Excitation loss of open resonators

Reported here are the results on level and structure of the radiated field of an open resonator at and off resonance. On the basis of the modelling problem rigorous solution and the measurements at 4-millimeter wavelength we find there are no ways to compensate the radiated field from an open electromagnetic structure at resonance. Analysis of open resonator excitation efficiency shows that the mismatch loss of a slot-fed open resonator runs to 34% while at the aperture-feed excitation this is not more than 6% for the same-geometry resonator.     

Deep submicron CMOS based on silicon germanium technology

The advantages to be gained by using SiGe in CMOS technology are examined, Conventional MOSFETs are compared with SiGe heterojunction MOSFETs suitable for CMOS technology and having channel lengths between 0.5 and 0.1 μm. Two-dimensional computer simulation demonstrates that the improved mobility in the SiGe devices, due to higher bulk mobility and the elimination of Si/SiO₂ interface scattering by the inclusion of a capping layer, results in significant velocity overshoot close to the source-end of the channel. The cut-off frequency, f_t , is found to increase by around 50% for n-channel devices while more than doubling for p-channel devices for typical estimates of mobility. The results offer the prospect of a more balanced CMOS and improved circuit speed especially when using dynamic logic     

Probability-based current dipole localization from biomagneticfields

Focal biomagnetic sources are described as pointlike current dipoles. The dipole parameters, position, and moment coordinates are commonly determined from biomagnetic data using iterative nonlinear optimization algorithms such as the Levenberg-Marquardt algorithm. However, even for single-dipole sources, mislocalizations can occur due to side minima of the cost function or due to a wrong choice of the start vector. This can be shown by introducing a cost function where the independent variables are only the position coordinates instead of position and moment coordinates. This dimensional reduction-which is also possible for multiple dipole sources-is achieved by calculating the cost function at each position with the position and data-dependent, optimum dipole moments. The authors call these dipoles with-in a least squares sense-optimum moments, locally optimal dipoles. The visualization of such a single-dipole cost function and of the iteration steps of the Levenberg-Marquardt algorithm show why mislocalizations cannot be avoided. Therefore, the authors propose an alternative noniterative localization algorithm for single-dipole sources without this drawback. It uses localization probabilities calculated by means of the locally optimal dipoles. Besides the determination of the dipole parameters, the proposed algorithm furnishes a reliable error for each localization. Its effectiveness is shown with simulated and real patient data     

Intercomparison between ozone-broadening parameters retrieved from millimetre-wave measurements by using different techniques

For atmospheric purposes, the N₂- and O₂-, or Air-broadenings of selected transitions of ozone have been investigated in the 195-300 K temperature range. More precisely, the following 13 transitions in the 280-345 GHz frequency range have been studied: the 2_2,0 ← 2_1,1 (279.5 GHz), 24_2,22 ← 24_1,23 (286.2 GHz), 3_2,2 ← 3_1,3 (286.3 GHz), 5_2,4 ← 5_1,5 (293.2 GHz), 13_4,10 ← 14_3,11 (300.7 GHz), 14_0,14 ← 13_1,13 (301.8 GHz), 7_2,6 ← 7_1,7 (303.2 GHz), 26_2,24 ← 26_1,25 (315.9 GHz), 5_3,3 ← 6_2,4 (317.2 GHz), 20_1,19 ← 20_0,20 (320.0 GHz), 26_6,20 ← 27_5,23 (343.2 GHz), 26_2,24 ← 25_3,23 (343.2 GHz), and 4_3,1 ← 5_2,4 (343.5 GHz) lines. Systematic errors are known to be the principal error source and recent intercomparisons of line-broadening coefficients showed differences up to 20%, thus a large effort in minimizing systematic error sources has been taken and cross check measurements with different techniques have been carried out. The conclusion of the intercomparison performed indicates an excellent agreement of the results and that an uncertainty less than 3%, which also takes into account the systematic errors, can be claimed for the line-broadening parameters.     

Fast acquisition clock and data recovery circuit with low jitter

This paper presents a half-rate clock and data recovery circuit (CDR)that combines the fast acquisition of a phase selection (PS) delay-locked loop (DLL) with the low jitter of a phase-locked loop (PLL). The PLL acquisition time improves considerably with use of a phase frequency magnitude detector(PFMD) that feeds back an estimate of the magnitude of the frequency difference in addition to the sign. Measurements in 0.5/spl mu/m CMOS technology show operation up to 700 Mb/s, a 7% acquisition range, an initial acquisition time of 8 bit times with jitter of 30% bit time, and jitter of 16 ps after the PLL acquires lock. With a phase frequency detector (PFD), the PLL locks in about 700 ns from an initial frequency difference of 7%. Measurements using a PFMD show the 700 ns PLL acquisition time is reduced on average by about a factor of 5 to 140 ns from an initial 7% frequency difference. The power dissipation is 300mW.     

A refined stress-strain analysis in the load transfer zone of flat specimens of high-strength unidirectional composites in uniaxial tension 1. Theoretical analysis

With the use of an analytical approach developed, the influence of distribution of a tangential load on the stress concentration in uniaxially tensioned flat specimens of high-strength unidirectional composites near the grips of a testing machine is evaluated. In view of singularity of the analytical solution derived at the points of discontinuity of boundary conditions, for estimating the stress concentration, it is suggested to employ the averaged value of longitudinal stresses, which is calculated by means of an improper integral across the thickness of a near-surface layer. __________ Translated from Mekhanika Kompozitnykh Materialov, Vol. 42, No. 6, pp. 787–796, November–December, 2006.     

Multinomial permutations on a circle

Multinomial permutations on a circle are considered in the framework of combinatorics. Different cases are presented and shown to agree with previously derived formula for the number of cyclic necklaces. Two applied examples are discussed with a view to illustrate the implications of derived formulas. Copyright © 2006 John Wiley & Sons, Ltd.     

Mathematical models of innovation diffusion with stage structure

Mathematical models with stage structures are proposed to describe the process of awareness, evaluation and decision-making. First, a system of ordinary differential equations is presented that incorporates the awareness stage and the decision-making stage. If the adoption rate is bilinear and imitations are dominant, we find a threshold above which innovation diffusion is successful. Further, if the adoption rate has a higher nonlinearity, it is shown that there exist bistable equilibria and a region such that an innovation diffusion is successful inside and is unsuccessful outside. Secondly, a model with a time delay is proposed that includes an evaluation stage of a product. It is proved that the system exhibits stability switches. The bifurcation direction of equilibria is also discussed.     

Nano-electrochemical detection of hydrogen or protons using palladium nanoparticles: distinguishing surface and bulk hydrogen.

The benefits of using nanoparticle-modified electrodes are exemplified through the electrochemical detection of protons and/or hydrogen. It is shown that a palladium-nanoparticle-modified boron-doped diamond allows voltammetric information relating to the relative roles played by the surface and the bulk metal to be obtained for the proton-hydrogen system at palladium surfaces which is not accessible using palladium macroelectrodes or microelectrodes.