产量──密度模型讨论

本文给出产量与密度函数关系     

Highly compact AC-AC converter achieving a high voltage transferratio

This paper reports a new, highly integrated modular design approach for pulsewidth-modulation AC-AC converters based on a modular phase-bank structure. Novel high-power 3-in-1 integrated bi-directional power modules (IBPM) rated at 1200-V AC and 150 A and the 3-to-1 phase bank circuits have been successfully developed, fabricated and tested. This enables the modularity design of the multiphase converter systems and reduces the critical parasitic inductance. A theoretical analysis of the IBPM's silicon utilization for this new breed of direct power converters has been outlined. A lab prototype at medium power level has been successfully designed, implemented, and tested with good results. A nearly 460-VRMS out voltage at a 1:0.955 voltage transfer ratio, which, perhaps, is the highest performance reported so far in the literature, has been achieved by the novel two-side modulation control system. The converter-fed AC motor system is able to operate over the 0-240 Hz range with inherent regenerative capability and four-quadrant operation. Potential industrial applications are also briefly highlighted in this paper     

Quantitative dependence of MR signal intensity on tissue concentration of Gd(HP-DO3A) in the nephrectomized rat.

Cardiac-gated SE 20/224 +/- 20 MR images were obtained from nephrectomized rats before and after intravenously administering 153Gd-Gd(HP-DO3A). The concentration of Gd, [Gd], was linear in dose in myocardium, skeletal muscle, and blood. Under steady-state conditions, where d[Gd]/dt = 0, image intensities (IIN) in regions of interest were compared with the measured [Gd]. IIN was linear in myocardium at less than or equal to 0.61 mumol/g-myocardium (less than or equal to 0.5 mmol/kg dose) and in skeletal muscle at less than or equal to 0.63 mumol/g-muscle (less than or equal to 0.75 mmol/kg). Above 0.6 mumol Gd/g-tissue, IIN did not increase further. The in vivo data were consistent with measured ex vivo and in vivo relaxivities. A 29% greater slope for IIN versus [Gd] in myocardium [14,439 +/- 4350 IIN (mumol/g)] than in muscle [10,258 +/- 5,296 IIN/(mumol/g)] was attributed to a significant difference in blood content: 25% versus 2% weight blood in myocardium and skeletal muscle, respectively. Two components were apparent from plots of ex vivo 1/T1 versus [Gd] in myocardium and muscle, and only one for blood.     

A theoretical study of pulsed laser sampling photon amplifiers

Theoretical studies point to significant improvements in the performance of semiconductor laser amplifiers by injecting carriers with pulsed electric currents of sub-nanosecond duration. A pulsed Fabry-Perot amplifier (FPA) is most sensitive to input lightwave at the instant the carrier density is crossing the critical region, and gives a sharply pulsed sampling effect on the input lightwave signal. Compared with a FPA operating at subcritical electron density, the pulsed amplifier gives much higher gain, peak power, and bandwidth. In fact, pulsed operation of a FPA is also expected to give significantly higher gain and about the same peak output power as a traveling wave amplifier. Pulsed operation also improves the performance of a traveling wave amplifier by attenuating its internally reflected waves     

热辐射驱动烧蚀平面金靶的数值定标定律

利用一维辐射流体力学编码数值研究了辐射烧蚀波在平面金靶中的传播情况,并在常温边界条件下得到了辐射流、烧蚀压、质量烧蚀率和特征等离子体密度的定标定律。     

Investigation of the chemical state of ultrathin Hf-Al-O films during high temperature annealing

Al₂O₃ incorporated HfO₂ films grown by atomic layer deposition (ALD) were investigated by high-resolution X-ray photoelectron spectroscopy (HRXPS). The core level energy state of a 15 Å thick film showed a shift to higher binding energy, as the result of a silicate formation and Al₂O₃ incorporation. The incorporation of Al₂O₃ into the HfO₂ film had no effect on silicate formation at the interface between the film and Si, while the ionic bonding characteristics and hybridization effects were enhanced compared to a pure HfO₂ film. The dissociation of the film in an ultrahigh vacuum (UHV) is effectively suppressed compared to a pure HfO₂ film, indicating an enhanced thermal stability of Hf-Al-O. Any dissociated Al₂O₃ on the film surface was completely removed into the vacuum by vacuum annealing treatment over 850 °C, while HfO₂ contributed to Hf silicide formation on the film surface.     

非奇异单圈图的刻划

边数等于顶点个数的连通图称为单圈图.本文修正了文献[1]中关于奇异单圈图的充要条件,并且利用该条件证明了文献[2]中一个关于非奇异单圈图的猜想.     

Synthesis and magnetic properties of multilayer Ni/Cu and NiFe/Cu nanowires

Highly ordered composite nanowires with multilayer Ni/Cu and NiFe/Cu have been fabricated by pulsed electrodeposition into nanoporous alumina membrane. The diameter of wires can be easily varied by pore size of alumina, ranging from 30 to 100 nm. The applied potential and the duration of each potential square pulse determine the thickness of the metal layers. The nanowires have been characterized by transmission electron microscopy (TEM), magnetic force microscopy (MFM), and vibrating sample magnetometer (VSM) measurements. The MFM images indicate that every ferromagnetic layer separated by Cu layer was present as single isolated domain-like magnet. This technique has potential use in the measurement and application of magnetic nanodevices.     

An experimental investigation of electrically thick rectangular microstrip antennas

The electromagnetic properties of electrically thick rectangular microstrip antennas were investigated experimentally. Antennas were fabricated with different patch sizes and with electrical thicknesses ranging from 0.03 to 0.23 wavelengths in the dielectric substrate. The resonant frequencies were measured and compared to existing formulas. The bandwidth was calculated as a function of electrical thickness and the antenna radiation patterns were measured.     

Practical stopping criteria for validating safety-critical software by estimating impartial reliability

In this research, we investigate stopping rules for software testing and propose two stopping rules from the aspect of software reliability testing based on the impartial reliability model. The impartial reliability difference (IRD-MP) rule considers the difference between the impartial transition-probability reliabilities estimated for both software developer and consumers at their predetermined prior information levels. The empirical–impartial reliability difference (EIRD-MP) rule suggests stopping a software test when the computed empirical transition reliability is tending to its estimated impartial transition reliability. To insure the high-standard requirement for safety-critical software, both rules take the maximum probability (MP) of untested paths into account.