Superfield form of discrete gauge states in ĉ = 1 2d supergravity

A general formula for the discrete states (NeveuSchwarz sector) in N = 1 2D super-Liouville theory is written down in the world-sheet supersymmetric form. We then derive a set of gauge states at the discrete momenta. These discrete gauge states are shown to carry the ω_∞ charges and serve as the symmetry parameters in the old covariant quantization of the theory.     

A possibility of parallel and anti-parallel diffraction measurements on neutron diffractometer employing bent perfect crystal monochromator at the monochromatic focusing condition

In a conventional diffractometer having single monochromator, only one position, parallel position, is used for the diffraction experiment (i.e. detection) because the resolution property of the other one, anti-parallel position, is very poor. However, a bent perfect crystal (BPC) monochromator at monochromatic focusing condition can provide a quite flat and equal resolution property at both parallel and anti-parallel positions and thus one can have a chance to use both sides for the diffraction experiment. From the data of the FWHM and the Δd/d measured on three diffraction geometries (symmetric, asymmetric compression and asymmetric expansion), we can conclude that the simultaneous diffraction measurement in both parallel and anti-parallel positions can be achieved.     

Generation of 0.2-TW 5.5-fs optical pulses at 1 kHz using a differentially pumped hollow-fiber chirped-mirror compressor

Optical pulses with 1.1-mJ energy and 5.5-fs duration have been generated at 1-kHz repetition rate from a chirped pulse amplification Ti:Sapphire laser incorporating a differentially pumped hollow-fiber chirped-mirror compressor. The effects of self-focusing and multi-photon ionization during the beam propagation were minimized by differentially pumping the hollow fiber filled with neon. The spectral broadening at the hollow-fiber compressor was optimized by adjusting gas pressure, laser intensity, and laser chirp, covering from 540 nm to 950 nm. PACS 42.65.Jx; 42.65.Re     

Strong Diffie-Hellman-DSA Key Exchange

To provide authentication to the Diffie-Hellman key exchange, a few integrated key exchange schemes which provide authentication using the DSA signature have been proposed in the literature. In this letter we point out that all of the previous Diffie-Hellman-DSA schemes do not provide security against session state reveal attacks. We also suggest a strong Diffie-Hellman-DSA scheme providing security against session state reveal attacks as well as forward secrecy and key independence     

Design,Implementation, and Validation of KOMPSAT‐2 Software Simulator

In this paper, we present design features, implementation, and validation of a satellite simulator subsystem for the Korea Multi‐Purpose Satellite‐2 (KOMPSAT‐2). The satellite simulator subsystem is implemented on a personal computer to minimize costs and trouble on embedding onboard flight software into the simulator. An object‐oriented design methodology is employed to maximize software reusability. Also, instead of a high‐cost commercial database, XML is used for the manipulation of spacecraft characteristics data, telecommand, telemetry, and simulation data. The KOMPSAT‐2 satellite simulator subsystem is validated by various simulations for autonomous onboard launch and early orbit phase operations, anomaly operation, and science fine mode operation. It is also officially verified by successfully passing various tests such as the satellite simulator subsystem test, mission control element system integration test, interface test, site installation test, and acceptance test.     

A novel ultracompact two-mode-interference wavelength division multiplexer for 1.5-/spl mu/m operation

A novel ultracompact 2/spl times/2 wavelength division multiplexer (WDM) for 1.55-/spl mu/m operation based on highly dispersive two-mode interference (TMI) was designed, theoretically modeled, and verified using a finite-difference-time-domain (FDTD) method. A two-moded waveguide assisted with a dispersive tooth-shaped grating provided a mode-dependent reflection band of central wavelength at 1.55 /spl mu/m. The wavelengths of 1538 and 1572 nm that were at the band edges and had the lowest reflection losses and relatively high dispersion were selected for wavelength multiplexing. The result showed that the wavelengths were separated by grating dispersion in a coupler length of 75 /spl mu/m which was much shorter than the required length of 1.1 mm in a regular TMI multiplexer of no grating. Insertion loss of about 1.7 dB and channel contrast of about 12 dB were achieved.     

“Slow” active control of combustion instabilities by modification of liquid fuel spray properties

This paper describes an experimental investigation of the feasibility of using “slow” active control approaches, which “instantaneously” change liquid fuel spray properties, to suppress combustion instabilities. The objective of this control approach was to break up the feedback between the combustion process heat release and combustor pressure oscillations that drive the instability by changing the characteristics of the combustion process (e.g., the characteristic combustion time). To demonstrate the feasibility of such control, this study used a proprietary fuel injector (Nanomiser^TM), which can vary its fuel spray properties, to investigate the dependence of acoustics–combustion process coupling, i.e., the driving of combustion instabilities, upon the fuel spray properties. This study showed that by changing the spray characteristics it is possible to significantly damp combustion instabilities. Furthermore, using combustion zone chemiluminescence distributions, which were obtained by Abel’s deconvolution synchronized with measured acoustic data, it has been shown that the instabilities were mostly driven midway between the combustor centerline and wall, a short distance downstream from the flame holder, where the mean axial flow velocity is approximately zero in the vortex near the flame holder. The results of this study strongly suggest that a “slow” active control system that employs controllable fuel injectors could be effectively used to prevent the onset of detrimental combustion instabilities.     

Stability control of the electrooptic effect with new maleimide copolymers containing photoreactive tricyanopyrrolidene‐based chromophores

New photocrosslinkable maleimide copolymers have been synthesized by the attachment of a tricyanopyrrolidene‐based chromophore. The 2‐(3‐cyano‐4‐(2‐{4‐[hexyl‐(6‐hydroxy‐hexyl)‐amino]‐phenyl}‐vinyl)‐5‐oxo‐1‐{4‐[4‐(3‐oxo‐3‐phenyl‐propenyl)‐ phenoxy]‐butyl}‐1,5‐dihydro‐pyrrol‐2‐ylidene)‐malononitrile chromophore exhibits nonlinear optical activity and contains a chalcone moiety that is sensitive to UV light (λ = 330–360 nm) for crosslink formation. The maleimide monomers have also been functionalized with chalcone moieties. The resultant copolymers exhibit great processability, and one of them shows a maximum electrooptic coefficient of 90 pm/V at 1300 nm. We could control the thermal stability of the electrooptic coefficient with the newly synthesized photoreactive copolymers successfully. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 531–542, 2007     

Bio-Plasmonics: Nano/micro Structure of Surface Plasmon Resonance Devices for Biomedicine

We have reported a novel design of surface plasmon resonance (SPR) device, which uses alternating dielectric layers to enhance the SPR signal quality and modulate its resonant position. Admittance loci method of thin film design has been used in the design of such a device. The use of biomolecular thin film, such as DNAs or Porteins, in this design can result in resonant condition of wavelength changes as well. Bio-plasmonics is proposed for the research and development of novel devices, which use biomolecules as a part of the plasmon oscillation system to actively interact with nano/micro structure.