A universal matrix solver for integral-equation-based problems

A new method has been developed for compressing the matrices that occur in most integral-equation-based computer programs. This method is easy to interface with existing computer programs, and allows them to run significantly faster and with significantly less memory. This method applies not only to electromagnetic and acoustic computation, but also to most programs involving a Green's function or any integral equation with a kernel having some smoothness properties. Our numerical computations, running on a high-end personal computer, have achieved compression ratios of fifty times, and compressed inversion of the matrices fifty times faster than by previous methods. For larger problems, solved on high-performance computers, these ratios would improve to about one thousand to one for larger moment method problems.     

Towards intelligent dressing

The aim of this article is to state the principles of an intelligent monitoring and control system for the grinding machine, comprising the dressing process as well as grinding stability.     

一种用于三电平逆变器的SVPWM调制方法研究

本文从二极管箝位型三电平逆变器的基本结构出发，分析其输出状态，推导出六角形空间电压矢量图。然后从一种改进的，可以减小开关损耗，避免高的dv／dt三电平空间矢量PWM调制策略出发，建立了基于Matlab的详细仿真方案，验证了方案的可行性。文章给出了扇区判断的算法流程图，脉冲生成模块的内部结构图，其中的扇区判断的算法和脉冲生成方法对于用DSP实现三电平SVPWM具有重要的参考价值。     

基于公用无线网的短信息分发系统设计与实现

介绍了以GSM系统为平台的数据信息分发系统的设计与实现,并基于TC35模块,完成了计算机管理系统与GSM网络的互连,实现了对信息的分发、确认功能。     

双掺(Tm3+,Tb3+)LiYF4激光器1.5 μm波长激光阈值分析

由速率方程推出了双掺（Tm^3 ,Tb^3 ）离子准四能级系统的激光阈值解析式，讨论了Tm^3 和Tb^3 离子之间的相互作用。分析了1.5μm波长附近的激光阈值和Tm^3 、Tb^3 离子的掺杂原子数分数及晶体长度的关系。结果表明，对于对应Tm^3 离子^3H4→^3F4跃迁的约1.5μm波长的激光，激活离子Tm^3 的掺杂原子数分数过大时，交叉弛豫作用将使系统阈值迅速增加。Tb^3 离子的加入，一方面能抽空激光下能级，起到降低阈值的作用；另一方面亦减少了激光上能级的寿命，使阈值升高。故Tb^3 离子有最佳掺杂原子数分数。对于Tm原子数分数为y=0.01的Tm:LiYF4晶体，Tb^3 离子的最佳掺杂原子数分数为0.002左右，同时表明，激光阈值与晶体长度有关。最佳晶体长度与Tm^3 、Tb^3 离子的掺杂原子数分数以及晶体的衍射损耗和吸收损耗有关。     

激光抛光技术的发展与展望

介绍激光抛光技术的发展历史,阐明激光抛光的应用现状及未来的发展前景,论述了激光抛光的工艺特点和作用机理,将激光抛光技术与其它抛光技术进行了全面的对比,指出激光抛光的优势及其存在的问题。     

YBa2Cu1-xCox(Cu1-yZny)2Oz体系的Co,Zn共同掺杂效应

本文报道通过对YBa₂Cu_1-xCo_x(Cu_1-yZn_y)₂O_z(0≤x,y≤0.1)体系晶体结构、氧含量、正常态电阻-温度关系、Hall效应以及超导临界温度等的综合测量,发现随着Co和Zn含量的增加,体系经历了从正交结构的超导金属向四方结构的非超导半导体的转变,超导临界温度T_c和载流子浓度n_h均迅速下降,Co 关键词：     

Densification involved in the UV-based photosensitivity of silicaglasses and optical fibers

A comprehensive survey of photosensitivity in silica glasses and optical fiber is reviewed. Recent work on understanding the mechanisms contributing to germanium or aluminum doped fiber photosensitivity is discussed within the framework of photoelastic densification models     

α,α′-二氧代烯酮环二氮代缩醛的NMR研究

报道了5种新的α，α′-二氧代烯酮环二氮代缩醛化合物的NMR谱，初步探讨了分子结构对化学位移的影响．     

On the reliability of Landsat TM for estimating forest variables byregression techniques: a methodological analysis

In order to build models that relate thematic mapper (TM) imagery to field forest variables, several regression techniques, such as the ones based on the Mallows' C_p and the adjusted R² statistics, were applied. Nevertheless, although the best created models had good fittings (R²>0.65) apparently supported by a clear statistical significance (p<0.0001), later trials tested with additional plots showed that these models were, in fact, nonrobust models (models with very low-predictive capabilities). Two factors were pointed out as causes of these inconsistencies between predicted and observed values: a relatively small number of available field plots and a relatively high number of possible independent variables. Actually, different trials suggested much lower fittings for the expected “really” predictive models. Some restrictions of TM satellite data, such as its radiometric, spectral, and spatial limitations, together with restrictions arising from gathering and processing of field data, might have led to these poor relations. This study shows the need for guarantees stronger than the usual ones before concluding that there is a clear possibility of using satellite information to estimate forest parameters by means of regression techniques