WEIGHTED APPROXIMATION ON SZASZ—TYPE OPERATORS

In this paper, we use weighted modules ω(?)(f,t)w to study the pointwise approximation on Szasz-type operators, and obtain the direct and converse theorem, as well as characterizations of the pointwise approximation of Jacobi-weighted Szasz-type operators.     

Rhythmic growth of ring‐banded spherulites in blends of liquid crystalline methoxy‐poly(aryl ether ketone) and poly(aryl ether ether ketone)

Rhythmic growth of ring‐banded spherulites in blends of liquid crystalline methoxy‐poly(aryl ether ketone) (M‐PAEK) and poly(aryl ether ether ketone) (PEEK) has been investigated by means of differential scanning calorimetry (DSC), polarized light microscopy (PLM), and scanning electron microscopy (SEM) techniques. The measurements reveal that the formation of the rhythmically grown ring‐banded spherulites in the M‐PAEK/PEEK blends is strongly dependent on the blend composition. In the M‐PAEK‐rich blends, upon cooling, an unusual ring‐banded spherulite is formed, which is ascribed to structural discontinuity caused by a rhythmic radial growth. For the 50:50 M‐PAEK/PEEK blend, ring‐banded spherulites and individual PEEK spherulites coexist in the system. In the blends with PEEK as the predominant component, M‐PAEK is rejected into the boundary of PEEK spherulites. The cooling rate and crystallization temperature have great effect on the phase behavior, especially the ring‐banded spherulite formation in the blends. In addition, the effects of M‐PAEK phase transition rate and phase separation rate on banded spherulite formation is discussed. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 3011–3024, 2007     

Multi-layer thin films/substrate system subjected to non-uniform misfit strains

Current methodologies used for the inference of thin film stress through curvature measurement are strictly restricted to stress and curvature states that are assumed to remain uniform over the entire film/substrate system. These methodologies have recently been extended to a single layer of thin film deposited on a substrate subjected to the non-uniform misfit strain in the thin film. Such methodologies are further extended to multi-layer thin films deposited on a substrate in the present study. Each thin film may have its own non-uniform misfit strain. We derive relations between the stresses in each thin film and the change of system curvatures due to the deposition of each thin film. The interface shear stresses between the adjacent films and between the thin film and the substrate are also obtained from the system curvatures. This provides the basis for the experimental determination of thin film stresses in multi-layer thin films on a substrate.     

0.25μm CMOS千兆以太网发送器设计

分析了千兆以太网体系结构,给出了符合IEEE 802.3z标准中1000BASE-X规范的发送器电路结构,并采用TSMC 0.25 μm CMOS 混合信号工艺设计了符合该规范的高速复接电路和锁相环时钟倍频电路.芯片核心电路面积分别为(0.3×0.26)mm2和(0.22×0.12)mm2.工作电压2.5 V时,芯片核心电路功耗分别为120 mW和100 mW.时钟倍频电路的10倍频输出时钟信号频率为1.25 GHz,其偏离中心频率1MHz处的单边带相位噪声仅为-109.7 dBc/Hz.在驱动50 Ω输出负载的条件下,1.25 Gbit/s的高速输出数据信号摆幅可达到410 mV.     

基于嵌入式Linux的远程数据采集系统

以嵌入式微控制器为核心,将传感器网络收集来的数据通过无线电发射机发送到远程接收机,从而实现远程数据采集.系统的优势是充分利用了短波无线链路资源,适合于工作在无人区等场合.以ARM7为控制器,功耗小,性能稳定,维护方便;通信方式采用串口通信,连接线少,实现相对简单.系统设计主要应用嵌入式μCLinux系统设计、无线电发射、调制解调器等方面的知识,文中给出了调制解调器拨号协议、系统原理和软件流程等.     

大功率开关电源的设计与实现

介绍了开关电源设计中需要考虑的几个基本问题,包括频率的确定、最大占孔比Dm的确定、逆变变压器的设计和开关功率管的选择,并以一种1 kW的PWM大功率半桥式开关电源为例,详细介绍实际的开关电源设计方案,并给出了实验结果.     

非编码MPSK-OFDM系统判决指导的相位估计研究

本文论及非编码MPSK-OFDM系统载波跟踪中的重要部件?判决指导的相位估计器(PED)的研究.多载波系统的相位估计可以表示为各子载波相位估计的加权和.文中在分析单载波的基础上考察了符号判决错误对多载波相位估计的影响,并提出了两种改进方案,一是给出一组新的加权系数,改善了PED在较低信噪比的性能;二是由导频子载波相位估计指导其它数据子载波相位估计,获得了(-(/)M (/)M)区间上的线性无偏估计器.文中对两种改进算法进行了分析比较和仿真验证.     

An Additive Problem with Primes in Arithmetic Progressions

In this paper, we extend a classical result of Hua to arithmetic progressions with large moduli. The result implies the Linnik Theorem on the least prime in an arithmetic progression.     

水平均匀大气中多束光在接收面上的相关性及其对光强起伏的影响

在科尔莫戈罗夫理论的基础上，推广了光束在接收面上相关函数的物理含义。分析了多光束在接收面上的相关性。并在此基础上形成多光束光强起伏方差的解析表达式。分析结果表明，随着信道间距的增加，信道相关性下降。到达接收面的光强起伏方差降低；当信道完全重合，即相关系数变为1时，叠加后的光强起伏方差没有明显降低。与单光束时没有区别；在允许范围内增加光束数目可降低光强起伏。     

用毛细管测量纯水表面张力系数的误差讨论

通过用毛细管测量纯水表面张力系数实验，得到管内径d与接触角θ的相对误差之间的关系曲线，由此说明实验测得的表面张力系数α和理论公式相比呈现一定的偏差，并简单地讨论了实验的理想状态与实际情况的差别．