Anomalous variations of OFF-State leakage current in poly-Si TFTunder static stress

Studies the anomalous variations of the OFF-state leakage current (I_OFF) in n-channel poly-Si thin-film transistors (TFTs) under static stress. The dominant mechanisms for the anomalous I_OFF can be attributed to (1) I_OFF increases due to channel hot electrons trapping at the gate oxide/channel interface and silicon grain boundaries and (2) I_OFF decreases due to hot holes accumulated/trapped near the channel/bottom oxide interface near the source region. Under the stress of high drain bias, serious impact ionization effect will occur to generate hot electrons and hot holes near the drain region. Some of holes will be injected into the gate oxide due to the vertical field (~(V_Gstress V_Dstress)/T _OX) near the drain and the others will be migrated from drain to source along the channel due to lateral electric field (~V_Dstress/L_CH)     

Reconfigurable Microstrip Patch Antenna with Switchable Polarization

A novel reconfigurable microstrip patch antenna with frequency and polarization diversities is proposed. A U‐slot is incorporated into a square patch, and a PIN diode is utilized to switch the slot on and off, which realizes the frequency diversity characteristic. The polarization diversities among linear polarization (LP), right‐hand circular polarization (RHCP), and left‐hand circular polarization (LHCP) are also obtained by switching three PIN diodes on the slot and the truncating corners of a square patch on and off. The antenna design and experimental results are presented.     

Theoretical and Experimental Driving-Point Impedance Results of Resonance Circuits in a Gunn Waveguide Oscillator

The frequency tuning range of waveguide oscillator and its stability depend sensitively on the dimension of the resonance cap. Therefore the driving-point impedances with the various dimensions of the resonance cap are calculated by using HFSS(High Frequency Simulation System). In this paper the comparisons between theoretical results of the driving-point impedances as a function of frequency and that of experimental results are described. The oscillation frequency range could be predicted by using the theoretical evaluation methods which are proposed. It shows that resonance cap size and disc height have an effect on the frequency tuning characteristics of Gunn oscillator.     

Synthesis of 5‐Radioiodoarabinosyl Uridine Analog for Probing the HSV‐1 Thymidine Kinase Gene

Tumor cells transduced with herpes simplex virus thymidine kinase gene have been intensively applied to the field of positron emission tomography via imaging of its substrate. As a pilot synthesis approach, a facile preparation of 5‐[¹²⁵I] iodoarabinosyl uridine starting from commercially available uridine is reported herein.     

Analysis of a grating metal structure with broad back-scatteringfield pattern for applications in vehicle collision avoidancesystem

In this paper, grating metal structures with broad and flat back-scattering field patterns are studied for possible applications in a vehicle collision avoidance system. The two-dimensional TE scattering of a planar grating structure and a curved grating structure are analyzed at a frequency of 77 GHz. For the planar structure, the method of moments and Floquet's theorem are used to solve the induced current and the resultant back-scattering field. Based on the results of the planar structure, the scattering field of the curved grating structure is obtained by using a perturbation method. The influence on the field pattern of the curvature as well as other structure parameters, such as the width and geometry of each period in the grating structure, is investigated     

Preparation of Fe–Si–B–Nb amorphous powder cores with excellent high-frequency magnetic properties

FeSiBNb amorphous powder cores were prepared with the amorphous powder by gas atomization and subsequent hot pressing of resulting powder after creating oxide layers on the amorphous powder. Fully amorphous FeSiBNb powders with good soft magnetic properties were successfully obtained in the particle size range below 100 μm. FeSiBNb amorphous powder cores exhibit stable permeability up to 10 MHz, showing excellent high-frequency characteristics.     

Singlewall carbon nanotubes covered with polystyrene nanoparticles by in‐situ miniemulsion polymerization

This work is to make carbon nanotubes dispersible in both water and organic solvents without oxidation and cutting nanotube threads. Polystyrene‐singlewall carbon nanotube (PS‐SWNT) composites were prepared with three different methods: miniemulsion polymerization, conventional emulsion polymerization, and mixing SWNT with PS latex. The two factors, crosslinking and surface coverage of PS are important factors for the mechanical and electrical properties, including dispersion states of SWNT in various solvents. The PS‐SWNT composite prepared via a conventional emulsion polymerization showed SWNT bundles entirely covered with PS, whereas the PS‐SWNT composite prepared via a miniemulsion polymerization showed SWNT partially covered with crosslinked PS nanoparticles. The method of mixing SWNTs with PS latex did not show the well dispersed state of carbon nanotubes because PS was not crosslinked and was dissolved in a solvent, and nanotubes separated from PS precipitated. So the PS nanoparticle‐SWNT composite had lower electrical resistance, and higher mechanical strength than the other composites made by the latter two methods. As the amount of SWNT increases, the bare surface area of SWNT increases and the electrical conductivity increases in the composite made by the miniemulsion polymerization. © 2005 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 573–584, 2006     

Investigation of the Doughnut Effect in Cy3-Labeled Protein Microarrays using Scanning Near-Field Optical Microscope

We demonstrate the fluorescence mapping of protein microarrays by the technique of scanning near-field optical microscopy (SNOM) and confocal microscopy. Micron sized spots (300 μm) of human Immunoglobulin G (hIgG) protein with and without a Cy3 dye labeling have been fabricated on glass substrates by an immobilization method which makes use of calixcrown derivatives termed Prolinker. We have also tried to probe into the well-known “doughnut effect” observed in fluorescence images of proteins using the SNOM technique. The topographic and fluorescence SNOM images revealed that the number of proteins at the boundary of the spot were more than at the center in the case of the microarray spot which showed brighter luminescence at the edge than at the center in the confocal image.     

Extraction of left-ventricular chamber from 3-D CT images of the heart

A semiautomatic method is described for extracting the volume and shape of the left ventricular (LV) chamber from a dynamic spatial reconstructor cardiac volume. For a given volume, the operator first performs some simple manual edits. Then, an automated stage, which incorporates concepts from 3-D mathematical morphology and technology, the maximum-homogeneity filter, and an adaptive 3-D thresholder, extracts the LV chamber. The method gives more consistent measurements and demands considerably less operator time than manual slice-editing.