Lamellar Organo-Bridged Silicones

The acid-hydrolysis of an organo-bridged bisdiethoxysilylated molecular precursor bearing urea groups, (EtO)₂MeSi(CH₂)₃NHCONH(CH₂)₁₂NHCONH(CH₂)₃SiMe(OEt)₂, has been performed in pure aqueous medium. Scanning electron microscopy (SEM) analysis of the resulting insoluble solid revealed plate-like forms with a lamellar structure as determined by powder X-ray diffraction (PXRD) studies with a sharp peak at 28.5 Å. The solid state ²⁹Si MAS-NMR spectrum of this bridged siloxane hybrid is consistent with a moderately condensed material with complete preservation of the Si–C bonds throughout the hybrid network. In comparison, the classical sol–gel hydrolysis-condensation of the molecular precursor in ethanol with stoichiometric amount of water and fluoride anion as catalyst produced an amorphous featureless solid.     

ABS blends with phenoxy: morphology,thermal, mechanical and rheological properties

Blends of ABS (acrylonitrile–butadiene–styrene) with phenoxy(poly(hydroxyether bisphenol A)) were prepared using a Branender single screw extruder. Scanning and transmission electron micrographs (SEM, TEM) showed a typical two-phase morphology; particle-in-matrix (90/10) (ABS/phenoxy by weight), 70/30, 10/90), island/sea (30/70) and co-continuous (50/50) morphologies. The glass transition temperature (T_g) of SAN was almost unchanged in the blends, while the T_g of phenoxy increased by about 5 °C in the blends. The synergistic effect of tensile modulus and strength was noted in ABS-rich blends, where a drastic drop of ductility was seen, and the results were interpreted in terms of rubber particle migration form SAN to phenoxy phase, which was visualized by TEM. Melt viscosity showed yield in ABS-rich blends, and generally followed the log additivity.     

乙基罗丹明B与大豆甙的显色反应及其应用研究

在 p H1 0 .5的 NH3- NH4 Cl缓冲溶液中 ,在聚乙烯醇存在下 ,乙基罗丹明 B与大豆甙形成 1∶ 1有色缔合物。其最大吸收波长为 5 65 nm,表观摩尔吸光系数为2 .0 1× 1 0 4 L· mol- 1· cm- 1,大豆甙在 1 .6～ 6.2 mg/L范围内符合比耳定律。方法用于大豆提取液中大豆异黄酮甙的测定 ,结果满意     

The exterior Dirichlet problem for quasi-linear elliptic equations with small boundary data

It is shown that if the order of non-uniformity of a quasi-linear elliptic equation is h,10,2(h–1)/h norm. For 0h1,existence of a bounded solution is guaranteed without any smallness assumption on the given boundary data.More precise information is given for the special case of the minimal surface equation.     

Synthesis and Characterization of Tetraosmium Carbonyl Complexes Containing a Bridging CO2 Ligand

Treatment of (thd)H (thd=2,2,6,6-tetramethyl-3,5-heptandionate) with excess Os₃(CO)₁₂ in an autoclave at 180°C gives the formation of a brown metal chain complex [Os₂(CO)₅(thd)₂]₂ (1) and a yellow CO₂ cluster complex [Os₄(-H)(-CO₂)(thd)(CO)₁₃] (2) in low yields. Complex 2 was fully identified by a combination of spectroscopic methods and X-ray diffraction study, showing a unique CO₂ ligand bridging a triosmium metal fragment, Os₃(-H)(CO)₁₀ and a monometallic osmium fragment, Os(CO)₃(thd). Upon treatment of 1 with Me₃NO at an elevated temperature, oxidation of the CO ligand occurred at the position trans to the unique CO₂ ligand on the Os(CO)₃(thd) fragment, giving the formation of a second CO₂ cluster [Os₄(-H)(-CO₂)(thd)(CO)₁₂(NCMe)] (3), which is stabilized by a weakly coordinated acetonitrile molecule.     

Electrochemical study on the keto-enol tautomerization of p-hydroxyphenylpyruvic acid in aqueous solution

The keto-enol tautomerization of p-hydroxyphenylpyruvic acid (pHPP) in aqueous solutions and the complexation reaction between enolic pHPP and boric acid have been studied by electrochemical techniques including linear sweep voltammetry (LSV), pulse voltammetry, and cyclic voltammetry (CV), combining with UV spectrometry. Electrochemical techniques reveal that in aqueous solution, there are two tautomers of pHPP: enolic form and ketonic form; the former exists mainly in freshly prepared pHPP solution, and the latter exists mainly in equilibrium solution. Both enolic and ketonic pHPP are electroactive. The electrochemical oxidation of enolic pHPP gives rise to two anodic waves, I(a) and II(a), while the electrochemical oxidation of ketonic pHPP only results in the observation of the second wave II(a). The oxidation process I(a) is revealed to be associated with the quasi-reversible, two-electron two-proton oxidation of "C=C"group at the side chain of enolic pHPP, and the oxidation process II(a) is proposed to result from the irreversible oxidation of phenolic hydroxyl group. It is observed that in aqueous solution, enolic pHPP can quickly complex with boric acid to yield enol-borate complex that can also oxidize at a glassy carbon electrode to yield an anodic wave.     

Comparison of triel bonds with different chalcogen electron donors: Its dependence on triel donor and methyl substitution

The complexes between R₃Tr (Tr = B, Al, and Ga; R = H, F, Cl, and Br) and H₂X (X = O, S, and Se) were theoretically studied. The interaction energies of R₃Al⋯H₂X and R₃Ga⋯H₂X are consistent with the electronegativity of the halogen atom R (R ≠ H), but an opposite dependence is found for R₃B⋯H₂X. The triel bond of R₃Tr⋯H₂X is weaker for the heavier chalcogen donor. The dependence of triel bonding strength on the triel atom is complicated, depending on the nature of R and X. The methyl substitution of H₂X causes a substantial increase in the interaction energy from −5.74 kcal/mol to −22.88 kcal/mol, and its effect is relevant to the nature of Tr, X, and R groups. For the S and Se donors, the increased percentage of interaction energy is almost the same due to the methyl substitution, which is larger than that of the O analogue. In most triel-bonded complexes, electrostatic dominates and polarization has comparable contribution. However, polarization plays a dominant role in R₃B⋯ and R₃B⋯ (R = Cl and Br; R′ = H and Me).     

冰晶石-氧化铝熔体结构的计算机模拟研究

用Monte Carlo法对冰晶石-氧化铝系熔体结构作了计算机模拟研究。结果表明: 熔体中既有含“氧桥”和“氟桥”的“多核”离子集团, 如F3Al-O-AlF_3、F_3Al-AlF_3、F_3Al—F—AlF_3—F等; 也有“单核”离子集团如AlF_5~(2-)、AlOF_3~(2-)等。熔体中还存在较松散的xNa~+·yF~-离子集团。熔体中不存在AlO_2~-或AlO_3~(3-)集团。     

Vapor‐Phase Reaction of Citronellal over Mesoporous Molecular Sieves MCM‐41 and Zeolites

The vapor‐phase reaction of citronellal (CTN) at 220 °C and atmospheric pressure has been studied using mesoporous molecular sieves and zeolites in a fixed‐bed reactor. The primary products included isopulegol (IPG), menthone, and pulegol with subsequent reactions to form cyclic hydrocarbons. The CTN conversion and the product selectivity depend on the acidity and the textural property of catalysts. Lewis and/or Brönsted acid sites are essential for catalyzing this reaction. An increase of SiO₂/Al₂O₃ mol ratio diminishes the acid amount of all catalysts and enhances both the surface area and the structural order of MCM‐41. The catalytic activity follows the order of MCM‐41 > HZSM‐5 > Hβ > USY, in accordance with the relative total acid amount except that of MCM‐41. Despite its low acidity, Si‐MCM‐41 exhibits the best catalytic performance due to its uniform mesopores, large surface area and good stability; the CTN conversion and the IPG yield attain 91.9% and 58.6%, respectively, after at least 25 h time‐on‐stream.     

Determination of medecamycin by adsorptive stripping voltammetry with an activated electrode

The adsorptive and electrochemical behaviors of medecamycin were investigated on a glassy carbon electrode (GCE) pretreated by anodic oxidation at +1.8 V for 5 min in 0.025 mol l^–1 NH₃-NH₄Cl (pH 8.6) solution. An adsorptive stripping voltammetric method for the determination of medecamycin at the pretreated glassy carbon electrode has been developed. Medecamycin was accumulated in NH₃-NH₄Cl buffer (pH 9.0) at a potential of –0.7 V (vs. saturated calomel electrode (SCE)) for a certain time, and then determined by second-order differential anodic stripping voltammetry. The second-order differential anodic stripping peak current at +0.72 V was proportional to the concentration of medecamycin in the range 2.0 g ml^–1 to 50.0 g ml^–1. The detection limit (three times the signal-to-noise) was 1.0 g ml^–1 and the relative standard deviation of the results was 3.28% for eight successive determinations of 10.0 g ml^–1 medecamycin. This method has been applied to the direct determination of medecamycin in commercial tablets and spiked urine samples with satisfactory results.