不同入射角度下强流脉冲电子束能量沉积剖面和束流传输系数模拟计算

 强流脉冲电子束在材料中的能量沉积剖面、能量沉积系数和束流传输系数受其入射角的影响很大，理论计算了0.5~2.0MeV的电子束以不同的入射角在Al材料中的能量沉积剖面和能量沉积系数，并且还计算了0.4~1.4MeV电子束以不同入射角穿透不同厚度C靶的束流传输系数。计算结果表明，随着入射角的增大，靶材表面层单位质量中沉积的能量增大，电子在靶材料中穿透深度减小，能量沉积系数减小，相应的束流传输系数也减小；能量为0.5~2.0MeV的电子束当入射角在60°~70°时在材料表面层单位质量中沉积的能量较大。     

Effects of extended dislocations on charge distribution in GaN epilayer

We have investigated the effect of extended dislocations (0.5-3 μm) on charge distribution in GaN epilayer grown by metalorganic chemical vapor deposition on (0001) sapphire using atomic force microscopy (AFM) and scanning surface potential microscopy (SSPM). It has been observed for the surface at the extended dislocations present in undoped GaN film to be negatively charged showing 0.04-0.2 V higher potential relative to regions that contain no dislocations. In addition to the higher potential at the dislocation core, the surrounding surfaces, including the edge of the dislocations, are also negatively charged in a symmetric way around the dislocations revealing crater-shaped higher potential regions (∼0.04 V) relative to surrounding dislocation-free area. The experimental results show that the protrusion-type of dislocation is also negatively charged and its potential is dependent on the size of dislocation.     

AAS测定纸巾中的铅和镉

本文采用原子吸收光谱法测定纸巾中铅、镉的含量。结果表明，不同纸巾中的污染元素铅、镉的含量不同。同时还对一种纸巾的铅、镉元素进行了回收实验，回收率在92％-104％之间。     

用γ计数率的变化定位核元件的技术研究

用标准放射源进行模拟核材料库房监控实验,当放射源被转移出系统的时候,在不同位置探测了γ计数率变化,根据γ计数率变化的距离平方反比规律实现了被转移的放射源的定位,并估算了该放射源的源强.     

A Facile Synthesis of α-Phenylthio-α,β-Unsatuated Esters

α-phenylthio-α，β-unsaturated esters 6 were synthesized by Witting reaction of 3.which were prepared by a phenylsulfenyllation-trans-ylidation reaction.     

Impact of nonlinear phase noise on direct-detection DQPSK WDM systems

The performance degradation of differential quadrature phase-shift keying (DQPSK) wavelength-division-multiplexed (WDM) systems due to self-phase modulation (SPM)- and cross-phase modulation (XPM)-induced nonlinear phase noise is evaluated in this letter. The XPM-induced nonlinear phase noise is approximated as Gaussian distribution and summed together with the SPM-induced nonlinear phase noise. We demonstrate that 10-Gb/s systems, whose walkoff length is larger than 40-Gb/s systems', are more sensitive to XPM-induced nonlinear phase noise than 40-Gb/s systems. Furthermore, DQPSK WDM systems show lower tolerance to both SPM- and XPM-induced nonlinear phase noise than differential phase-shift keying WDM systems.     

A 0.9 V 92 dB Double-Sampled Switched-RC Delta-Sigma Audio ADC

A 0.9 V third-order double-sampled delta-sigma audio ADC is presented. A new method using a combination of a switched-RC technique and a floating switched-capacitor double-sampling configuration enabled low-voltage operation without clock boosting or bootstrapping. A three-level quantizer with simple dynamic element matching was used to improve linearity. The prototype IC implemented in a 0.13 CMOS process achieves 92 dB DR, 91 dB SNR and 89 dB SNDR in a 24 kHz audio signal bandwidth, while consuming 1.5 mW from a 0.9 V supply. The prototype operates from 0.65 V to 1.5 V supply with minimal performance degradation.     

A study on charge reduction in HfO/sub 2/ gate stacks

Charge in metal-organic chemical vapor deposition-grown HfO/sub 2/ gate stacks has been systematically studied using nMOS capacitors. It is found that, for these films, the charge in the stack is mainly concentrated at the interfaces between the layers and is negative at the HfO/sub 2//interfacial layer (IL) interface and positive at the Si/IL interface. In general, the calculated charge densities at both interfaces are of order 10/sup 12/ cm/sup -2/. A forming gas anneal (FGA) reduces both interface charge greatly. The FGA can also significantly reduce the hysteresis and interface state density. The effects of post deposition anneal at various temperatures and under various ambients have also been studied. It is found that a high-temperature dilute oxidizing ambient anneal followed by an FGA reduces the charge at both interfaces.     

一种新型波长转换器的模块化设计

对一种新型结构全光波长转换器进行了高精度、高稳定度的模块化设计，并利用该模块实现对波长转换器参数的监控。结果表明这种新型模块对波长转换器的实现提供了可靠的保证，表现出较高的稳定度和实用性。     

The Design for Automation of Pellet-Forming Process in HL-2A Pellet Fueling System

In the ever fusion experiments in SWIP, pellet forming process was carried out through adjusting relative devices by staff member in site, which will make every pellet-forming process slight distinction and will result in pellet difference in shape, size and intensity. In the intervals of HL-2A discharges, staff member have to go site to accomplish the pellet-forming process, this wastes human power and increase the potential danger. So it is necessary to develop a remote control system to perform the pellet-forming process. The control system needs have the features of real-time, reliability and be easy to operate and maintain.