An alternative blind feedforward symbol timing estimator using two samples per symbol

Recently, S.J. Lee proposed a blind feedforward symbol timing estimator that exhibits low computational complexity and requires only two samples per symbol (see IEEE Commun. Lett., vol.6, p.205-7, 2002). We analyze Lee's estimator rigorously by exploiting efficiently the cyclostationary statistics present in the received oversampled signal; its asymptotic (large sample) bias and mean-square error (MSE) are derived in closed-form expression. A new blind feedforward timing estimator that requires only two samples per symbol and presents the same computational complexity as Lee's estimator is proposed. It is shown that the proposed new estimator is asymptotically unbiased and exhibits smaller MSE than Lee's estimator. Computer simulations are presented to illustrate the performance of the proposed new estimator with respect to Lee's estimator and existing conventional estimators.     

High‐Performance,Monolithic Polyaniline Electrochemical Actuators

New polyaniline (PANI) asymmetric membranes were fabricated using a phase‐inversion technique with hexane as the coagulation bath. These membranes exhibit a dense structure with macrovoids distributed asymmetrically throughout the cross‐section. A stress–strain study demonstrated that the Young's modulus (1.421 GPa) and strain at break (7.6 %) of the new PANI asymmetric membranes prepared from hexane are approximately 12 and 4 times higher, respectively, than the values reported previously for the PANI integrally skinned asymmetric membranes (ISAMs) (123 MPa Young's modulus and 1.8 % strain at break). Furthermore, monolithic electrochemical actuators based on a single PANI asymmetric membrane were constructed, and a bending movement of up to 20 Hz was experimentally recorded in a hydrochloric acid aqueous solution. A lifetime of over 329 500 cycles was determined for these actuators at a ± 2° angular displacement (5 Hz). The lifetime is limited by a bending fatigue that creates a transversal crack on the PANI membrane at the air–water interface. Control over the actuator movement is also manifested by the linear dependences of the bending angle on the charge and of the angular velocity on the current. These relationships are independent of both the kind of applied electric signal and the frequency used.     

新型制冷机冷凝器壳侧的传热强化研究

针对现行制冷机冷凝器的不足 ,设计了适用于冷凝传热的新型折流杆冷凝器的壳程内部结构 ,并分析了其传热强化机理。在重力控制条件下 ,对不同内部支承结构与管束组合的冷凝器进行了传热实验研究 ,得到了水蒸汽在冷凝器壳侧的冷凝传热特性曲线。采用冷凝传热强化因子的概念 ,建立了预测该种折流杆冷凝器壳侧冷凝传热膜系数的计算公式 ,为折流杆冷疑器在制冷系统中的设计应用提供了理论依据。     

Vibsanin O, a novel diterpenoid from Viburnum awabuki

Vibsanin O, isolated from the leaves and twigs of Viburnum awabuki, is an unprecedented bicyclic diterpenoid. The structures of vibsanin O was established by extensive analysis of spectroscopic data.     

磁性钴纳米晶的二维自组装

在两种表面活性剂存在下，采用高温醇还原，合成出单分散、平均颗粒尺寸为14±19nm，直径标准偏差小(～18%)的磁性金属Co纳米晶.利用x射线衍射、紫外吸收光谱、x射线光电子能谱及透射电子显微镜对其结构和表面价态进行了分析.并将磁性金属Co纳米晶自组织形成有序的二维(2D)六方紧密堆积结构. 关键词： Co纳米晶 单分散 自组装     

转动玻璃圆筒激光器

本文介绍了转动玻璃圆筒激光器的设计及实验结果,得到了脉冲能量为13J,重复频率为15Hz的激光输出。电光转换效率为2.2％,斜效率为3.4％。     

Effect of exponentially graded base doping on the performance ofGaAs/AlGaAs heterojunction bipolar transistors

The authors have fabricated n-p-n GaAs/AlGaAs heterojunction bipolar transistors (HBTs) with base doping graded exponentially from 5×10¹⁹ cm^-3 at the emitter edge to 5×10¹⁸ cm^-3 at the collector edge. The built-in field due to the exponentially graded doping profile significantly reduces base transit time, despite bandgap narrowing associated with high base doping. Compared to devices with the same base thickness and uniform base doping of 1×10¹⁹ cm^-3 , the cutoff frequency is increased from 22 to 31 GHz and maximum frequency of oscillation is increased from 40 to 58 GHz. Exponentially graded base doping also results ill consistently higher common-emitter current gain than uniform base doping, even though the Gummel number is twice as high and the base resistance is reduced by 40%     

离子束混合工艺对材料抗蚀性能的影响

本文介绍了离子束混合工艺方法。与直接注入相比较,离子束混合所使用的设备造价低1/4—1/2,而生产效率可提高1—2个数量级,因而使生产成本大幅度降低,这无疑对离子束工艺的实际应用将产生巨大的促进作用。 通过对轴承材料(GCr15和Cr4Mo4V)经Cr、N、Ta不同元素的混合处理后,在0.5M H_2SO_4和0.1M NaCl的缓冲溶液中的阳极极化曲线表明经混合处理后的两种材料试样,其抗蚀能力和抗点蚀能力均大大提高,这与直接注入的试样效果是一致的。 通过俄歇谱仪和透射电镜的分析结果表明混合是成功的,且在一定的条件下,形成非晶组织。 本文的结论是,无论是离子的直接注入还是离子束混合,对提高轴承材料的抗腐蚀性能都是有效的方法,特别是离子束混合技术具有更大的应用前景。     

Improvement of real time diffraction efficiency of NGD holograms by introducing electron donors

Nongelatin dichromated holographic film(NGD) is a new holographic recordingmaterial.Holograms recorded on this material have better environmental stability, higherdiffraction efficiency and stronger real time effect, etc..An experimental study to ascertainthe influence of two electron donors, namely,N,N-dimethylformamide(DMF) and dimethyl-sulfoxide(DMSO),on the real time diffraction efficiency(RTDE) of NGD holograms is car-ried out.The pressence of electron donors not only improves the sensitivity,but also enhancesthe real time effect greatly.RTDE of above 60% at±1 orders of NGD plane transimissiongrating is achieved by introducing electron donors.