Josephson current versus potential strength of the interface in ferromagnetic superconductors

Based on the scattering theory, we calculate the Josephson current in a junction between two ferromagnetic superconductors as a function of the interface potential z. We consider the ferromagnetic superconductor(FS) in three different Cooper pairing states: spin singlet s-wave pairing(SWP) state, spin triplet opposite spin pairing(OSP) state, and spin triplet equal spin pairing(ESP) state. We find that the critical Josephson current as a function of z shows clear differences among the SWP, OSP, and ESP states. The obtained results can be used as a useful tool for determining the pair symmetry of the ferromagnetic superconductors.     

Adsorption isotherms and ideal selectivities of hydrogen sulfide and carbon dioxide over methane for the Si-CHA zeolite: comparison of carbon dioxide and methane adsorption with the all-silica DD3R zeolite

Adsorption isotherms of H₂S, CO₂, and CH₄ on the Si-CHA zeolite were measured over pressure range of 0–190 kPa and temperatures of 298, 323, and 348 K. Acid gases adsorption isotherms on this type of zeolite are reported for the first time. The isotherms follow a typical Type-I shape according to the Brunauer classification. Both Langmuir and Toth isotherms describe well the adsorption isotherms of methane and acid gases over the experimental conditions tested. At room temperature and pressure of 100 kPa, the amount of CO₂ adsorption for Si-CHA zeolite is 29 % greater than that reported elsewhere (van den Bergh et al. J Mem Sci 316:35–45 (2008); Surf Sci Catal 170:1021–1027 (2007)) for the pure silica DD3R zeolite while the amounts of CH₄ adsorption are reasonably the same. Si-CHA zeolite showed high ideal selectivities for acid gases over methane at 100 kPa (6.15 for H₂S and 4.06 for CO₂ at 298 K). Furthermore, H₂S adsorption mechanism was found to be physical, and hence, Si-CHA can be utilized in pressure swing adsorption processes. Due to higher amount of carbon dioxide adsorbed and lower heats of adsorption as well as three dimensional channels of Si-CHA pore structure, this zeolite can remove acid gases from methane in a kinetic based process such as zeolite membrane.     

Thermal and morphological characteristics of solution blended epoxy/NBR compound

Systematic study about the effect of acrylonitrile–butadiene rubber (NBR) concentration on the fracture toughness and thermal behavior of epoxy resin is conducted in this study. NBR is solved in an aromatic hydrocarbon solvent and is added to epoxy resin. We used diethylene-teriamin as the curing agent for epoxy resin. Tensile test results, performed followed by molding procedure, show that the toughness is improved owing to the increase of rubber content. Scanning electron microscopy (SEM) and atomic force microscopy besides thermogravimetric analysis (TG) are used to investigate the epoxy/rubber interface and chemical decomposition of the resultant mixture. The thermal behavior of cured epoxy resin was analyzed via TG instrument at different heating rates. Thermogravimetry curves showed that the thermal decomposition of epoxy system was occurred in only one stage regardless of the rubber content. The apparent activation energies of the rubber/epoxy systems containing 0, 5, and 10 phr of rubber were determined by Flynn–Wall–Ozawa, Kissinger–Akahira–Sunose, and Friedman methods. The results prove that the thermal stability of epoxy resin was decreased with enhancing the rubber content. However, the trend of changing activation energy versus conversions is totally different followed by adding the elastomer to the system compared to neat epoxy resin. Moreover, the results obtained via our proposed facile solution blending method are compared to those of resins modified with nano-powdered elastomer.     

Experimental and Modelling Study of Gravity Drainage in a Three-Block System

Transport in Porous Media - Gravity drainage is known as the controlling mechanism of oil recovery in naturally fractured reservoirs. The efficiency of this mechanism is controlled by...     

Unidirectional invisibility induced by PT-symmetric periodic structures

Parity-time (PT) symmetric periodic structures, near the spontaneous PT-symmetry breaking point, can act as unidirectional invisible media. In this regime, the reflection from one end is diminished while it is enhanced from the other. Furthermore, the transmission coefficient and phase are indistinguishable from those expected in the absence of a grating. The phenomenon is robust even in the presence of Kerr nonlinearities, and it can also effectively suppress optical bistabilities.     

Fabrication of integrated waveguide grating in azo polymers

In this Letter, we have introduced a technique, new to our knowledge, to fabricate gratings on a waveguide of azo-functionalized polymeric films using a slit mask and a fast, direct-writing method. To prevent the destruction of the waveguide by the grating formation on the waveguide, we placed a slit mask on the waveguide. By properly adjusting the resonance, this grating can be used as an integrated wavelength filter. We have produced an attenuation of 13.4?dB at 1562?nm with a FWHM of 3.45?nm. The grating has been fabricated as narrow as the width of the waveguide to couple filtered light into the waveguide by using a slit mask. Any light shifted from the resonance will pass through the waveguide undisturbed.     

Sustainable and green microextraction of organophosphorus flame retardants by a novel phosphonium‐based deep eutectic solvent

Based on the solidification of a hydrophobic deep eutectic solvent in air‐assisted liquid phase microextraction combined with gas chromatography and mass spectrometry, a green and sustainable microextraction technique was developed for extracting, separating, and detecting organophosphorus flame retardants in aqueous samples. In this study, some strategies were considered for overcoming or improving the challenges of conventional solvent microextraction procedures. In addition, a hydrophobic deep eutectic solvent with a freezing point near the ambient temperature was employed as an extraction phase, the dispersive solvent was substituted by the syringe pump process, and the centrifugation step was omitted by using salting‐out phenomenon. Further, the effect of the main independent variables was evaluated by using the chemometric methods in order to maximize the extraction efficiency of the procedure. Under optimal conditions, the calibration model was linear in the range of 0.01–25.0 µg/L. Limits of detection and quantitation were assessed at the concentration levels of 2–23 and 9–65 ng/L, respectively. The precision involving repeatability and reproducibility was evaluated by estimating the relative standard deviation, the levels of which were <6.6 and <8.7%, respectively. The applicability of the method was successfully evaluated by analyzing the target analytes in real aqueous samples, which illustrated satisfactory recoveries (95–104.61%).     

Cyclometalated platinum(II) complexes containing monodentate phosphines: antiproliferative study

Reaction of cyclometalated platinum(II) precursor [Pt(C^N)Cl(dmso)], 1, C^N = N(1), C(2′)-chelated deprotonated 2-phenylpyridine and dmso = dimethylsulfoxide, with 1 equivalent of triphenyl phosphine, PPh₃, or 1,3,5-triaza-7-phosphaadamantane, PTA, gave the complex [Pt(C^N)Cl(PPh₃)], 2, or [Pt(C^N)Cl(PTA)], 3, respectively. On the basis of careful multinuclear NMR spectroscopy, supported by a number of 2D NMR experiments, structures of the complexes 2 and 3 in solution were determined to be neutral four coordinate. The X-ray crystallography indicated that the solid-state structure of complex 3 comprised a common square-planar geometry around platinum(II). Cytotoxicity of the complexes 2 and 3 was studied in three human cancer cell lines derived from ovarian carcinoma (CH1), lung carcinoma (A549), and colon carcinoma (SW480).     

Finite difference time domain analysis of a photonic crystal substrate patch antenna

Planar microstrip patch antennas can achieve a wide range of radiation patterns. However, due to surface-wave losses, they have low bandwidth, low gain, and a potential decrease in radiation efficiency. In order to minimize the surface-wave effects, a photonic-band gap (PBG) substrate is proposed. The PBG structure significantly diminishes the surface-wave modes and thus improves the gain and far-field radiation pattern and efficiency. In this paper, using FDTD, an accurate full-wave analysis of surface-wave propagation in a rectangular microstrip patch antenna with and without PBG is presented. Finally, the antenna fabricated and result of measurement was compared with numerical simulation.