Expeditious Approach to Coumarins via Pechmann Reaction Catalyzed by Molecular Iodine or AgOTf

An efficient and facile route for the synthesis of coumarins via the Pechmann reaction catalyzed by molecular iodine or AgOTf was described.     

Fast switching beam steering based on ferroelectric liquid crystal phase shutter and polarisation grating

We report on fast-switching and high-efficient optical beam steering based on a polymerisable liquid crystal polarisation grating (PG) in combination with ferroelectric liquid crystal (FLC) phase shutter. The PG was fabricated in a convenient single-step holographic exposure process using photo-sensitive azo-dye material as alignment layer for liquid crystal (LC) director. A binary electro-optical FLC was employed for circular polarisation selection, which enables the electro-tunable steering of the combined system. The efficiency of 95.7% with 82 μs switching time is obtained for 1064 nm laser. This work provides a versatile candidate for non-mechanical beam steering devices.     

化学感觉及其转导机制

化学感觉包括了红辣椒产生的灼烧感、椒样薄荷产生的清凉感、碳酸饮料产生的麻刺感和葡萄酒产生的涩感,是化学物质刺激到感受冷、热、疼痛等神经系统而产生的敏感性反应。化学感觉是一个相对较新的术语,最早称为共同化学感觉,后来又称为三叉神经反应。化学感觉与嗅觉、味觉相互结合形成一种独特的食品香味,尽管其他感官输入(例如质地、色泽和温度等)也参与整个香味形成过程。本文对化学感觉的基本特征、它与嗅觉、味觉的相互作用及其转导机制进行了概括介绍。     

气驱油油气混相过程的界面传质特性及其分子机制

油气混相过程的界面传质特性对气驱提高原油采收率技术非常重要。本文针对吉林某油田的实际油组分,采用分子动力学模拟研究了气驱油过程,分析了不同气体和驱替压力下油气两相的状态变化以及界面特性,获得不同驱替气体的最小混相压力(MMP)。结果表明,随着驱替气体压力的升高,气相的密度逐渐增大,油相膨胀密度降低,气相与油相的混合程度增强,油气两相界面厚度增加,界面张力随之减小。同时发现,驱替相中二氧化碳浓度越高,在同等气体压力下,油气界面更厚,油气混合程度更高。纯CO₂驱油得到的MMP远远小于纯N₂驱油,当这两种气体摩尔比为1 : 1混合时MMP介于两种纯气体之间,说明要达到同样的驱油效果二氧化碳需要的压力更小。最后,本文从分子微观作用力角度解释了驱替气体不同时影响油气混相程度的机制,通过分子平均作用势曲线发现油相分子对CO₂的吸引力要大于N₂分子,因此CO₂分子更容易与油相混合,驱替效果更明显。     

Amorphous Carbon Film with Self-modified Carbon Nanoparticles Synthesized by Low Temperature Carbonization of Phenolic Resin for Simultaneous Sensing of Dopamine and Uric Acid

A self-modified film electrode consisting of homogeneous snowflake-shaped nanoparticles on the amorphous carbon substrate (HNAC) was prepared by low temperature carbonization of phenolic resin. Such a unique structure was beneficial to enhance the electroanalysis signal responds. Simultaneous detection of DA and UA was performed on the HNAC using differential pulse voltammetry (DPV) at pH 8 phosphate buffer. The well-defined oxidation peak potential separation reached 260 mV between DA and UA. Meanwhile, the detection limit of HNAC were 0.401 μM (DA) and 2.800 μM (UA).     

Photonic generation of a millimeter-wave signal based on sextuple-frequency multiplication

A millimeter-wave signal with sextuple-frequency multiplication of a microwave source is obtained with two cascaded optical modulators, which are driven by the same microwave source with phase deviation of pi/2 introduced by an electrical phase shifter. Without any optical filter, a wideband continuously tunable millimeter-wave signal is easily generated.     

Mixing of Racemic Poly(L-lactide)/Poly(D-lactide) Blend with Miscible Poly(D,L-lactide):Toward All Stereocomplex-type Polylactide with Strikingly Enhanced SC Crystallizability

Stereocomplex-type polylactide (SC-PLA) consisting of alternatively arranged poly(L-lactide) (PLLA) and poly(D-lactide) (PDLA) chains has gained a good reputation as a sustainable engineering plastic with outstanding heat resistance and durability,however its practical applications have been considerably hindered by the weak SC crystallizability.Current methods used to enhance the SC crystallizability are generally achieved at the expense of the precious bio-renewability and/or bio-degradability of PLAs.Herein,we demonstrate a feasible method to address these challenges by incorporating small amounts of poly(D,L-lactide) (PDLLA) into linear high-molecular-weight PLLA/PDLA blends.The results show that the incorporation of the atactic PDLLA leads to a significant enhancement in the SC crystallizability because its good miscibility with the isotactic PLAs makes it possible to greatly improve the chain mixing between PLLA and PDLA as an effective compatibilizer.Meanwhile,the melt stability (i.e.,the stability of PLLA/PDLA chain assemblies upon melting) could also be improved substantially.Very intriguingly,SC crystallites are predominantly formed with increasing content and molecular weight of PDLLA.More notably,exclusive SC crystallization can be obtained in the racemic blends with 20 wt％ PDLLA having weight-average molecular weight of above 1 ×10s g/mol,where the chain mixing level and intermolecular interactions between the PLA enantiomers could be strikingly enhanced.Overall,our work could not only open a promising horizon for the development of all SC-PLA-based engineering plastic with exceptional SC crystallizability but also give a fundamental insight into the crucial role of PDLLA in improving the SC crystallizability of PLLA/PDLA blends.     

Improved electrochemical performance of LiNi0.5Mn1.5O4 as cathode of lithium ion battery by Co and Cr co-doping

Three samples, LiNi_0.5Mn_1.5O₄, LiNi_0.4Mn_1.4Co_0.2O₄, and LiNi_0.4Mn_1.4Cr_0.15Co_0.05O₄, were prepared by sol–gel method and characterized by powder X-ray diffraction, Fourier transformed infrared spectroscope, scanning electron microscopy, Brunauer–Emmett–Teller surface area, four-probe resistance, cyclic voltammetry, electrochemical impedance spectroscopy, and charge–discharge test. It is found that the co-doped sample LiNi_0.4Mn_1.4Cr_0.15Co_0.05O₄ exhibits an improved performance compared with the Co-doped sample LiNi_0.4Mn_1.4Co_0.2O₄ and the undoped sample LiNi_0.5Mn_1.5O₄, especially at elevated temperature. At 25 °C, the discharge capacity of LiNi_0.4Mn_1.4Cr_0.15Co_0.05O₄ is 130 mAh g^?1 at 0.1 C and 103 mAh g^?1 at 10 C. At an elevated temperature (55 °C), its 1 C discharge capacity is 136 mAh g^?1 and maintains 95.6 % of its initial capacity after 100 cycles. Compared with the reported results of LiNi_0.4Mn_1.4Co_0.2O₄ and LiNi_0.475Mn_1.475Co_0.05O₄, the co-doped sample LiNi_0.4Mn_1.4Cr_0.15Co_0.05O₄, with least content of Co, 0.05, possesses not only the high C-rate capacity but also the structural stability. The mechanism on the electrochemical performance improvement of LiNi_0.5Mn_1.5O₄ by the co-doping was discussed.     

An Unexpected Fluctuating Reactivity for Odd and Even Carbon Numbers in the TiO2‐Based Photocatalytic Decarboxylation of C2‐C6 Dicarboxylic Acids

The degradation behaviours of five straight‐chain dicarboxylic acids (from ethanedioic acid to hexanedioic acid) were compared in aqueous TiO₂‐based photocatalysis. When all other conditions were identical, the degradation rates were found to fluctuate regularly with the parity of the number of carbon atoms. Dicarboxylic acids with an even number of carbon atoms (e‐DAs) always degraded more slowly than those acids with an odd number of carbon atoms (o‐DAs). This unusual fluctuation in the reactivity for the degradation of dicarboxylic acids by TiO₂‐based photocatalysis is very closely related to the different pre‐coordination modes of the acids with the photocatalyst. Attenuated total reflection FTIR (ATR‐FTIR) of e‐DAs labelled with ¹³C showed that both carboxyl groups of the acid coordinate to TiO₂ through bidentate chelating forms. In contrast, only one carboxyl group of the o‐DAs coordinated to TiO₂ in a bidentate chelating manner, whereas the other formed a monodentate binding linkage. The bidentate chelating form with bilateral symmetric coordination did not favour degradation. Isotope‐labelling experiments were performed with ¹⁸O₂ to observe the different ways in which incorporated oxygen entered the initial decarboxylated products of e‐ and o‐DAs. For the degradation of butanedioic acid, (45.9±0.5) % of the oxygen in the formed propanedioic acid came from H₂O, whereas for pentanedioic acid, (97.4±0.2) % of the oxygen in the formed butanedioic acid came from H₂O. Our results demonstrate that in TiO₂‐based photocatalysis, the reactivity of active species, such as ^. OH/h_vb⁺, is far from non‐selective and that the attacks of these active species on organic substrates are significantly affected by the coordination patterns of the substrates on the TiO₂ surface.     

Synthesis of Site‐Specifically Phosphate‐Caged siRNAs and Evaluation of Their RNAi Activity and Stability

A complete set of new photolabile nucleoside phosphoramidites were synthesized, then site‐specifically incorporated into sense or antisense strands of siRNA for phosphate caging. Single caging modification was made along siRNA strands and their photomodulation of gene silencing were examined by using the firefly luciferase reporter gene. Several key phosphate positions were then identified. Furthermore, multiple caging modifications at these key positions led to significantly enhanced photomodulation of gene silencing activity, suggesting a synergistic effect. The caging group on both the terminally phosphate‐caged siRNA and the single‐stranded caged RNA has comparatively high stability, whereas hydrolysis of the caged group from the internally caged siRNA was observed, irrespective of the presence of Mg²⁺. Molecular dynamic simulations demonstrated that enhanced hydrolysis of the caging group on internally phosphate‐caged siRNAs was due to easy fragmentation of the caging group upon formation of the pentavalent intermediate of the phosphotriester with attack by water. The caging group in the terminally phosphate‐caged siRNA or single‐stranded caged RNA prefers to form π–π stacks with nearby nucleobases. In addition to providing explanations for previous observations, this study sheds further light on the design of caged oligonucleotides and indicates the direction of future development of nucleic acid drugs with phosphate modifications.