激光对光学薄膜损伤的热冲击效应

计算了薄膜在高功率脉冲激光作用下截面温度场和应力场分布。分析了热冲击在光学薄膜激光损伤中的作用，并用调Ｑ１．０６μｍ脉冲激光对ＺｒＯ２单层膜损伤，讨论了不同激光强度下薄膜截面温度场与应力场分布，揭示了热冲击在ＺｒＯ２单层膜损伤中的机理和过程。     

五羟色胺分子选择性电极研究

本应用自己合成的联萘２０－冠－６作为活性载体，进行了五羟色胺分子选择性电极研究。电极在１０＾－＾５－１０＾－＾２ｍｏｌ／Ｌ浓度范围内对五羟色胺具有稳定的线性响应，平均斜率为６３ｍＶ／ＰＣ，检测下限为２．７×１０＾－＾６ｍｏｌ／Ｌ。     

Topology design and bridge-capacity assignment for interconnecting token ring LANs: A simulated annealing approach

We address the problem of determining the topology and bridge-capacity assignments for a network connecting a number of token rings via source-routing bridges. The objective is to minimize the cost of bridge installations while meeting the network users' performance requirements. The problem is modeled as a mixed 0–1 integer program. A comparison is given between two solution algorithms: a simulated annealing algorithm using the flow-deviation algorithm for each routing subproblem, and a drop algorithm using the simplex method for the same subproblems to provide benchmark solutions. In the former algorithm, the routing subproblem is formulated as a nonlinear program with penalty functions to model node and link capacity constraints, and in the latter as a multicommodity flow model with the same capacity constraints. Computational results show that the simulated-annealing/flow-deviation algorithm produced substantially better solutions than the LP-based drop algorithm.     

Effect of epitaxial realignment on the leakage behavior of arsenic-implanted,as-deposited polycrystalline Si-on-single crystal Si diodes

When dopants are indiffused from a heavily implanted polycrystalline silicon film deposited on a silicon substrate, high thermal budget annealing can cause the interfacial “native” oxide at the polycrystalline silicon-single crystal silicon interface to break up into oxide clusters, causing epitaxial realignment of the polycrystalline silicon layer with respect to the silicon substrate. Anomalous transient enhanced diffusion occurs during epitaxial realignment and this has adverse effects on the leakage characteristics of the shallow junctions formed in the silicon substrate using this technique. The degradation in the leakage current is mainly due to increased generation-recombination in the depletion region because of defect injection from the interface.     

Part II: An example of the use of the comsis software: simulation of an optical network which uses wavelength multiplexing,fsk modulation format and direct detection

This second article deals with using the Comsis software for a particular application. Simulation is used to determine the maximum channel density in presence of crosstalk. In a first part, the modelling of the system is described. The simulation parameters of different optical elements are given. The results show that in the case of channels modulated at 500 Mbitls using fsk modulation format, and a direct detection operation at 1,5 μm, a minimum spacing of 6 GHz can be obtained with a 2 dB penalty. Thus if only the bandwidth of the erbium doped fibre amplifier is taken into account, the maximum number of channels which can be used is 250. However if the fsr (free spectral range) of optical filter is taken into account, the maximun number of channels is limited to 30.     

Reduction of loading effect by tungsten etchback in a magneticallyenhanced reactive ion etcher

The plug loading effect occurring during the etchback of tungsten was investigated in a magnetically enhanced reactive ion etcher using SF ₆/Ar mixtures. It was found that while the plug loading effect is independent of varying SF₆/Ar flow rate ratio and magnetic field intensity, it is reduced under the condition of high selectivity of tungsten relative to TiN which was achieved at high chamber pressure and low RF power. It is proposed that when TiN is used as a glue layer, the W etch rate enhancement in the plug is mainly controlled by a local loading effect. Under the optimized etchback conditions the plug loss was successfully controlled without the tungsten residue left on severe topology     

Mode analysis of DFB SE lasers

This paper presents theoretical results on mode characteristics of surface-emitting (SE) lasers utilizing an active second-order grating section. Based on a coupled-mode approach, longitudinal modes and the associated space-harmonic transverse modes are calculated via a numerical technique. From these, the lasing-mode spectrum, near- and far-field patterns of the radiation mode, and the surface-emission power efficiency are obtained. Effects of the substrate reflector and the grating parameters are also investigated. Finally, comparisons are made with conventional, edge-emitting DFB lasers. The results indicate that with a suitable choice of structural parameter values, DFB SE lasers can be made to possess both the spectral discrimination of the conventional DFB lasers and the advantages of SE lasers at the same time and also that the second lowest longitudinal mode may be preferred over the fundamental longitudinal mode for many applications due to its symmetric field distribution     

Still image coding based on vector quantization and fractalapproximation

In this paper, we propose a coding algorithm for still images using vector quantization (VQ) and fractal approximation, in which low-frequency components of an input image are approximated by VQ, and its residual is coded by fractal mapping. The conventional fractal coding algorithms indirectly used the gray patterns of an original image with contraction mapping, whereas the proposed fractal coding method employs an approximated and then decimated image as a domain pool and uses its gray patterns. Thus, the proposed algorithm utilizes fractal approximation without the constraint of contraction mapping. For approximation of an original image, we employ the discrete cosine transform (DCT) rather than conventional polynomial-based transforms. In addition, for variable blocksize segmentation, we use the fractal dimension of a block that represents the roughness of the gray surface of a region. Computer simulations with several test images show that the proposed method shows better performance than the conventional fractal coding methods for encoding still pictures.     

字节全加器及其在无线电测控系统中的应用

对全加器概念进行了推广，并在此基础上给出了使用字节全加器网络的无线电抗干扰算法。通过在实际的无线电测控系统中的应用，结果表明该算法具有良好的无线电抗干扰效果。     

On detecting the presence of fetal R-wave using the moving averagedmagnitude difference algorithm

An efficient algorithm detecting the presence of a fetal QRS complex is presented. The proposed fetal QRS detection method computes the averaged magnitude of the difference between the fetal ECG signal and the reference signal to detect the fetal QRS event. The detected fetal QRS complexes are exponentially averaged to generate the template signal which can track the slowly varying shape of the fetal ECG signal. As an effort to obtain improved detection performances, two approaches of normalizing the fetal ECG signal and the template are considered.