ASON实际组网中架构及演进方式分析

对在实际组网中选择合理的ASON架构和保护方式作了相应分析，并为搭建可向ASON平滑演进的传统网络时需注意的问题提供了参考意见，     

Data-efficient blind OFDM channel estimation using receiver diversity

We investigate non data-aided channel estimation for cyclically prefixed orthogonal frequency division multiplexing (OFDM) systems. By exploiting channel diversity using only two receive antennas, a blind deterministic algorithm is proposed. Identifiability conditions are derived that guarantee the perfect channel retrieval in the absence of noise. In the presence of noise, the proposed method has the desired property of being data efficient-only a single OFDM block is needed to achieve good estimation performance for a wide range of SNR values. The algorithm is also robust to input symbols as it does not have any restriction on the input symbols with regard to their constellation or their statistical properties. In addition, this diversity-based algorithm is computationally efficient, and its performance compares favorably to most existing blind algorithms.     

Hf-doped and NH/sub 3/-nitrided high-K gate dielectric thin film with least drain current degradation and flatband voltage shift

A novel technique to form high-K dielectric of HfSiON by doping base oxide with Hf and nitridation with NH/sub 3/, sequentially, is proposed. The HfSiON gate dielectric demonstrates excellent device performances such as only 10% degradation of saturation drain current and almost 45 times of magnitude reduction in gate leakage compared with conventional SiO/sub 2/ gate at the approximately same equivalent oxide thickness. Additionally, negligible flatband voltage shift is achieved with this technique. Time-dependent dielectric breakdown tests indicate that the lifetime of HfSiON is longer than 10 years at V/sub dd/=2 V.     

Improvement of AlGaInP light emitting diode by sulfide passivation

The brightness of AlGaInP light emitting diodes (LEDs) has been raised by a factor of 1.12 at 20 mA by sulfide passivation. Meanwhile, the sulfide also can decrease leakage current of AlGaInP LEDs at -2 V to nearly one thousandth of that in the as-fabricated device. The possible causes for the brightness increase of AlGaInP LEDs after sulfide treatment including surface roughness, reduction of Fresnel loss, and effective injection of carriers were demonstrated.     

Ripple: a wireless token-passing protocol for multi-hop wireless mesh networks

This work presents a wireless token-passing protocol, named Ripple, for wireless mesh networks (WMNs). In contrast to existing random-access approaches, Ripple uses a decentralized controlled-access approach to protect nodes from unintentional packet collisions and maximize the spatial reuse. The performance of Ripple under an error-free wireless channel was investigated and the accuracy of the analysis was verified by simulation. Simulation results also indicated that Ripple achieved throughput, stability, and QoS enhancement than that of 802.11 DCF under a highly loaded situation.     

异步DS-CDMA系统中基于矩阵点除算法的DOA估计

针对异步DS-CDMA系统中的多用户环境,本文提出了一种低复杂度的DOA估计算法——矩阵点除算法。该算法通过对感兴趣信息的逐次分离,实现了DOA的逐路径估计。算法具有两方面显著优势:(1)克服了传统的DOA估计算法在路径总数大于天线阵元数时不能工作这一缺陷:(2)避免了计算复杂的特征值分解运算,大大降低了算法复杂度。仿真实验验证了算法的有效性。     

基于EDGE系统信道估计实现方案的研究

研究了基于ＥＤＧＥ系统接收机中信道估计的实现方案，并对算法的各项性能做出评估。首先论述了算法的采用及其理论依据。接着，说明了信道预估计的原理及方法。最后，针对ＭＡＴ－ＬＡＢ及 ＤＳＰ上的仿真结果，比较了各项系数对于系统性能改善所具有的影响和作用，对系统特性作了较为详细的分析总结。     

氢化丁苯共聚物结构的核磁共振波谱表征Ⅱ.微观结构的定量计算

在氢化丁苯共聚物¹³C-NMR谱脂肪碳部分谱带归属的基础上,根据各谱带的主要来源,推导出六个二单元浓度的计算公式。计算出二单元、一单元的相对含量,各结构单元的数均序列长度、嵌段含量和其它结构参数。加氢前后的¹H-和¹³C-NMR谱的组成计算结果基本一致。初步探讨了作为粘度指数改进剂的氢化丁苯共聚物微观结构与性能的关系,为合成提供了依据。     

A medium-access control protocol for a cellular packet CDMAcarrying multirate traffic

We propose and evaluate a medium-access control (MAC) protocol for synchronous cellular packet direct-sequence code-division multiple-access (DS/CDMA). The protocol is designed for handling a variety of multimedia traffic types in an integrated wireless-access network (IWAN). For instance, the protocol is suited for carrying multiple traffic types of different priorities. An analytical model for the equilibrium state has been developed for the proposed protocol. A comparative evaluation of the protocol is done for three different radio frequency bandwidths currently under consideration for personal communication services (PCS), i.e., 1.25 MHz, 5 MHz, and 10 MHz. Our results demonstrate that the proposed protocol is both robust and flexible for the intended IWAN applications. It offers a significant multiplexing gain as the bandwidth increases     

Fabrication of 1.55 μm VCSELs on Si using metallic bonding

Using AuGeNiCr multilayered metals as the wafer bonding medium, long-wavelength GaInAsP/InP vertical cavity surface emitting lasers employing Al-oxide/Si as the upper and lower distributed Bragg reflectors were fabricated on Si substrate with the bonding interface formed outside the vertical cavity surface emitting laser cavity. Laser emission at 1.545 μm was measured under pulsed operations near room temperature. The low-temperature metallic bonding process demonstrates a great potential in device fabrication