Interface solution for writing-induced nano-deformation of slider body

Writing-induced nano-deformation of slider body becomes a big concern when the mechanical spacing between the head and disk is continuously reduced to achieve higher magnetic recording areal density. Reduced head–disk spacing increases the risk of head/disk contact and causes the thermal instability in head–disk interface (HDI). This paper reports authors’ efforts towards exploration of interface solutions for writing-induced instability in ultra-low head–disk spacing magnetic system. Multi-shallow step structure with optimized rail position is analyzed and a new femto slider with such structure is explored. The results of numerical simulation indicate that the multi-shallow step structure is an effective approach in reducing the flying height change caused by the writing-induced nano-deformation of the slider body.     

一种新型半桥不对称PW M控制变换器

介绍了一种适用于DC／DC半桥变换的不对称PWM控制方案，分析了电路的工作原理，给出了150W变换器的仿真波形和实验结论，结果表明，该控制方案能在恒定开关频率下对变换器实现高效率的软开关控制。     

一种时延范德波尔电磁系统中的复杂行为(Ⅰ)——分岔与混沌现象

建立了一种可积的无穷维系统——时延范德波尔电磁系统，采用Poincaré映射分析了系统随参数E和λ变化发生的分岔与混沌现象，发现这种时延系统具有复杂的非线性动力学特性，例如吸引子共存、间歇性混沌、类似边界碰撞分岔通向混沌以及周期增加的现象.在研究系统时间混沌行为的同时，还对空间混沌行为进行了初步分析，通过描绘空间分布图发现时延范德波尔电磁系统随参数E和λ变化时，在空间中会呈现出周期和混沌等不同的图案. 关键词： 分岔 混沌 无穷维系统 时延范德波尔电磁系统     

交流源作用下介观RLC电路系统量子态随时间的演化

根据量子不变量理论，同时考虑介观电容器极板间电子波函数的耦合作用和电路的耗散,研究介观RLC电路系统在交流电流源作用下动力学的演化过程，并且得到描述系统量子态随时间的演化算符.进一步的分析结果表明，介观RLC电路系统的波函数将由任意的初态演化到一般的压缩态. 关键词： 介观RLC电路 交变电源 不变量理论 时间演化算符     

测量冷原子温度的理论与近似拟合公式的误差分析

对短程飞行时间法(tim e-of-flight,TOF)中推算冷原子温度的理论拟合公式与近似拟合公式进行了误差分析与比较。研究表明:对于使用短程飞行吸收光谱信号推测冷原子团温度,当探测光光斑半径与冷原子团高斯半径之比k小于0.2时,理论拟合公式和近似拟合公式能很好的相符,随着探测光光斑半径与冷原子团高斯半径比值的逐渐增大,用近似拟合公式所得TOF吸收信号与用理论拟合公式所得TOF吸收信号的误差也将逐渐增大,当比值为0.5时,用近似拟合公式所得TOF吸收信号的误差将增大到20%。     

Study on anti-emission materials for non-emitting grid applications in microwave power tubes

Hafnium and platinum were deposited onto molybdenum grids by ion-beam assisted deposition method. Electron-emission characteristics from molybdenum grids with Hf and Pt films, which were contaminated by active electron-emission substances (Ba, BaO) of the cathode, were measured using analogous diode method. The surfaces of grids were analyzed by X-ray diffraction. The results revealed that the reaction between BaO and Hf formed BaHfO₃ compound, which greatly reduced the accumulation of BaO on the surface and accordingly decreased grid emission. In contrast, Ba were formed by the decomposition of BaO on the surface of Pt film under high temperature and re-evaporated from its surface, which reduced the active electron-emission substances on the surface of the grid and effectively restrained grid emission. Their mechanisms for grid-emission suppression are discussed and a good method to develop new grid-coating materials is suggested.     

�����װ�õĻԹ�ŵ�����

在四阳极直流放电装置上,测量并分析了辉光放电的电流-电压和发光特征随气压的变化关系。结果表明,采用稳流放电模式比稳压放电具有更宽的稳定放电气压和电流范围,能在从1～800Pa的较宽气压范围内实现氦气辉光放电,放电电流可达到500mA左右。随着电极表面亮斑的变化,对于同一气压,在低电流区,放电电压几乎成指数增长;随电流增大,电压的增长速度变缓;对于高的气压,碰撞频率的增大使得电压随电流升高的速率变小。分析表明,放电处于异常辉光区。从放电管的CCD图像可以看出,对于同一放电电流,随气压的升高,等离子体往阴极收缩。     

偏振模色散统计特性的研究

利用动态方程研究了偏振模色散矢量的统计特性 ,分别用统计系综和频率系综两种方法进行数值模拟。数值结果表明 ,统计系综和频率系综两种方法的结果一致。在大归一化距离条件下 ,均方根时延的平方随归一化距离线性变化 ;偏振模色散矢量的各个分量服从高斯分布 ,差分群时延服从麦克斯韦分布 ;偏振模色散矢量弥散于整个邦加球     

Pad effects on material-removal rate in chemical-mechanical planarization

The role of a porous pad in controlling material-removal rate (MRR) during the chemical-mechanical planarization (CMP) process has been studied numerically. The numerical results are used to develop a phenomenological model that correlates the forces on each individual abrasive particle to the applied nominal pressure. The model provides a physical explanation for the experimentally observed domains of pressure-dependent MRR, where the pad deformation controls the load sharing between active-abrasive particles and direct pad-wafer contact. The predicted correlations between MRR and slurry characteristics, i.e., particle size and concentration, are in agreement with experimentally measured trends reported by Ouma¹ and Izumitani.²