in field due to the exponentially graded doping profile significantly reduces base transit time, despite bandgap narrowing associated with high base doping. Compared to devices with the same base thickness and uniform base doping of 1×10¹⁹ cm^-3 , the cutoff frequency is increased from 22 to 31 GHz and maximum frequency of oscillation is increased from 40 to 58 GHz. Exponentially graded base doping also results ill consistently higher common-emitter current gain than uniform base doping, even though the Gummel number is twice as high and the base resistance is reduced by 40%     

Rotative quadrature phase-shift keying

A rotative quadrature phase-shift keying (RQPSK) modulation scheme is proposed. By rotating the QPSK signal constellation by pi /2 either clockwise or anticlockwise during a symbol duration, the conventional QPSK scheme can be modified to transmit 3 bits per symbol to achieve both power and bandwidth efficiency.<>     

Synthesis and adsorption properties of gold nanoparticles within pores of surface‐functional porous polymer microspheres

Mesoporous polymer microspheres with gold (Au) nanoparticles inside their pores were prepared considering their surface functionality and porosity. The Au/polymer composite microspheres prepared were characterized by transmission electron microscope (TEM), X‐ray diffraction (XRD), and Brunauer–Emmett–Teller (BET) techniques. The results showed that the adsorption of Au nanoparticles could be increased by imparting the pore structure and surface‐functional groups into the supporting polymer microspheres (in this study, poly (ethylene glycol dimethacrylate‐co‐acrylonitrile) and poly (EGDMA‐co‐AN) system). Above all, from this study, it was established that the porosity of the polymer microspheres is the most important factor that determines the distribution and adsorption amount of face‐centered cubic (fcc) Au nanoparticles in the final products. Our study showed that the continuous adsorption of Au nanoparticles with the aid of the large surface area and surface interaction sites formed more favorably the Au/polymer composite microspheres. The BET measurements of Au/poly(EGDMA‐co‐AN) composite microspheres reveals that the adsorption of Au nanoparticles into the pores kept the pore structure intact and made it more porous. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 5627–5635, 2004