复方维生素B片中主要成分的高效毛细管电泳电化学法检测

采用高效毛细管电泳－电化学检测法同时测定复方维生素B片中的主要成分维生素B1，B12，B6和C的含量；研究了电极电位，运行缓冲溶液的浓度和酸度，电泳电压和进样时间等对电泳的影响，以微铂电极为工作电极，检测电位＋0．5V（vs SCE)，在pH9.0的15mmol/L Tris-1mmol/L H3BO3缓冲溶液中，上述4组分在5min内获得基线分离；维生素B1，B12，B6和C的线性范围分别为2．1mg/L-1.0g/L,6.0mg/L-0.80g/L,1.4mg/L-0.72g/L和0．97mg/L-0.44g/L检出限分别为0．50mg/L,1.0mg/L,,0.65mg/L和0．40mg/L；5次测定峰高的相对标准偏差分别为2．4％，3．0％，3．1％，和2．5％，5次测定的平均回收率分别为99％，102％，98％和100％。     

TEOS-MTES基SiO2溶胶微结构的SAXS研究

正硅酸乙酯(TEOS)为前驱体,在碱性条件下制备含有无定形SiO2颗粒的溶胶,以甲基三乙氧基硅烷(MTES)在酸性条件下获得聚甲基硅氧链,二者混合后应用同步辐射X射线进行混合溶胶的SAXS散射强度测定,计算了溶胶的平均回转半径、平均粒径、两相界面层厚度、散射体体积分数、两相间比表面积等参数,辅以光子相关光谱法(PCS)和透射电子显微镜(TEM)观测溶胶粒度,证实SiO2颗粒被MTES混合物连接成族团.实验发现所测混合溶胶样品均表现出对Porod定理的负偏离,说明溶胶中颗粒与溶剂之间存在很明显的两相间界面层.     

模板组装Fe纳米线阵列及其微结构

铝在硫酸溶液中经直流阳极氧化,得到多孔铝阳极氧化膜(AAO). 以AAO膜为模板,通过交流电沉积的方法,在AAO模板孔内成功组装了Fe纳米线.TEM分析表明,Fe纳米线的长度约为2.5 μm,其长度分布十分均匀；粗细均匀,直径约为25 nm. XRD实验分析证实,所制备的Fe纳米线为α-Fe.选区电子衍射（SAED）实验分析表明,α-Fe纳米线具有单晶结构.     

Preparation and Characterization of Ultrafine Rare Earth Molybdenum Complex Oxide Particles

Ultrafine rare earth molybdenum (La–Mo and Ce–Mo) complex oxide particles have been synthesized by the sol–gel process using citric acid as complexing agent. The influence of preparation conditions such as thermal treatment temperature (T), molar ratio of citric acid to metallic ions (L/M), and pH value of the starting solution on the oxide particle size has been studied. The formation of La₂Mo₂O₉and Ce₂Mo₃O₁₂has been investigated using XRD, DTA–TG, FT-IR, TEM, and BET surface area measurements. It is shown that the morphology and structure of the oxide particles are significantly dependent on the preparation conditions. The influence of different preparation methods on the particle size of La–Mo and Ce–Mo oxides is also discussed.     

Studies on fluorescent species of spiro-indolinonaphthooxazines and their fluorescence spectra

Photophysical behavior of spiro[1,3,3-trimethylindolino-2,3′-naphtho[2,1-b]-1,4-oxazine] (SP1) and spiro[1,3,3,2′-tetramethylindolino-2,3′-naphtho[2,1-b]-1,4-oxazine] (SP2) were studied. The fluorescent species and their spectra of SP1 and SP2 in polar solvents (acetonitrile and methanol) and non-polar solvent (cyclohexane) were investigated. The fluorescence decay in polar solvents was studied by picosecond time-correlated single photon counting. In most cases, fluorescence decay obeyed triexponential decay kinetics. The major fluorescent species is an excited intermediate which has similar conformation as its precursor (¹ SP ^*) formed after the bond cleavage between spirocarbon and oxygen in oxazine ring. The effects of molecular structure and solvent polarity on fluorescence spectra and fluorescence decay lifetime were studied.     

通过密度函数理论表征炭质吸附剂的孔径分布

通过密度函数理论（DFT-DensityFunctionalTheory）对炭质吸附剂的孔径分布进行了表征。该法以多孔固体上N2吸附分子模型为依据，用一种方法对多孔固体的孔径分布从微孔到大孔范围进行确定。本文用该法对自制的聚丙烯腈活性炭纤维、国产煤质活性炭及日本产活性炭微球等六种炭质吸附剂的孔径分布进行了表征。     

K-Mo基催化剂的表面酸性与其合成醇选择性

对500℃和800℃焙烧制得的氧化态K－MoO3／γ－AlO3，K－MoO3／SiO2及非负载K－Mo催化剂进行硫化后，测试其合成醇活性．结果表明500℃焙烧制得的负载型催化剂显示较高的合成低碳烃活性和较低的合成低磷醇选择性，经800℃焙烧后，合成低磷醇的选择性大幅度提高．500℃焙烧的非负载K－Mo催化剂显示较高的合成醇选择性，经800℃焙烧后，促碳醇的选择性保持不变．用氨的吸附及TPD方法测定了各样品的酸性，并与催化剂活性对照，发现催化剂酸性越强，酸量越大，则其合成醇选择性越低．催化剂上的乙醇分解实验证实，催化剂的酸量大小与它的醇分解活性成正变关系，这些结果说明催化剂酸性对其合成醇性能有直接的影响．     

Simultaneous determination of Co(II), Cr(VI), Ni(II) and Pb(II) in water by solvent extraction and high-field 1H NMR Spectrometry

A novel analytical approach is described that combines the preconcentration power of solvent extraction with the resolution and sensitivity of a 500 MHz ¹H NMR spectroscopic detection method for the quantitative determination of metals. Co(II), Cr(VI), Ni(II) and Pb(II) in water are extracted into chloroform as dithiocarbamate complexes. By decoupling the protons and employing a solvent-induced shift method, the ¹H NMR spectrum containing the dithiocarbamate complexes of Co(II), Cr(VI), Ni(II) and Pb(II) is fully resolved at CDCl₃/ C₆D₆ below 40%/60%. The detection limits for Co(II), Cr(VI), Ni(II) and Pb(II) are estimated to be 0.12, 0.073, 0.11 and 0.27 μg/mL, respectively, in the sample solution. Received: 31 July 1997 / Revised: 24 October 1997 / Accepted: 31 October 1997     

Study on analysis of153Sm-EDTMP stability in vitro and vivo by HPLC

The behavior of¹⁵³Sm-EDTMP in vitro and vivo is analyzed by the size exclusion HPLC. The experimental results show that EDTMP amounts have an obvious effect on the stability in vitro and uptake of¹⁵³Sm-EDTMP in the liver. HPLC analysis of urine sample indicates that¹⁵³Sm-EDTMP es excreted in the original form. The behavior in vivo of¹⁵³Sm-EDTMP containing 4 μg is similar to that of¹⁵³Sm-EDTMP containing 50 μg EDTMP at 1 h post-injection.     

A unique reaction pathway of fluorine-substituted ethyl groups on Cu(111): successive alpha,alpha-fluoride elimination

Fluorine-substituted ethyl groups on Cu(111) were generated by thermal scission of the C-I bond in the adsorbed C2F5I. Temperature-programmed reaction spectrometry observed a novel pathway resulting in the evolution of C4F6 above 400 K. Among the various isomers, this product was identified as hexafluro-2-butyne. Although abstraction of two fluorine atoms from the starting Cu-CF2CF3 was required, Cu-CCF3 (trifluoroethylidyne) was favored over Cu-CF=CF2 (trifluorovinyl) as the intermediate because this ethyl-ethylidyne-butyne pathway was suppressed on a Cu(100) surface devoid of the key threefold hollow binding sites for ethylidyne. Once formed, perfluoroethylidyne readily coupled to afford a tightly surface-bound hexafluoro-2-butyne up to 400 K. Therefore, the C-F bonds adjacent to the metal were found to be more susceptible to the bond activation, leading the chemisorbed perfluoroethyl to eliminate two F atoms successively from the alpha-carbon. This preference for alpha-elimination rather than beta-elimination (the most favorable route in hydrocarbons) may be quite general for metal surface-mediated reactions involving fluorinated alkyl groups.