Determination of the rheological behavior of epoxy–amine thermosets by dynamic mechanical analysis: Isothermal methods versus nonisothermal methods

The reticulation process of an epoxy resin using an amine as a cure agent was studied at different temperatures and concentrations of the cure agent with dynamic mechanical thermal analysis. The study was performed under both isothermal and nonisothermal conditions, and a temperature–time–transformation diagram was obtained. The measurements from the two modes gave similar results, although the nonisothermal mode required fewer experiments. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 1965–1977, 2003     

ηi-Mode Related Properties of Collisionless Anisotropic Plasmas

An extended eigenvalue problem for collisionless electrostatic driftwaves in cylindrical and slab geometry is discussed and solved in local approximation. The fact of a minimum threshold for the ITG instability (η_i-mode) is used to get a unique concept for profile determination.     

An unconditionally stable two-stage CMOS amplifier

This paper describes a two-stage CMOS amplifier that is stable for any capacitive load. This is achieved through the use of an optimized cascoded compensation topology. A new level shifting technique allows independent optimization of drive capability, noise and systematic offset voltage. The circuit is 0.1 mm² in a 2 μm technology and has a quiescent current consumption of 110 μA     

Bandwidth renegotiation for VBR video over ATM networks

A scheme for delivery or variable bit-rate (VBR) video over asynchronous transfer mode (ATM) networks where bandwidth can be renegotiated during the duration of a call between the video source and the network is considered. Renegotiation can be initiated by either the video source or the network. The video bandwidth requirement is characterized by a usage parameter control (UPC) consisting, in general, of peak rate, burst length, and sustained rate. A baseline design is outlined where rate-control adjusts the source's rate while a new UPC is requested from the network. When granted, the new UPC allows the source to maintain its target quantization and delay requirements. Rate control epochs may be extended when the network blocks UPC requests or sets a lower UPC value to temporally deal with congestion. Simulation results are presented for VBR MPEG video. The results show that with a moderate renegotiation rate the scheme tracks the bandwidth requirements of the source. As a result, the video quality and bandwidth efficiency can be maintained     

Extension of multigrid methodology to supersonic/hypersonic 3-D viscous flows

A multigrid acceleration technique developed for solving the three-dimensional Navier–Stokes equations for subsonic/transonic flows has been extended to supersonic/hypersonic flows. An explicit multistage Runge–Kutta type of time-stepping scheme is used as the basic algorithm in conjunction with the multigrid scheme. Solutions have been obtained for a blunt conical frustum at Mach 6 to demonstrate the applicability of the multigrid scheme to high-speed flows. Computations have also been performed for a generic High-Speed Civil Transport configuration designed to cruise at Mach 3. These solutions demonstrate both the efficiency and accuracy of the present scheme for computing high-speed viscous flows over configurations of practical interest.     

Quick simulation of detector error probabilities in the presence ofmemory and nonlinearity

One would like to compare and analyze digital communication systems based upon their overall probability of error. Unfortunately, easily evaluated closed form expressions for these probabilities are almost impossible to derive due to the complexity of the stochastic systems usually encountered. Hence, one must often resort to simulation to obtain the desired quantities. The most obvious technique is Monte Carlo simulation, which directly counts the number of errors in repeated trials. The problem is that error probabilities are usually quite small, requiring numerous simulation runs to sufficiently “hit” the rare event to gain adequate knowledge of its statistics. This places severe demands on the computer's random number generator. Importance sampling strategies simulate under altered input signal distributions (e.g., translation or stretching) so as to “speedup” convergence of the error estimators. The authors discuss a speedup technique termed quick simulation based upon results in large deviation theory. The quick simulation method is shown to compare favorably with three other importance sampling techniques for simulating a simple nonlinear system with memory     

Eigenstates of polarization of elliptical single-mode fibers

The degree of polarization of radiation in an elliptical polarization-maintaining fiber and the polarization states of eigenpolarization modes of such fibers have been experimentally investigated in a wide spectral range. It has been shown that the elliptical fibers are uniform, homogeneously twisted fibers with elliptically polarized eigenpolarization modes. The ellipticity of the eigenpolarization mode is independent of fiber length and increases with wavelength, while the azimuth of the eigenpolarization mode is spectrally independent     

Modulation resonance enhancement in SCH quantum-well lasers with anexternal Bragg reflector

The modulation response of a semiconductor laser can be enhanced by coupling it to an external cavity with frequency-selective feedback. This creates a comb of transmission bands where the modulation response is high, at the cavity round-trip frequency and its harmonics. In a previous publication, we related the bandwidths of these bands to the material and structural parameters of a bulk laser. We showed that a nonzero linewidth enhancement factor together with a nonzero intermediate facet reflectivity lead to deep nulls close to the peaks of these transmission bands. This suggests that quantum-well (QW) lasers, which have a low linewidth enhancement factor, may give a better performance than bulk lasers. To test this hypothesis, we have extended our analysis to model QW lasers coupled to a fiber grating. Carrier transport, carrier heating, intraband carrier fluctuations, and nonparabolic band structures are considered. We show that electron carrier transport and amplitude-phase coupling in the separate-confinment-heterostructure (SCH) layer contribute to the nulls in the modulation response. Therefore, the apparent advantage of having a reduced linewidth enhancement factor that we found in our previous analysis cannot be fully realized by using QW lasers     

Design and characterization of a mode-splitting Ψ-junction

It will he shown In this paper, that the mode conversion factor (MCF) as defined for Y-junctions, can be profitably applied for the design of three branch junctions for splitting the three lowest-order modes of a channel waveguide. Accordingly, these so-called mode-splitting Ψ-junctions were designed for implementation in PECVD SiON-technology. Propagation calculations point to crosstalk levels well below -20 dB at 10-20 mm junction length. The produced Ψ-junctions show crosstalk of less than -17 dB, mainly originating from the nonhomogeneity of the refractive indexes of the SiON layers