A 0.25-/spl mu/m CMOS quad-band GSM RF transceiver using an efficient LO frequency plan

This paper describes a single-chip CMOS quad-band (850/900/1800/1900 MHz) RF transceiver for GSM/GPRS applications. It is the most important design issue to maximize resource sharing and reuse in designing the multiband transceivers. In particular, reducing the number of voltage-controlled oscillators (VCOs) required for local oscillator (LO) frequency generation is very important because the VCO and phase-locked loop (PLL) circuits occupy a relatively large area. We propose a quad-band GSM transceiver architecture that employs a direct conversion receiver and an offset PLL transmitter, which requires only one VCO/PLL to generate LO signals by using an efficient LO frequency plan. In the receive path, four separate LNAs are used for each band, and two down-conversion mixers are used, one for the low bands (850/900 MHz) and the other for the high bands (1800/1900 MHz). A receiver baseband circuit is shared for all four bands because all of their channel spaces are the same. In the transmit path, most of the building blocks of the offset PLL, including a TX VCO and IF filters, are integrated. The quad-band GSM transceiver that was implemented in 0.25-/spl mu/m CMOS technology has a size of 3.3/spl times/3.2 mm/sup 2/, including its pad area. From the experimental results, we found that the receiver provides a maximum noise figure of 2.9 dB and a minimum IIP3 of -13.2dBm for the EGSM 900 band. The transmitter shows an rms phase error of 1.4/spl deg/ and meets the GSM spectral mask specification. The prototype chip consumes 56 and 58 mA at 2.8 V in the RX and TX modes, respectively.     

Fast optical switching in Sm/sup 3+/-doped fibers

We report an experimental investigation of the fast optical switching in a Sm/sup 3+/-doped fiber. We discovered that this fiber can effect a fast switching speed less than 5 ns. However, the required switching power is 472 W with pulsewidth 10 ns.     

Performance analysis of an improved MMSE multiuser receiver formismatched delay channels

Motivated by the fact that time delays in a practical direct-sequence code-division multiple-access (DS-CDMA) system can never be perfectly estimated, an improved minimum-mean squared-error (MMSE)-based receiver is proposed and analyzed. Via the simple assumption of a probability distribution for the delay estimation errors, the proposed receiver can achieve a performance superior to that of the conventional MMSE (CMMSE) receiver. The performances of this improved receiver and the CMMSE receiver are compared in terms of the mean squared error (MSE), probability of error, and asymptotic multiuser efficiency (AME). As the original definition of AME does not consider mismatched channels, the behavior of three single-user receivers bearing imperfect delay estimation is also investigated. These single-user receivers are employed to define a more appropriate AME. Finally, an efficient update mechanism to accommodate dynamic channel statistics, and thus practical implementation, is proposed     

High speed p-type SiGe modulation-doped field-effect transistors

We report on the fabrication and characterization of high-speed p-type modulation-doped field-effect transistors (MODFETs) with 0.7-μm and 1-μm gate-lengths having unity current-gain cut-off frequencies (f_T) of 9.5 GHz and 5.3 GHz, respectively. The devices were fabricated on a high hole mobility SiGe heterostructure grown by ultra-high-vacuum chemical vapor deposition (UHV-CVD). The dc maximum extrinsic transconductance (g_m) is 105 mS/mm (205 mS/mm) at room temperature (77 K) for the 0.7-μm gate length devices. The fabricated devices show good pinch-off characteristics and have a very low gate leakage current of a few μA/mm at room temperature and a few nA/mm at 77 K     

Observation of spontaneous pattern with six-fold symmetry in disk-shaped ZnO complex microstructures

Using a simple vapor phase transport technique, we have fabricated unique complex disk-shaped ZnO microstructures comprising a small disk coaxially grown on a large one and observed spatially perfect six-fold symmetric patterns. The observed results can be explained based on the spontaneous nanoindentation (NI) effect under the geometric constraints and the explanation can be extended to fathom the growth mechanism of other highly symmetrical ZnO nanostructures. Our results indicate that NI not only can elucidate the mechanical properties of surfaces and thin films but also is an effective approach to fabricate ordered nanostructures with high precision on the location of the building blocks. PACS 81.16.Rf; 81.07.-b; 81.05.Dz     

On the Zero-Energy-Limit Solution for the Modified Gross–Pitaevskii Equation

The modified Gross–Pitaevskii equation was derived and solved to obtain the 1D solution in the zero-energy limit. This stationary solution could account for the dominated contributions due to the kinetic effect as well as the chemical potential in inhomogeneous Bose gases.     

Profile dependence and measurement of absolute Raman scattering cross-section in optical fibres

A simple measurement method for the absolute Raman scattering cross-section of an optical fibre is presented. This method does not require a high power pump laser and it measures the fibre directly. It is also shown that the calculation of the cross-section depends on the fibre structure, such as its refractive index profile and the differential attenuation between the pump wavelength and Raman wavelength.<>     

Self-Consistent Effects on the Starting Current of Gyrotron Oscillators

Self-consistent effects on the starting current of gyrotron oscillators are examined. Field profiles in the open cavity are shown to be sensitive to the interaction dynamics. This can either significantly raise or lower the oscillation threshold, particularly for the low-Q modes. The transition from resonant-mode oscillations at the low magnetic field to backward-wave oscillations at the high magnetic field is demonstrated.     

Positively Thermo‐Sensitive Monodisperse Core–Shell Microspheres

In this paper, we report on a novel family of monodisperse thermo‐sensitive core–shell hydrogel microspheres that is featured with high monodispersity and positively thermo‐responsive volume phase transition characteristics with tunable swelling kinetics, i.e., the particle swelling is induced by an increase rather than a decrease in temperature. The microspheres were fabricated in a three‐step process. In the first step, monodisperse poly(acrylamide‐co‐styrene) seeds were prepared by emulsifier‐free emulsion polymerization. In the second step, poly(acrylamide) or poly[acrylamide‐co‐(butyl methacrylate)] shells were fabricated on the microsphere seeds by free radical polymerization. In the third step, the core–shell microspheres with poly‐ (acrylamide)/poly(acrylic acid) based interpenetrating polymer network (IPN) shells were finished by a method of sequential IPN synthesis. The proposed monodisperse core–shell microspheres provide a new mode of the phase transition behavior for thermo‐sensitive “smart” or “intelligent” monodisperse micro‐actuators that is highly attractive for targeting drug delivery systems, chemical separations, sensors, and so on.     

距离Cigar域与拟共形映射

设f：R^n→R^n是一同胚，本文证明了f是拟共形映射的充要条件是f将R^n中的任一距离Cigar域映成R^n中的距离Cigar域．