ALICE实验中光子谱仪的触发选判机制的模拟研究

对ALICE实验光子谱仪的触发选判机制进行了模拟研究, 内容包括: 1) 对光子谱仪的能量重建性能进行了研究, 通过计算机模拟检验光子谱仪探测器对大横动量范围的入射粒子的能量重建性能; 2) 对光子谱仪探测器的事件触发效率进行了研究, 通过计算机模拟分析触发阈值的选取并计算触发效率; 3) 对光子谱仪探测器的事件触发频率进行了研究, 通过计算机模拟对p-p和Pb-Pb两种碰撞模式下的触发频率分别进行了估算和讨论.     

Ag纳米颗粒的光吸收和透射电镜研究

用硼氢化钠作还原剂,制备出两种相对稳定的含银纳米颗粒的水溶胶,用透射电镜（TEM）和光学吸收谱对这些颗粒进行了表征.当被还原的银离子较少时,所形成的银纳米颗粒较小,吸收峰呈现二极等离子体共振吸收峰.当被还原的银离子较多时,银纳米颗粒尺寸变大,并出现二极和四极共振吸收峰.在Ag纳米颗粒形成后,对其溶液稀释,发现其峰形保持不变,而峰位会出现红移,最大红移量可达到10 nm.透射电镜研究表明,低浓度溶胶中的Ag纳米颗粒尺寸较为均匀,平均直径12 nm.高浓度溶胶中的纳米颗粒尺寸呈双尺寸分布特点,少量颗粒直径小于14 nm,大部分颗粒直径大于20 nm.     

OFDM-MIMO系统及其频率同步分析

多媒体业务对无线通信的带宽与品质提出了更高的要求，OFDM和MIMO由于满足了这一需求被越来越多的无线通信标准采用所为底层的调制和传输技术。频率同步问题是OFDM—MIMO物理层设计中正确解调的前提和基础，本文介绍了OFDM—MIMO的原理、特点和频率同步问题的研究现状。     

环形燃烧室火焰简及旋流器流场计算

本文采用偏微分方程法生成贴体网格,在任意曲线坐标系下数值研究两种先进燃烧室火焰筒及其旋流器三维紊流流场。由于旋流器的形状复杂,本文采用型线定点法确定网格的边界。在非交错网格系下采用SIMPLE算法和混合差分格式对离散方程进行求解。计算结果表明计算方法合理,这计算程序进一步扩展,可用来预估环形燃烧室反应流流场。     

甚高频等离子体增强化学气相沉积法沉积μc-Si∶H薄膜中氧污染的初步研究

对不同的本底真空条件下,采用甚高频等离子体增强化学气相沉积技术沉积的氢化微晶硅（μc_Si∶H）薄膜中的氧污染问题进行了比较研究.对不同氧污染条件下制备的薄膜样品的x射线光电子能谱与傅里叶变换红外吸收光谱测量结果表明：μc_Si∶H薄膜中,氧以Si—O，O—O和O—H三种不同的键合模式存在,不同的键合模式源自不同的物理机理.μc_Si∶H薄膜的Raman光谱、电导率与激活能的测量结果进一步显示：沉积过程中氧污染程度的不同,对μc_Si∶H薄膜的结构特性与电学特性产生显著影响；而不同氧污染对μc_Si∶H薄膜电学特性的影响不同于氢化非晶硅（a_Si:H）薄膜. 关键词： 氢化微晶硅薄膜 甚高频等离子体增强化学气相沉积 氧污染     

单片机软件模拟SPI接口的解决方案

SPI接口是一种同步串行通讯接口，具备SPI接口的外围芯片十分丰富，应用非常广泛。但是，具备SPI接口的单片机种类较少。介绍了一种基于单片机的模拟SPI接口的方法，使没有SPI接口的单片机扩展带有SPI接口的外围芯片成为现实。     

电控平行排列液晶光栅的光衍射特性研究

对电控平行液晶光栅的理论进行了分析,并配以结构原理图。通过对平行排列及90°扭曲排列液晶指向矢的计算,得出液晶盒中相应的折射率、相位差与电压之间的关系图,两者经比较证明平行排列更具适用性,并在实验中观测到了平行排列液晶光栅衍射特性与电压的关系。     

Novel algorithms for shared segment protection

The major challenges in designing survivable schemes are how to allocate a minimal amount of spare resources (e.g., bandwidth) using fast (e.g., polynomial-time) algorithms, and, in case a failure occurs, to be able to recover quickly from it. All existing approaches invariably make tradeoffs. We propose novel shared segment protection algorithms which make little or no compromise . We develop an elegant integer linear programming (ILP) model to determine an optimal set of segments to protect a given active path. Although the ILP approach is useful for a medium-size network, it is too time consuming for large networks. Accordingly, we also design a fast heuristic algorithm based on dynamic programming to obtain a near-optimal set of segments. Although the heuristic algorithm has a polynomial time complexity, it can achieve a bandwidth efficiency as high as some best-performing shared path protection schemes and, at the same time, much faster recovery than these shared path protection schemes. The proposed scheme is also applicable to a wide range of networking technologies, including Internet Protocol and wavelength-division multiplexing networks under the generalized multiprotocol label switched framework.     

Achieving fast and bandwidth-efficient shared-path protection

Dynamic provisioning of restorable bandwidth guaranteed paths is a challenge in the design of broad-band transport networks, especially next-generation optical networks. A common approach is called (failure-independent) path protection, whereby for every mission-critical active path to be established, a link (or node) disjoint backup path (BP) is also established. To optimize network resource utilization, shared path protection should be adopted, which often allows a new BP to share the bandwidth allocated to some existing BPs. However, it usually leads the backup paths to use too many links, with zero cost in term of additional backup bandwidth, along its route. It will violate the restoration time guarantee. In this paper, we propose novel integer linear programming (ILP) formulations by introducing two parameters (/spl epsi/ and /spl mu/) in both the sharing with complete information (SCI) scheme and the distributed partial information management (DPIM) scheme. Our results show that the proposed ILP formulations can not only improve the network resource utilization effectively, but also keep the BPs as short as possible.     

光电双基区晶体管(PDUBAT)的器件模型

本文在考虑了晶体管的小注入效应和大注入效应以及基区宽变效应等因素后,首次用近似和简化的数学表示式和相应的等效电路,描述了光电双基区晶体管(PDUBAT)负阻形成的机理并使负阻区和谷值区的理论计算和实验结果一致性很好.