Whitening of sidelobe powers by pattern switching in radar array antenna

Presented here is a concept for nearly eliminating bias errors in reflectivity and velocity estimates due to power received through antenna sidelobes of pulse Doppler radars. The antenna pattern is switched from pulse to paise among specially designed patterns, with near identical main lobes, but with sidelobes having randomly distributed phases and amplitudes. The sidelobe signal then becomes incoherent without affecting the coherency of the main lobe signal. The whitened sidelobe signal does not bias the mean velocity estimate computed by Doppler processing, and an unbiased estimate of reflectivity can be computed with the knowledge of the mean whitened power level. Pattern design criteria and a method for the design of optimum patterns are developed for a linear array. The extent of sidelobe reduction by way of whitening has been studied in detail for special case of only two patterns switched randomly using a pseudonoise sequence. Pattern switching realizes an effectively low sidelobe pattern without sacrifice of main lobe resolution. A possible extension to two-dimensional arrays is suggested.     

The effect of secondary scattering on the induced current in a longwire over an imperfect ground from an incident EMP

The effect of secondary scattering that is produced by the induced current in an infinitely long, finitely conducting wire over a plane, finitely conducting earth from an incident electromagnetic pulse is investigated. This is accomplished by finding the field of a Hertzian dipole over the earth and identifying the part that is due to secondary scattering. Frequency-domain results for the overall induced current require that certain infinite integrals be numerically evaluated. Fourier inversion to the time domain in turn requires the numerical evaluation of another infinite integral. When the results are compared to those obtained when secondary scattering is ignored, it is found that secondary scattering slightly increases the current for the case of broadside incidence and reduces it for the case of grazing incidence by as much as two orders of magnitude. Peak currents are much smaller than previously thought. These general results hold for all of the earth parameters that were used in the study     

Power-dependent dispersion in far-off-resonant raman scattering

We investigate the saturation effects of power broadening, Stark shifting, and population transfer on Stokes conversion in stimulated Raman scattering. We do not make the usual rotating wave approximation because the detuning from the next electronic state is assumed to be in the optical regime. Retaining the counter-rotating terms allows an exact determination of the pump and Stokes indexes of refraction. Steady-state solutions for the Stokes intensity and phase are obtained and the effects of making the rotating wave approximation (RWA) are discussed. Finally, we examine the behavior of these solutions for Stokes conversion in hydrogen gas when geometric propagation is appropriate.     

Franck-Condon factors and relative strengths of the c1Σu → α1Δg,c1Σu → X3Σg electronic transitions in the O2 molecule

Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 54, No. 1, pp. 46–50, January, 1991.     

Determination of trace levels of diosmin in a pharmaceutical preparation by adsorptive stripping voltammetry at a glassy carbon electrode.

A systematic study on the electrochemical behavior of diosmin in Britton-Robinson buffer (pH 2.0-10.0) at a glassy carbon electrode (GCE) was made. The oxidation process of the drug was found to be quasi-reversible with an adsorption-controlled step. The adsorption stripping response was evaluated with respect to various experimental conditions, such as the pH of the supporting electrolyte, the accumulation potential and the accumulation time. The observed anodic peak current at +0.73 V vs. Ag/AgCl reference electrode increased linearly over two orders of magnitude from 5.0x10(-8) M to 9.0x10(-6) M. A limit of detection down to 3.5x10(-8) M of diosmin at the GCE was achieved with a mean recovery of 97+/-2.1%. Based on the electrochemical data, an open-circuit accumulation step in a stirred sample solution of BR at pH 3.0 was developed. The proposed method was successfully applied to the determination of the drug in pharmaceutical formulations. The results compared favorably with the data obtained via spectrophotometric and HPLC methods.     

Continuous phase quadrature phase shift keyed signaling techniquewith coding

A continuous phase quadrature phase shift keyed (CPQPSK) modulation technique is presented. This method utilizes a conventional QPSK modulator and a phase trajectory converter to approximate M=4, h=1/4 continuous phase signal and allows low cost, low complexity, and high rate (>1 Gbit/s) CPM modem implementation for bandwidth efficient transmission through nonlinear satellite channels. Using a communications analysis computer program it has been found that CPQPSK has 99 percent out-of-band power of 0.8R (MSK has 99 percent out-of-band power of 1.2 R where R is defined as bit rate), continuous phase trajectories, and nearly constant envelope amplitude. Simulation of realistic hardware designs indicate that the CPQPSK will require an Eb/No of 14 dB to achieve a bit error rate (BER) of 10^-6. Forward error correcting techniques using block codes with an overhead of 10 percent indicate that the Eb/No requirements can be reduced to 11.2 dB for 10^-6 BER     

Efficient computation of natural convection in a concentric annulus between an outer square cylinder and an inner circular cylinder

In this work, the natural convection in a concentric annulus between a cold outer square cylinder and a heated inner circular cylinder is simulated using the differential quadrature (DQ) method. The vorticity‐stream function formulation is used as the governing equation, and the coordinate transformation technique is introduced in the DQ computation. It is shown in this paper that the outer square boundary can be approximated by a super elliptic function. As a result, the coordinate transformation from the physical domain to the computational domain is set up by an analytical expression, and all the geometrical parameters can be computed exactly. Numerical results for Rayleigh numbers range from 104 to 106 and aspect ratios between 1.67 and 5.0 are presented, which are in a good agreement with available data in the literature. It is found that both the aspect ratio and the Rayleigh number are critical to the patterns of flow and thermal fields. The present study suggests that a critical aspect ratio may exist at high Rayleigh number to distinguish the flow and thermal patterns. Copyright © 2002 John Wiley & Sons, Ltd.     

Half-bridge inverter using 4H-SiC gate turn-off thyristors

This paper reports on the first demonstration of a half-bridge power inverter constructed from silicon carbide gate turn-off thyristors (GTOs) operated in the conventional GTO mode. This circuit was characterized with input bus voltages of up to 600 VDC and 2 A (peak current density of 540 A/cm²) with resistive loads using a pulse-width modulated switching frequency of 2 kHz. We discuss the implications of the thyristor's electrical characteristics and the circuit topology on the overall operation of the half-bridge circuit. This work has determined the conservative critical rate of rise value of the off-state voltage to be 200 V/μs in these devices