Personal telecommunication radiation safety and the precautionary principle

The approach to risk management for RF and microwave radiation has been to establish guidelines for maximum permissible levels of exposure. These guidelines are based on evaluations of the relevant scientific literature and, with safety margins to account for uncertainties and gaps in scientific knowledge, offer a significant level of protection against established hazards of RF and microwave radiation for short-term exposures. One can argue, on this basis, that the precautionary principle - specifically, safety factors -have been used to guide the making and promulgation of existing permissible-exposure standards for RF and microwave radiation. Therefore, discussions on the appropriateness of the precautionary principle for RF radiation may be "much ado about nothing". Clearly, this approach to "pre caution" neither has stifled technological development, nor has it helped to enforce the acceptance of zero risk, but it provided a basis for action when science was unable to give a clear answer.     

Graph-theoretic construction of low-density parity-check codes

This article presents a graph-theoretic method for constructing low-density parity-check (LDPC) codes from connected graphs without the requirement of large girth. This method is based on finding a set of paths in a connected graph, which satisfies the constraint that any two paths in the set are either disjoint or cross each other at one and only one vertex. Two trellis-based algorithms for finding these paths are devised. Good LDPC codes of practical lengths are constructed and they perform well with iterative decoding.     

GaN-MOCVD设备反应室流场的CFD数值仿真

采用计算流体力学方法对生长半导体材料GaN的重要设备MOCVD(金属有机物化学气相沉积)反应室中的流场结构进行了三维数值仿真.数值模拟采用基于非交错网格系统的SIMPLE算法,用有限体积方法对控制方程进行离散,并采用改进的压力-速度耦合方法进行求解.数值仿真给出了具有复杂几何结构和运动方式的GaN-MOCVD反应室中的流场结构,研究了改变几何尺寸和运行参数对MOCVD反应室流场结构的影响,对正在试制开发中的MOCVD设备的几何结构的改进和运行参数的优化提出了指导性建议.     

An Analysis of Citation Counts of ETRI‐Invented US Patents

From its foundation until 2004, ETRI has registered over 1,000 US patents. This letter analyzes the characteristics of these patents and addresses the explanatory factors affecting their citation counts. For explanatory variables, research team related variables, invention specific variables, and geographical domain related variables are suggested. Zero‐altered count data models are used to test the impact of independent variables. A key finding is that technological cumulativeness, the scale of invention, outputs in the electronic field, and the degree of dependence on the US technology domain positively affect the citation counts of ETRI‐invented US patents. The magnitude of international presence appears to negatively affect the citation counts of ETRI‐invented US patents.     

New hybrid fuzzy controller for direct torque control induction motor drives

A new hybrid fuzzy controller for direct torque control (DTC) induction motor drives is presented in this paper. The newly developed hybrid fuzzy control law consists of proportional-integral (PI) control at steady state, PI-type fuzzy logic control at transient state, and a simple switching mechanism between steady and transient states, to achieve satisfied performance under steady and transient conditions. The features of the presented new hybrid fuzzy controller are highlighted by comparing the performance of various control approaches, including PI control, PI-type fuzzy logic control (FLC), proportional-derivative (PD) type FLC, and combination of PD-type FLC and I control, for DTC-based induction motor drives. The pros and cons of these controllers are demonstrated by intensive experimental results. It is shown that the presented induction motor drive is with fast tracking capability, less steady state error, and robust to load disturbance while not resorting to complicated control method or adaptive tuning mechanism. Experimental results derived from a test system are presented confirming the above-mentioned claims.     

一种改进的MC-CDMA系统结构

MC-CDMA在频域扩频时实际上是一种频率分集,对于频率分集重数的要求通常小于子载波的数目N,故扩频因子可以小于子载波数目。改进了这种MC-CDMA系统的结构,通过在频域引入交织器,使交织后频率分集各分量经历独立的哀落,从而提高了抗哀落能力。最后给出了用系统仿真软件SPW仿真的结果。     

A new Pd-oxide-Al/sub 0.3/Ga/sub 0.7/As MOS hydrogen sensor

A new and interesting Pd-oxide-Al/sub 0.3/Ga/sub 0.7/As MOS hydrogen sensor has been fabricated and studied. The steady-state and transient responses with different hydrogen concentrations has been measured at various temperatures. Based on the large Schottky barrier height and presence of oxide layer, the studied device exhibits a high hydrogen detection sensitivity and wide temperature operating regime. The studied device exhibits the low-leakage current and obvious current changes when exposed to hydrogen-contained gas. Even at room temperature, a very high hydrogen detection sensitivity of 155.9 is obtained when a 9090 ppm H/sub 2//air gas is introduced. Furthermore, when exposed to hydrogen-contained gas at 95/spl deg/C, both the forward and reverse currents are substantially increased with increased hydrogen concentration. In other words, the studied device can be used as a hydrogen sensor under the applied bidirectional bias. Under the applied voltage of 0.35 V and 9090 ppm H/sub 2//air hydrogen ambient, a fast adsorption response time about 10 s is found. The transient and steady-state characteristics of hydrogen adsorption are also investigated.     

Synthesis of ZSM‐5 Films and Monoliths with Bimodal Micro/Mesoscopic Structures

A route to synthesize ZSM‐5 crystals with a bimodal micro/mesoscopic pore system has been developed in this study; the successful incorporation of the mesopores within the ZSM‐5 structure was performed using tetrapropylammonium hydroxide (TPAOH)‐impregnated mesoporous materials containing carbon nanotubes in the pores, which were encapsulated in the ZSM‐5 crystals during a solid rearrangement process within the framework. Such mesoporous ZSM‐5 zeolites can be readily obtained as powders, thin films, or monoliths.     

Inside Front Cover: The Elastic Properties and Plastic Behavior of Two‐Dimensional Polymer Structures Fabricated by Laser Interference Lithography (Adv. Funct. Mater. 10/2006)

The probing of the micromechanical properties within a two‐dimensional polymer structure with sixfold symmetry fabricated via interference lithography reveals a nonuniform spatial distribution in the elastic modulus “imprinted” with an interference pattern in work reported by Tsukruk, Thomas, and co‐workers on p. 1324. The image prepared by M. Lemieux and T. Gorishnyy shows how the interference pattern is formed by three laser beams and is transferred to the solid polymer structure. The elastic and plastic properties within a two‐dimensional polymer (SU8) structure with sixfold symmetry fabricated via interference lithography are presented. There is a nonuniform spatial distribution in the elastic modulus, with a higher elastic modulus obtained for nodes (brightest regions in the laser interference pattern) and a lower elastic modulus for beams (darkest regions in the laser interference pattern) of the photopatterned films. We suggest that such a nonuniformity and unusual plastic behavior are related to the variable material properties “imprinted” by the interference pattern.     

应用激光活化饵料藻种的研究

应用Nd:YAG激光(波长1.06μm,功率5w,照射时间0.5-3 min)和Ar+激光(波长488nm,功率70mw,照射时间5-15min)对长期保存的不同保存形式的塔胞藻(Pyramidomonassp.)进行辐照处理。研究了不同剂量激光辐照对藻体生长和叶绿素含量的影响。实验结果表明:照射剂量为60s的Nd:YAG激光及剂量为15min的Ar+激光对液体保存形式的藻种有较明显的促长效果,接种后这两种激光处理组的比生长速率分别较对照提高达53.33%和28.89%,叶绿素含量分别增加73.33%和65.69%。两种激光对液体保存藻种的活化效果均好于固体保存种。