Effects of Processing Parameters on Microstructure and Properties of Nanoscale ZrC/ZrB2 Multilayered Coatings

ZrC/ZrB2 multilayered coatings with bilayer periods of 3.5-40nm are synthesized by rf magnetron sputtering. Analyses of x-ray diffraction, scanning electron microscopy and nanoindentation indicate that multilayered coatings possess much higher hardness and greater fracture resistance than monolithic ZrC and ZrB2 coatings. A maximum hardness （41.TCPa） and a critical fracture load （73.7mN） are observed in the multilayer with A = 32 nm deposited at the substrate bias -40 V. Higher residual stress built in the ZrC layer can be released by periodic insertion of ZrB2 into the ZrC layer. A clear multilayered structure with mixed ZrB2（001）, ZrB2 （002） and ZrC （111） orientations should be responsible for the enhanced mechanical properties.     

Pregelation Behaviour of Coagulation Processes with the Constant-Reaction-Number Kernel

We propose an irreversible binary coagulation model with a constant-reaction-number kernel, in which, among all the possible binary coagulation reactions, only p reactions are permitted to take place at every time. By means of the generalized rate equation we investigate the kinetic behaviour of the system with the reaction rate kernel K（i;j） = （ij）^w （0 ≤w〈1/2）, at which an i-mer and a j-mer coagulate together to form a large one. It is found that for such a system there always exists a gelation transition at a finte time to, which is in contrast to the ordinary binary coagulation with the same rate kernel. Moreover, the pre-gelation behaviour of the cluster size distribution near the gelation point falls in a scaling regime and the typical cluster size grows as （to - t）-1/（1-2w）. On the other hand, our model can also provide some predictions for the evolution of the cluster distribution in multicomponent complex networks.     

氟碳铈矿／直氟碳钙铈矿混层结构中新规则混层矿物的超微结构研究

用电子衍射和晶格像技术研究了钙稀土氟碳酸盐矿物中的氟碳铈矿（Ｂ）／直氟碳钙铈矿（Ｓ）混层结构，发现并确定了Ｂ＿４Ｓ＿４、Ｂ＿８Ｓ＿６、Ｂ＿１Ｓ＿６、Ｂ＿７Ｓ＿４和Ｂ＿２Ｓ＿１５种新规则混层矿物的对称性、晶胞参数及理论晶体化学式。根据所获得的高分辨晶格像真实而直观地揭示出该类Ｂ＿ｍＳ＿ｎ（ｍ＞ｎ）型新规则混层矿物的长周期有序堆垛结构特征及变化规律。     

Bright Blue Light—emitting Diodes Based on a Novel Fluorescent Dye Containing Heterocyclic Groups

Novel molecular material ,1-benzothiazoly-3-pheny1-pyrazoline (BTPP) was found to function as bright blue light emitting dye in organic electroluminescent device, and its optical and electric characteristics were investigated. This heterovyclic compound exhibited good characteristics of blue photoluminescence and electroluminescence,which had the emission peak at 450nm .The single layer light-emitting devices using BTPP as light -emitting material dispersed in poly(N-vinylcarbazole)(PVK) and double layer ones using PBD as hole block layer above the light-emitting layer were fabricated using conventional spin-casting and vaccum vapour deposition methods. The introduction of PBD has enhanced electron injection and luminance efficiency, compared with the single layer LEDs.     

Comparisons of PWM and one-cycle control for power amplifier with multilevel converter

Based on the concepts of cascade multilevel converters and one-cycle technique, comparisons are conducted to characterize the distortion of the pulsewidth modulation (PWM) and one-cycle control methods that were applied to converters. Simulation results for the different control schemes are obtained in PSIM software initially to see the effect of one-cycle control different from that of PWM control. Through the comparisons, the advantages and disadvantages are identified for each method. The one-cycle scheme is better than PWM control in reducing undesirable harmonics and tracing dynamic waveforms. Simulation and experimental results are also provided to verify the conclusions.     

完善组装工艺与实施统计过程控制(SPC)

本文主要说明了X射线分层摄影法的在线检测，统计过程控制（SPC）在BGA装配中的应用，并通过BGA定位、制程能力、焊料桥接、焊料开路、焊料短路和把SPC应用于BGA，进一步简术了装配工艺与履行统计过程控制的关系。     

大电流监测信号提取的光收发及信号处理

近年来,大电流的监测成了人们十分关心的问题,这是由于大电流有强磁、高压、电流大等一系列的直接监测所不能克服的问题。这就需要把高压大电流的强电信号,经过提取后变成能在实验室中直接观测的弱电信号。为此,如何从高压大电流的信号中提取出随实时信号变化而实时变化的小信号就变成了一个关键问题。详细介绍了监测信号提取的光收发电路原理和后续信号处理电路,分析了各部分的作用,给出了必要的分析结果。     

非AWGN环境下调制类型自动识别

在非AWGN环境下，针对CW，AM，FM，OOK，PSK，QPSK，16QAM，FSK，MSK，SSB十种混合调制信号，对调制类型特征提取方法和自动识别算法进行了分析、综合、设计和计算机仿真。提出了梯层电平分析方法、频率瞬时信号分析、剔除载波的归一化能量分析、平方后信号的频谱分析、四次方后的信号频谱分析等方法。当SNR=10dB时，计算机仿真结果是正确识别率不低于95％，自动识别的平均处理时间为不超过10s。     

基于神经网络的雷达辐射源体制和用途智能识别

本文描述一种采用BP神经网络对雷达辐射源体制和用途进行智能识别的方法 ,包括理论分析、神经网络结构设计、推理和学习算法设计、编程算法设计、实验结果比较与分析等。实验表明 ,该方法有着良好的识别效果     

阀控式铅酸蓄电池的维护

对阀控式铅酸式蓄电池的维护工作进行了初步探讨。