Synthesis,Crystal Structure and IR Spectra of Complexes of Mn(II) by Indole-2-Carboxylic or Isoquinoline-1-Carboxylic Acids and 1,10-Phenanthroline

Abstract  

Two ternary complexes of manganese(II) indole-2-carboxylate (2-IC⁻) or isoquinolinecarboxylate (IQC⁻) with 1,10-phenanthroline (phen) in methanol or in dimethylacetamide (DMA) were synthesized and studied by X-ray diffraction and IR spectra. [Mn(C₉H₆NO₂)₂(C₁₂H₈N₂)₂]·CH₄O (1) crystallizes in the triclinic space group P-1 with cell parameters of a = 10.548(2) ?, b = 14.168(3) ?, c = 14.580(3) ?, α = 62.35(2)°, β = 69.16(2)°, γ = 78.61(2)°, V = 1802.4(6) ?³ and Z = 2; [Mn(C₁₀H₆NO₂)₂(C₁₂H₈N₂)].C₄H₉NO (2) crystallizes in the monoclinic space group P2₁/a with cell parameters of a = 15.304(5) ?, b = 12.871(5) ?, c = 17.421(5) ?, β = 114.39(1), V = 3125(2) ?³ and Z = 4. In 1, Mn is six-coordinate by two bidentate phen ligands and two 2-IC⁻ ligands and exhibits a very distorted octahedral geometry. This complex is solvated by methanol involved in hydrogen bonding. In 2, Mn atom is surrounded by one bidentate phen ligand and two bidentate IQC⁻ ligands. The complex exhibits a distorted octahedral geometry around the Mn^II atom. The crystal structure is completed by a disordered DMA solvate molecule. The IR spectra of both compounds are slightly different in the range 4000–2400 cm⁻¹ which may be attributed to hydrogen bond lack in 2.     

TEM characterization of chemically synthesized copper–gold nanoparticles

Dodecanethiol-capped Cu–Au nanoparticles, synthesized via a successive two-phase (water/toluene) and galvanic-exchange procedure, were characterized using transmission electron microscopy (TEM). The size range of the particles is around 1–7 nm. Electron-induced morphological evolution was observed under high resolution (HR) TEM. Cuboctahedral morphology was found to be thermodynamically stable. Electron-induced aggregation of two particles was also observed. Chemical ordering of cuboctahedral particles was studied by atomic-resolution high angle annular dark field (HAADF) imaging in scanning TEM (STEM) mode and energy dispersive X-ray (EDX) element mapping using a silicon drift detector (SDD). The particles were found to be Cu–Au mixed, and to be stable in air. Surface plasmon resonance (SPR), which is dependent on local structure and morphology, was investigated by electron energy loss spectroscopy (EELS).     

Theory of Microbial Carbonate Precipitation and Its Application in Restoration of Cement-based Materials Defects

Bacterial induced carbonate mineralization has been demonstrated as a new potential method for restoration of limestones in historic buildings and monuments. We claim here the formation of calcium carbonate was controlled by extracellular polymeric substances (EPS) isolated from Bacillus pasteurii. The process of crystallization nucleation was accelerated in the presence of cells and inhibited in the presence of EPS. The CaCO₃ film deposited on cement paste surface was about 100 µm after 7 d treatment. The results of various restoring methods showed that higher decrease of water absorption of cement paste was gained in brushing application in the presence of agar, which could maintain urease with high activity in long term compared to spraying method. The coefficient of capillary suction of cement paste treated with brushing method was reduced by 90%. Mixed media consisted of sands, urea, Ca²⁺ and concentrated biomass, was injected into artificial cracks of cement paste followed by continual nutrient supplement, and CaCO₃ particles were precipitated gradually between sands particles which were combined with cement matrix. The results showed that the compressive strength of recovered specimens was restored to 84%, which demonstrated that this kind of bio‐restoration method is effective in repairing surface defects of cement‐based materials.     

Four-wave mixing between pump and signal in a distributed Raman amplifier

We observed experimentally four-wave mixing (FWM) between a 14xx-nm pump and a 15xx-nm signal in a forward-pumped distributed Raman amplifier (DRA) over 50 km of nonzero dispersion-shifted fiber with a zero dispersion wavelength of 1497 nm. The 100-mW pump Fabry-Perot (FP) spectra centered at 1440, 1450, and 1460 nm are reproduced via FWM around the single-wavelength probe signal around 1558, 1548, and 1538 nm, respectively. The suppression of DRA gain by about 2-3 dB was experimentally observed with peak FWM at minimum phase mismatching between two 14xx-nm FP pump wavelengths and two 15xx-nm signal wavelengths. This DRA gain suppression, together with the reproduced pump FP spectrum at 15xx-nm signal band, may limit the usefulness of the forward-pumped DRA, generating spectrally nonuniform FWM-induced noise floors and crosstalk in wavelength-division-multiplexed fiber-optic transmission systems.     

煤燃烧中飞灰的光学特性和辐射传热

利用快速Ｆｏｕｒｉｅｒ红外光谱仪，对三种具有与锅炉煤粉飞灰组成相似的合成灰（即纯氧化物的混合物）的辐射特性进行了测量（ＫＢｒ压片方法）；同时，利用对不同细度粒子所测得的吸数指数，计算了其间充满了弥散灰粒子的平行平板间的辐射传热。结果表明：用透射光谱来确定吸收指数的传统方法，对颗粒的细度十分敏感，往往会造成不可接受的误差；另外，发现合成灰的吸数指数较之所对应的熔渣要高得多，这对美国Ｓｔａｎｆｏｒｄ大学试图用熔渣的光学参数来代替飞灰参数的想法提出了质疑。     

Common Core State Standards in the Middle Grades: What's New in the Geometry Domain and How Can Teachers Support Student Learning?

The Common Core State Standards for Mathematics (CCSSM) is a primary focus of attention for many stakeholders' (e.g., teachers, district mathematics leaders, and curriculum developers) intent on improving mathematics education. This article reports on specific content shifts related to the geometry domain in the middle grades (6–8) mathematics curriculum. The methodology employed allows for comparisons of content across multiple standards documents. We report on some dramatic changes with regards to the geometry content taught in the middle grades. We found 52% of the middle grades geometry CCSSM learning expectations will be new to the respective grade level at which they are taught in at least six of the eight states analyzed in this study (57% in grade 6, 50% in grade 7, and 50% in grade 8). We also highlight three areas that represent “new” geometry content at the middle grades based on our analysis of CCSSM and pre‐CCSSM state standards.     

Twostep-by-twostep continuous PIRKN-type PC methods for nonstiff IVPs

In this paper, we start with the consideration of direct collocation-based Runge-Kutta-Nyström (RKN) methods with continuous output formulas for solving nonstiff initial-value problems (IVPs) for systems of special second-order differential equations y″(t) = f(t, y(t)). At nth step, the continuous output formulas can be used for calculating the step values at (n + 2)th step and the integration processes can be proceeded twostep-by-twostep. In this case, we obtain twostep-by-twostep RKN methods with continuous output formulas (continuous TBTRKN methods). Furthermore, we consider a parallel predictor-corrector (PC) iteration scheme using the continuous TBTRKN methods as corrector methods with predictor methods defined by the continuous output formulas. The resulting twostep-by-twostep parallel-iterated RKN-type PC methods with continuous output formulas (twostep-by-twostep continuous PIRKN-type PC methods or TBTCPIRKN methods) give us a faster integration processes. Numerical comparisons based on the solution of a few widely-used test problems show that the new TBTCPIRKN methods are much more efficient than the well-known PIRKN methods, the famous nonstiff sequential ODEX2, DOP853 codes and comparable with the CPIRKN methods.     

基于高速DSP的实时语音增强系统设计

随着移动通信技术的快速发展,语音增强的研究及其实际应用成为数字化通信的一个重要的研究方向。在数字信号处理技术的支撑下,许多优秀的语音增强算法的实时实现成为了可能。谱减法是一种运算量相对较小,增强效果明显,并且容易实时实现的语音增强算法,但是其缺点就是残留有音乐噪声。针对传统谱减法,本语音增强系统采用了一种改进算法,就是...