Structural, Infrared, and Magnetic Characterization of the Solid Solution Series Sr2−xPbx(VO)(VO4)2; Evidence of the Pb6sLone Pair Stereochemical Effect

The solid solution Sr_2−xPb_xV₃O₉, 0≤x≤2, was prepared by solid state reactions and characterized by X-ray diffraction, IR spectroscopy, and magnetic susceptibility measurements. Single crystals of the pure strontium phase and mixed Sr/Pb compounds were prepared by high temperature treatment of the respective powder compositions. Pb₂V₃O₉crystals could only be obtained by the electrochemical reduction of molten PbV₂O₆. These crystals were always twinned. The previously reported crystal structure of Sr₂V₃O₉was confirmed. It was refined toR=0.050,R_w=0.057, in space group C2/c,a=7.555(1) Å,b=16.275(2) Å,c=6.948(1) Å,β=119.78(1)°. The single crystal structural studies of the Sr_1.02Pb_0.98V₃O₉and Sr_0.67Pb_1.33V₃O₉members of the series show that the introduction of lead gives rise to a progressively complicated splitting of Sr²⁺/Pb²⁺and the tetrahedral vanadium ion crystallographic sites. As a consequence the vanadium framework distorts and beyond the Sr_0.5Pb_1.5V₃O₉composition the crystal symmetry becomes triclinic. This distortion is ascribed to the stereochemical effect of the 6s²lone pair of Pb²⁺. The crystallographic parameters of Pb₂V₃O₉area=7.598(1) Å,b=16.393(3) Å,c=6.972(2) Å,α=91.38(1)°,β=119.35(1)°,γ=90.47(1)°. Pb₂V₃O₉exhibits a more complex IR spectrum than the monoclinic phases. Despite the similarity between the triclinic and monoclinic phases the magnetic susceptibilities indicate differences in the coupling between V⁴⁺ions at low temperatures.     

Synthesis, Electrical Properties, and Powder Neutron Crystal Structure Refinement of Pb1−xBixPt2O4 Compounds (0≤x≤0.3)

Substitution of Pb for Bi in the recently characterized mixed-valence lead-platinum oxide PbPt₂O₄ was attempted and a Pb_1−xBi_xPt₂O₄ solid solution was obtained for 0≤x≤0.3. Powder X-ray diffraction study showed that all substituted compounds crystallize with similar triclinic unit cell and PbPt₂O₄ lattice parameters. The structural model of Pb_0.7Bi_0.3Pt₂O₄ was refined from powder X-ray diffraction data using the Rietveld method and the results indicate the same crystal structure than PbPt₂O₄ with one mixed Pb/Bi atomic site. Neutron diffraction realized on the two limit compositions of the solid solution (x=0 and 0.3) allowed to confirm the PbPt₂O₄ and Pb_0.7Bi_0.3Pt₂O₄ stoichiometries. Mean oxidation degree of Pt atoms in the [PtO₄] infinite chains decreases from +3 for PbPt₂O₄ to +2.7 for Pb_0.7Bi_0.3Pt₂O₄. Conductivity measurements show a metallic behavior for all the compositions except the limit composition x=0.3 for which a semiconducting behavior appears.     

[H2en]2{La2M(SO4)6(H2O)2} (M=Co, Ni): First organically templated 3d-4f mixed metal sulfates

The first organically templated 3d-4f mixed metal sulfates, [H₂en]₂{La₂M(SO₄)₆(H₂O)₂} (M=Co 1, Ni 2) have been synthesized and structurally determined from non-merohedrally twinned crystals. The two compounds are isostructural and their structures feature a three-dimensional anionic network formed by the lanthanum(III) and nickel(II) ions bridged by sulfate anions. The La(III) ions in both compounds are 10-coordinated by four sulfate anions in bidentate chelating fashion, and two sulfate anions in a unidentate fashion. The transition metal(II) ion is octahedrally coordinated by six oxygens from four sulfate anions and two aqua ligands. The doubly protonated enthylenediamine cations are located at the tunnels formed by 8-membered rings (four La and four sulfate anions).     

Pretreatment studies of cellulose wastes for optimization of cellulase enzyme activity

The composition of cellulose, hemicellulose, starch, lignin, pectin, protein, and total lipid content in the selected cellulosic wastes-tapioca (Manihot esculenta) stem, leaf, petiole, and water hyacinth (Eichhornia crassipes) were determined. The effectiveness of various physical and chemical pretreatments on the enzymatic digestibility of these wastes were identified. In general, chemical pretreatments were more effective than physical pretreatments. The efficiency of the pretreatment was checked by subjecting these wastes to enzymatic saccharification after the pretreatments.     

Charge calculations in molecular mechanics. IX. A general parameterisation of the scheme for saturated halogen,oxygen and nitrogen compounds

Summary The CHARGE2 program for the calculation of partial atomic charges has been amended to include bond parameters for a number of organic functional groups, including halogens, nitrogen and oxygen. These minor amendments to the original scheme produce dipole moments for the fluoro and chloro compounds which are in complete agreement with the observed values.The less complete data sets for the bromo and iodo compounds are also well reproduced, and the dipole moments of a variety of mixed halo compounds are now in better agreement with experiment than previously.The calculated dipole moments of the saturated nitrogen and oxygen compounds are now in much better agreement than in the original scheme, thus the revised parameterisation may be employed with confidence to predict the electrostatic energies of these compounds.Furthermore, the revised scheme now gives a precise proportionality between the charge on the proton in a CH group and the ¹H chemical shift of the corresponding proton, allowing the general prediction, in principle, of ¹H chemical shifts. In addition, attempts to include variable electronegativity in the effect are described for fluoro compounds.For part VIII see Ref. 1.     

Human neural stem cell growth and differentiation in a gradient-generating microfluidic device

This paper describes a gradient-generating microfluidic platform for optimizing proliferation and differentiation of neural stem cells (NSCs) in culture. Microfluidic technology has great potential to improve stem cell (SC) cultures, whose promise in cell-based therapies is limited by the inability to precisely control their behavior in culture. Compared to traditional culture tools, microfluidic platforms should provide much greater control over cell microenvironment and rapid optimization of media composition using relatively small numbers of cells. Our platform exposes cells to a concentration gradient of growth factors under continuous flow, thus minimizing autocrine and paracrine signaling. Human NSCs (hNSCs) from the developing cerebral cortex were cultured for more than 1 week in the microfluidic device while constantly exposed to a continuous gradient of a growth factor (GF) mixture containing epidermal growth factor (EGF), fibroblast growth factor 2 (FGF2) and platelet-derived growth factor (PDGF). Proliferation and differentiation of NSCs into astrocytes were monitored by time-lapse microscopy and immunocytochemistry. The NSCs remained healthy throughout the entire culture period, and importantly, proliferated and differentiated in a graded and proportional fashion that varied directly with GF concentration. These concentration-dependent cellular responses were quantitatively similar to those measured in control chambers built into the device and in parallel cultures using traditional 6-well plates. This gradient-generating microfluidic platform should be useful for a wide range of basic and applied studies on cultured cells, including SCs.     

Stabilization of an excess electron on molecular surfaces by a pair of HF molecules

This work presents the results of solvation of electrons on several hypothetical cyclooctane and cyclohexane molecular surfaces, using the hydrogen fluoride (HF) dimer. These complexes were constructed with extensive OH groups on one side of a hydrocarbon surface (i.e., cyclohexane sheets), which creates hydrogen‐bonded networks that can form, increasing the dipole moment of the system. Concurrently, the hydrogen atoms on the opposite side of the surface form a pocket of positive charge that can attract excess electrons. Two possible orientations for HF dimer solvation on eight molecular surfaces that have been demonstrated to be stable toward electron detachment are examined. © 2006 Wiley Periodicals, Inc. Int J Quantum Chem, 2007     

Relative retention of the fibroblast growth factors FGF-1 and FGF-2 on strong cation-exchange sorbents

The isocratic retention of two heparin-binding fibroblast growth factors, FGF-1 (acidic FGF) and FGF-2 (basic FGF), was compared on a set of six preparative strong cation-exchange adsorbents. The FGFs comprise a solute pair that are structurally equivalent, yet differ in protein parameters of potential importance in cation-exchange chromatography, such as isoelectric point, net charge, and the number and distribution of basic amino acids. The cation-exchange adsorbents comprise a diverse set of materials in common use for protein purification, with physical and chemical properties that have been characterized and described previously. Isocratic k' values for the two proteins obtained on each adsorbent at several different [NaCl] are compared with one another and with corresponding data for hen egg lysozyme, which is also strongly retained on cation-exchangers. Of the six adsorbents examined, three showed strong retention of both FGFs, with equivalent k' values for FGF-1 and FGF-2. Three others, which showed weaker overall retention for the FGF pair, showed much larger retention differences between FGF-1 and FGF-2. The trends in retention order among the stationary phases are very similar to those seen previously with other unrelated proteins. However, retention differences between the two FGFs, and between the FGFs and lysozyme, do not correlate well with simple charge properties such as net charge, indicating, as in some previous studies, the importance of local regions on the protein surface in determining retention. These observations are interpreted in terms of the structural features of the proteins and the physicochemical properties of the adsorbents.     

Phospholipid coated poly(lactic acid) microspheres for the delivery of LHRH analogues

The aim of this work was to develop alternative peptide‐loaded microspheres using liposphere formulation—a lipid based microdispersion system. This formulation represents a new type of lipid or polymer‐based encapsulation system developed for parenteral and topical drug delivery of bioactive compounds. Our strategy was to utilize the liposphere formulation to improve the entrapment efficiency and release profile of triptorelin and leuprolide [luteinizing hormone–releasing hormone (LHRH) analogues] in vitro. Peptides (2% w/w) were loaded into lipospheres contained of polylactic acid (PLA) or poly(lactic‐co‐glycolic acid) (PLGA) with several types of phospholipids. The effects of polymer and phospholipid type and concentration, method of preparation and solvents on the liposphere characteristics, particle size, surface and bulk structure, drug diffusion rate, and erosion rate of the polymeric matrix were studied. The use of L ‐PLA (M_w = 2000) and hydrogenated soybean phosphatidylcholine (HSPC) with phospholipid–polymer ratio of 1 : 6 w/w, was the most efficient composition that formed lipospheres of particle size in the range of 10 µm with most of the phospholipid embedded on the particles surface. In a typical procedure, peptides were dissolved in N‐methyl‐2‐pyrrolidone (NMP), and dispersed in a solution of polymer and phospholipids in a mixture of NMP and chloroform with the use of 0.1% poly(vinyl alcohol) (PVA) as the emulsified aqueous medium. Uniform microspheres were prepared after solution was mixed at 2000 rpm at room temperature for 30 min. Using this formulation, the entrapment efficiency of LHRH analogues in lipospheres was up to 80%, and the peptides were released for more than 30 days. Copyright © 2002 John Wiley & Sons, Ltd.