Preparation, characterization and photocatalytic activity of polycrystalline Bi2O3/SrTiO3 composite powders

Bi₂O₃/SrTiO₃ composite powders have been prepared and their photocatalytic activities were investigated by photooxidation of methanol. These powders were characterized by UV-Visible diffuse reflectance spectra, SEM and X-ray diffraction (XRD). The results revealed that all the Bi₂O₃/SrTiO₃ composite powders exhibited higher photocatalytic activity than pure SrTiO₃, Bi₂O₃ and TiO₂ (P25) under visible light irradiation (λ>440 nm). The effects of the Bi₂O₃ contents on the photocatalytic activities of the composite powders were examined, the photocatalytic activities increased with the content of Bi₂O₃ increasing to a maximum of 83% and then decreased under visible light irradiation. The effects of the calcination temperatures on the photocatalytic activities of the composite powders were also investigated.     

偶氮苯衍生物三阶非线性的四波混频研究

用皮秒Ｎｄ：ＹＡＧ激光器的倍频光（５３２ｎｍ）对具有离域π－共轭电子云结构的偶氮苯类样品材料作简并四波混频补给，测得三阶非线性电极化率ｘ＾（３）和它们的时间响应分别为１０＾－９ｅｓｕ和２０ｐｓ，并对影响ｘ＾（３）的瞬时光栅作用和ｘ＾（３）的响应时间人了讨论。     

Non-destructive evaluation of residual stresses in thin films via x-ray diffraction topography methods

Quantitative x-ray diffraction topography techniques have been used to measure the residual strain magnitude and uniformity of deposition for Mo and W sputtered films on Si(100) substrates. High sensitivity rocking curve measurements were able to determine differential strains for films as thin as 2.5 nm; while Bragg angle contour mapping had similar sensitivity and was also able to assess coating uniformity and stress distribution over areas covering a whole wafer. Measurements of strain versus film thickness over a range of 2.5 nm to 80 nm showed that a critical thickness exists for maximum residual strain. Growth beyond this range produces stress relaxation. This non-destructive type of analysis could be employed on a wide range of film-substrate combinations.     

Effect of nonlinear wave-current interaction on flow fields and hydrodynamic forces

A fifth-order theory for solving the problem of interaction between Stokes waves and exponential profile currents is proposed. The calculated flow fields are compared with measurements. Then the errors caused by the linear superposition method and approximate theory are discussed. It is found that the total wavccurrent field consists of pure wave, pure current and interaction components. The shear current not only directly changes the flow field, but also indirectly does so by changing the wave parameters due to wave-current interaction. The present theory can predict the wave kinematics on shear currents satisfactorily. The linear superposition method may give rise to more than 40% loading error in extreme conditions. When the apparent wave period is used and the Wheeler stretching method is adopted to extrapolate the current, application of the approximate theory is the best. Project supported by the Chinese Academy of Sciences.     

Equivalent boundary integral equations for plane elasticity

Indirect and direct boundary integral equations equivalent to the original boundary value problem of differential equation of plane elasticity are established rigorously. The unnecessity or deficiency of some customary boundary integral equations is indicated by examples and numerical comparison.     

PIXE analysis of the Mn-doped content in Ga1-xMnxN film grown by LP-MOVPE

Summary Department of Technical Physics, School of Physics, Peking Unive     

3mm波段极近距离雷达

提出一种极近距离雷达概念，并导出其作用距离公式，在此基础上研制出一台３ｍｍ波段极近距离多普勒雷达样机．试验结果表明该雷达结构简单，成本低廉，在作用距离为零点几米至几米范围内可获得较高的定距精度．     

一种新颖的半导体光放大器镀膜监控方法

本文介绍了一种在半导体光放大器镀膜过程中监测端面反射率的简单而有效的方法。理论模型的建立考虑了光放大器的漏电流和自发发射速率随载流于浓度的非线性变化，并且基于实验测量的ＰＩ（输出功率与注入电流）曲线，采用曲线拟合的方法来修正一些依赖于器件的参数，理论计算结果与有关文献的测量结果较好地吻合。     

电热泵用于蔬菜温室供热的经济性分析

现代化蔬菜温室是我国都市农业发展中的一个重要组成部分，目前这类温室的冬季加热均以燃煤方式为主．伴随着越加严重的城市环境污染，温室供热系统也面临着改造问题，需要引入清洁供热方式，热泵供热是其中的一种．本文以上海地区现代化蔬菜温室为研究对象，分析了蔬菜温室中使用电热泵供热的运行成本，并与燃煤供热方式进行了对比．就热泵供热系统在温室中的应用前景及可行性、经济性进行了分析，为热泵在温室供热系统中的应用提供了可参考依据．     

一种红外成像系统作用距离试验评估方法

进行红外成像系统作用距离考核试验时，由于外场试验中的目标特性及气象条件与指标提出对应的目标特性及气象条件有差别，因此需要进行必要的折算。提出一种基于信噪比准则的可行的红外成像系统作用距离试验评估方法。