Apparent Molar Volume, Heat Capacity, and Conductance of Lithium Bis(trifluoromethylsulfone)imide in Glymes and Other Aprotic Solvents

Lithium bis(trifluoromethylsulfone)imide (LiTFSI) is a promising electrolyte for high-energy lithium batteries due to its high solubility in most solvents and electrochemical stability. To characterize this electrolyte in solution, its conductance and apparent molar volume and heat capacity were measured over a wide range of concentration in glymes, tetraethylsulfamide (TESA), acetonitrile, -butyrolactone, and propylene carbonate at 25°C and were compared with those of LiClO₄ in the same solvents. The glymes or n(ethylene glycol) dimethyl ethers (nEGDME), which have the chemical structure CH₃–O–(CH₂–CH₂–O) _n –CH₃ for n = 1 to 4, are particularly interesting since they are electrochemically stable, have a good redox window, and are analogs of the polyethylene oxides used in polymer-electrolyte batteries. TESA is a good plasticizer for polymer-electrolyte batteries. Whenever required, the following properties of the pure solvents were measured: compressibilities, expansibilities, temperature and pressure dependences of the dielectric constant, acceptor number, and donor number. These data were used in particular to calculate the limiting Debye-Hückel parameters for volumes and heat capacities. The infinite dilution properties of LiTFSI are quite similar to those of other lithium salts. At low concentrations, LiTFSI is strongly associated in the glymes and moderately associated in TESA. At intermediate concentrations, the thermodynamic data suggests that a stable solvate of LiTFSI in EGDME exists in the solution state. At high concentrations, the thermodynamic properties of the two lithium salts approach those of the molten salts. These salts have a reasonably high specific conductivity in most of the solvents. This suggests that the conductance of ions at high concentration in solvents of low dielectric constant is due to a charge transfer process rather than to the migration of free ions.     

Correlation of the volumes and heat capacities of solutions with their solid-liquid phase diagrams

Liquid systems which have strong non-idealities, as seen from their thermodynamic properties, often show evidence of these interactions in the solid-liquid phase diagrams. This suggests that some of the structures present in the solid state can persist in the solution state, on a time average, up to temperatures much higher than the melting point. Volumes and heat capacities of typical systems were either taken from the literature or measured to illustrate this correlation with the phase diagrams. With mixtures of aprotic solvents which show nearly-ideal simple eutectic phase diagrams, the properties of the solutions are also nearly ideal. Examples of systems investigated which show strong non-idealities are ionic surfactant solutions, alcohol-water mixtures, chloroform-triethylamine mixtures and lithium salts in aprotic solvents.Paper written in the honor of Loren Hepler on the occasion of his retirement.     

Complex forming and extraction properties of oligo benzo-fused crown ethers

The complex forming properties with alkali metal and ammonium ions of a series of oligo benzo-condensed 18-crown-6 ethers1–8 having a different gradation of lipophilicity and of molecular rigidity are investigated by voltammetry at the interface of two immiscible electrolyte solutions (ITIES) and by a liquid-liquid extraction technique. The experimental results obtained in the two phase system H₂O/nitrobenzene are discussed in relation to the structure of the crown and the cation type. The stability constants for the 1 : 1 complexes of Na⁺, K⁺, Rb⁺, Cs⁺ and NH ₄ ⁺ in nitrobenzene have been determined and compared with the extraction constants for the 1: 1 complexes of Na⁺ and K⁺ and for the 1 : 1 and 1 : 2 complexes of Cs⁺, showing the effect of oligo benzo condensation for the 18-crown-6 system.     

Zusammenhang zwischen Struktur und Komplexbildungseigenschaften der C1–C6-Xanthogenate mit Hg(II)-, Cd(II)- und Zn(II)-Ionen

The thermodynamic parameters D[`(H)], D[`(G)], D[`(S)]₂₉₈\Delta \bar H, \Delta \bar G, \Delta \bar S_{298} and lg _n resp. of the reactions indicated in the title have been computed from polarographic data. The numerical values obtained are nearly independent from the xanthate used. The overall formation constants increase as follows: Zn(II)<>相似文献   

Impact of the computational method on the geometric and electronic properties of oligo(phenylene vinylene) radical cations

We report on a quantum-chemical study of the electronic and optical properties of unsubstituted oligo(phenylene vinylene) (OPV) radical cations. Our goal is to distinguish the impact of the choice of molecular geometry from the impact of the choice of quantum-chemical method, on the calculated optical transition energies. The geometry modifications upon ionization of the OPV chains are found to depend critically on the theoretical formalism: Hartree-Fock (HF) geometry optimizations lead to self-localization of the charged defects while pure density functional theory (DFT) results in a complete delocalization of the geometric modifications over the whole conjugated backbone. The electronic structure and vertical transition energy associated with the lowest excited state of the radical cations have been calculated at the post-Hartree-Fock level within a configuration interaction (HF-CI) scheme and using the time-dependent DFT (TD-DFT) formalism for different radical cation geometries. Interestingly, the changes in the calculated optical properties obtained when using different geometric structures are less important within a given method than the differences between methods for a given structure. The optical excitation is localized with HF-CI and delocalized with TD-DFT, almost irrespective of the molecular geometry; as a result, HF-CI excitation energies tend to saturate as the chain length increases, in contrast to the results from TD-DFT.     

Mixed-metal sandwich complexes [M(II)2(H2O)2Fe(III)2(P2W15O56)2]14- (M(II) = Co, Mn): synthesis and stability. The molecular structure of [M(II)2(H2O)2Fe(III)2(P2W15O56)2]14-

Two new mixed-metal sandwich complexes [M(II)2(H2O)2Fe(III)2(P2W15O56)2]14- (abbreviated [M2Fe2P4W30], M(II) = Co(II), Mn(II)) were obtained at pH 3 by addition of M2+ to [Na2(H2O)2Fe(III)2(P2W15O56)2]16- (abbreviated [Na2Fe2P4W30]) without substitution in the alpha-[P2W15O56]12- (abbreviated [P2W15]) units. Their X-ray structures are reported. At lower pH, back conversion to [Na2Fe2P4W30] was followed by 31P NMR, electrochemistry and UV-visible spectroscopy. The preparation and the characterization in solution of the lacunary intermediate [NaCo(II)(H2O)2Fe(III)2(P2W15O56)2]15- (abbreviated [NaCoFe2P4W30]) is also described.     

Unexpected cross-coupling reaction between o-chloroaryl ketones and organomanganese reagents

Alkyl- and arylmanganese reagents react with o-chloro or o-bromoaryl ketones to give the substituted ketones in high yields. The cross-coupling reaction is performed under mild conditions (-60 to +40 degrees C, 30 min to 4 h) and takes place with excellent chemoselectivity. [reaction: see text]     

Sublimation enthalpy of dye molecules measured using fluorescence

We present an in-flight fluorescence detection scheme for molecular beams which is applied to determine the enthalpy of sublimation of dye molecules. We investigate tetraphenylporphyrin (TPP), porphine, and nile red, which are believed to be suitable candidates for molecular de Broglie wave interferometry. The measured values are H(sub)(TPP)=142+/-3 kJ/mol, H(sub)(porphine)=87+/-3 kJ/mol, and H(sub)(nile red)=66+/-2 kJ/mol. For TPP, sublimation enthalpies differ in the literature by more than a factor of 2. Our measurements confirm a value at the lower end of this scale. We discuss changes in the character of the molecular flow with the source temperature as a prime reason for discrepancies in the published data.     

Tetranuclear [Rh4(mu-PyS2)2(diolefin)4] complexes as building blocks for new inorganic architectures: synthesis of coordination polymers and heteropolynuclear complexes with electrophilic d8 and d10 metal fragments

The reaction of [Rh4(mu-PyS2)2(cod)4] (PyS2 = 2,6-pyridinedithiolate, cod = 1,5-cyclooctadiene) with CF3SO3Me gave the cationic complex [Rh(4)(mu-PyS(2)Me)(2)(cod)4][CF3SO3]2 (1) with two 6-(thiomethyl)pyridine-2-thiolate bridging ligands from the attack of Me+ at the terminal sulfur atoms of the starting material. Under identical conditions [Rh4(mu-PyS2)2(tfbb)4] (tfbb = tetrafluorobenzobarrelene) reacted with CF3SO3Me to give the mixed-ligand complex [Rh(4)(mu-PyS2)(mu-PyS2Me)(tfbb)4][CF3SO3] 2. The nucleophilicity of the bridging ligands in the complexes [Rh4(mu-PyS2)2(diolefin)4] was exploited to prepare heteropolynuclear species. Reactions with [Au(PPh3)(Me2CO)][ClO4] gave the hexanuclear complexes [(PPh3)2Au2Rh4(mu-PyS2)2(diolefin)4][ClO4]2 (diolefin = cod (3), tfbb (4)). The structure of 4, solved by X-ray diffraction methods, showed the coordination of the [Au(PPh3)]+ fragments to the peripheral sulfur atoms in [Rh4(mu-PyS2)2(diolefin)4] along with their interaction with the neighbor rhodium atoms. Neutral coordination polymers of formula [ClMRh4(mu-PyS2)2(diolefin)4]n (M = Cu (5, 6), Au (7)) result from the self-assembly of alternating [Rh4(mu-PyS2)2(diolefin)4] ([Rh4]) blocks and MCl linkers. The formation of the infinite polymetallic chains was found to be chiroselective for M = Cu; one particular chain contains exclusively homochiral [Rh4] complexes. Cationic heterometallic coordination polymers of formula [MRh4(mu-PyS2)2(diolefin)4]n[BF4]n (M = Ag (8, 9), Cu (10, 11)) and [Rh5(mu-PyS2)2(diolefin)5]n[BF4]n (12, 13) result from the reactions of [Rh4] with [Cu(CH2CN)4]BF4, AgBF4, and [Rh(diolefin)(Me2CO)2]BF4, respectively. The heterometallic coordination polymers exhibit a weak electric conductivity in the solid state in the range (1.2-2.8) x 10(-7) S cm(-1).     

"Lego" chemistry for the straightforward synthesis of dendrimers

A new straightforward method of synthesis of dendrimers, using two branched monomers (CA(2) and DB(2)), is described. Each generation is obtained in a single quantitative step, with only N(2) or H(2)O as byproducts; generation 4 is obtained in only four steps. The end groups are alternatively phosphines and hydrazines; their versatile reactivity is illustrated by the reaction of generation 4 with a branched CD(5) monomer, which increases the number of end groups in a single step from 48 to 250.