实用型三谱段太阳模拟器的设计与研制

本文设计并研制了一种实用型三谱段太阳模拟器,其光谱匹配可同时调整3个谱段(300~700 nm,700~900 nm,900~1 700 nm)范围的能量,修正后可满足三结砷化镓太阳电池的测试使用要求。本文重点阐述了三谱段太阳模拟器滤光片的设计和氙灯光谱的修正及测试,介绍了太阳模拟器的光机结构。实验表明:三谱段太阳模拟器的光谱匹配满足三结砷化镓太阳电池各子电池的响应电流值。在有效辐照面150 mm×150 mm上,平均辐照度可以达到2个太阳常数(2 730 W/m²),辐照不均匀度达到±1.77%,辐照不稳定度达到±0.83%,为太阳电池自动分拣系统提供了可靠稳定的平台。     

多巴胺在聚溴甲酚绿修饰碳糊电极上的电化学行为

以碳糊电极(CPE)为基底,采用电聚合方法制备出聚溴甲酚绿修饰碳糊电极(PBG/CPE),运用循环伏安法(CV)对修饰电极进行表征,通过扫描电子显微镜(SEM)对聚合膜的表面形貌进行观察分析。利用PBG/CPE研究了多巴胺(DA)的电化学行为,并对最佳实验条件进行了探讨。研究结果表明:DA在PBG/CPE上于0.32V和0.24V处分别出现一对可逆氧化还原峰,PBG/CPE对DA有显著的催化作用,该催化过程受吸附控制。DA催化氧化还原峰电流与其浓度在1.0×10-5~2.0×10-4mol/L范围内呈现良好的线性关系,检出限为1.0×10-6mol/L。     

单滴微萃取-气相色谱质谱联用法测定纺织品中可分解芳香胺

建立了单滴微萃取结合气相色谱-质谱法测定纺织品中可分解芳香胺的方法。研究了萃取剂种类、萃取剂体积、萃取时间、pH和搅拌速度等条件对单滴微萃取效率的影响。确定最佳萃取条件:在室温条件下,取5 mL样液,调节被萃取液pH8,以2μL氯苯为萃取剂萃取20 min,搅拌速度为200 r/min。在优化的实验条件下,检出限为0.08~0.14 mg/kg,线性范围0.5~50 mg/kg,线性相关系数大于0.996,平均加标回收率为75.3%~96.7%,相对标准偏差为3.6%~8.7%。方法适合纺织品中可分解芳香胺的测定。     

固相萃取-高效液相色谱法测定化妆品中的鞣花酸含量

建立了固相萃取-高效液相色谱法测定化妆品中鞣花酸的含量。样品用甲醇-水(1+1)溶液提取,超声提取10min,以10 000r·min-1转速离心5min,移取5.00mL上清液,经MAX固相萃取柱处理,用甲酸-甲醇(5+95)溶液洗脱。MG C18柱(250mm×4.6mm,5μm)为固定相,以0.2%(体积分数)磷酸-乙腈(18+82)溶液为流动相进行洗脱,检测波长为254nm。线性范围为0.5~100mg·L-1,测定下限(10S/N)为20mg·kg-1,应用该方法对化妆品中鞣花酸的含量进行检测,加标回收率在83.5%~100%之间。     

基于DNA-甲苯胺蓝生物聚合离子膜的多环有机物电化学传感器的研究

利用DNA与小分子之间的相互作用,以DNA/壳聚糖生物聚合离子膜固定电活性小分子,制备了DNA-甲苯胺蓝/壳聚糖聚合离子复合膜修饰电极,并利用多环有机物与染料分子对DNA特异结合的竞争关系,构筑了多环有机物非试剂添加型DNA电化学生物传感器。以盐酸四环素为模式分子,利用循环伏安法和方波伏安法研究了该修饰电极的电化学特性以及该电极对盐酸四环素的电化学响应,结果表明,DNA和甲苯胺蓝成功地固定在电极表面,电极表面的甲苯胺蓝保持了很好的电化学活性。利用紫外-可见分光光度法研究了电极对盐酸四环素响应的作用机理。该传感器的线性范围为2.5~100μmol·L-1。     

离子色谱法测定合成气制烯烃产物中的C_1~C_6有机酸

采用离子色谱建立了合成气制烯烃(SGTO)水相产物和油相产物中C1~C6有机酸的测定方法。对分离条件进行了优化,使用标准样品测定了线性范围和工作曲线,考察了方法的精密度和准确度,确定了SGTO油相产物样品的碱洗条件,并对SGTO水相产物和油相产物样品进行了测定。结果表明:C1~C6有机酸的质量浓度在各自配制的质量浓度范围内呈现良好的线性关系,相关系数均大于0.99。标准溶液的回收率测定表明回收率在95.6%~104.3%之间,5次重复测定的相对标准偏差(RSD)在0.4%~3.6%之间,表明该方法具有良好的准确性和精密度。SGTO油相产物中的加标回收率在91.1%~96.8%之间,5次重复测定的RSD为0.7%~2.3%,准确性可以满足实际分析的需要。实际SGTO水相产物和油相产物中C1~C6有机酸的分析结果表明,SGTO水相产物中C2~C4有机酸含量较高,而SGTO油相产物中C4~C6有机酸含量较高。本研究对SGTO反应研究、催化剂制备、工艺优化以及设备材料的选择具有重要意义。     

不同形貌纳米CoWO_4的水热法制备及气敏性能(英文)

以Co(NO3)2·6H2O、Na2WO4·2H2O为主要原料,去离子水为溶剂,利用水热法在不同条件下制备了一系列的纳米CoWO4,用XRD、TEM和比表面分析仪对产品的物相、形貌和比表面积进行了表征。较系统地探讨了水热条件(反应混合物pH值、反应时间、反应温度等)对产物物相和形貌的影响,并研究了不同形貌产品对甲醛、乙醇、氨气、苯和丙酮等的敏感性能。结果表明:水热条件对产品的物相和形貌有影响,在不同水热条件下,可成功制备CoWO4纳米颗粒、纳米立方体及纳米棒;以纳米颗粒、纳米立方体及纳米棒样品制成的气敏元件对被试气体有不同程度的响应,其中以纳米颗粒为基的元件在210℃对1 000μL·L-1NH3灵敏度为3.3。     

Influence of Cell Disruption and Elution on Cellulase Release of Clostridium straminisolvens (CSK1)

Clostridium straminisolvens (CSK1) is a novel cellulolytic bacterium isolated from a cellulose-degrading bacterial community MC1. In this study, the influence of the following cell disruption and elution methods on CSK1cellulase release was investigated: (1) freezing–thawing, (2) ultrasonication, (3) elution, (4) freezing–thawing following elution, (5) ultrasonication following elution, and lastly (6) high-pressure homogenization following elution. The activity of the cellulases CMCase, β-glucosidase, Avicelase, FPase, and xylanase in crude extracts increased 81.5, 23.8, 87.7, 46.3, and 51.7 %, respectively, with an observed optimal treatment method for each cellulase type. The release of protein from CSK1 cells increased following either cell disruption or elution and was highest at 88.3 % in the homogenization high pressure following elution treatment. A newly observed protein was present following cell elution. The performance of cell elution as determined by real time-PCR indicated that the first time cell elution removed more than 90 % of the CSK1 cells from the substrate. These findings demonstrate that cell disruption and elution are effective methods for inducing cellulase release, and elution is the key step for CSK1. To our knowledge, this study presents the first evidence of optimal treatments for induction of cellulase release of Clostridium straminisolvens. This information will be of great value for use in subsequent efforts to better understand the cellulase characteristics of CSK1 and cellulose degradation mechanisms of the MC1 community.     

RP-HPLC法测定QOA的含量及有关物质

建立了测定QOA含量及有关物质的RP-HPLC方法。采用Sepax C18(4.6 mm×250 mm,5μm)色谱柱,流动相为乙腈与体积分数0.1%乙酸水溶液(体积比为10:90),流速1.0 m L/min,检测波长241 nm,进样体积为20μL。QOA质量色谱峰与其相邻杂质峰能完全分离,QOA质量浓度在0.5~50μg/m L范围内呈良好的线性关系(A=48387ρ-736.4,γ=0.9999),检出限为10 ng/m L(S/N≥3)。方法 RSD为0.45%,重复性试验RSD为0.37%,稳定性试验RSD为0.21%。     

Thermal and Nonthermal Effects in Plasmon-Mediated Electrochemistry at Nanostructured Ag Electrodes

Hot carriers (HCs) and thermal effects, stemming from plasmon decays, are crucial for most plasmonic applications. However, quantifying these two effects remains extremely challenging due to the experimental difficulty in accurately measuring the temperature at reaction sites. Herein, we provide a novel strategy to disentangle HCs from photothermal effects based on the different traits of heat dissipation (long range) and HCs transport (short range), and quantitatively uncover the dominant and potential-dependent role of photothermal effect by investigating the rapid- and slow-response currents in plasmon-mediated electrochemistry at nanostructured Ag electrode. Furthermore, the plasmoelectric surface potential is found to contribute to the rapid-response currents, which is absent in the previous studies.