SnCl4 and SbCl5 promoted aromatization of enamines

Aromatic amines have been synthesized efficiently from enamines using SnCl₄ and SbCl₅ in CH₂Cl₂ at room temperature.     

Asymmetric intermolecular C-H activation,using immobilized dirhodium tetrakis((S)-N-(dodecylbenzenesulfonyl)- prolinate) as a recoverable catalyst

[reaction: see text] Heterogenization of dirhodium tetrakis((S)-N-dodecylbenzenesulfonyl)prolinate) (Rh(2)(S-DOSP)(4)) can be readily achieved on a pyridine functionalized highly cross-linked polystyrene resin. The immobilized complex is readily recycled and exhibits excellent catalytic activity for asymmetric intermolecular C-H activation by means of rhodium carbenoid induced C-H insertion.     

An efficient procedure for the synthesis of coumarin derivatives using TiCl4 as catalyst under solvent-free conditions

The ability of titanium(IV) chloride as a catalyst to promote the Pechmann condensation reaction with a range of phenols and β-keto esters is described.The reaction was carried out by addition of TiCl₄ to a mixture of the phenol and the β-keto ester with thorough stirring in the absence of a solvent and represents an improvement on the classical Pechmann conditions. The yields of coumarins obtained via this novel protocol were significantly higher than those using the conventional method and the reaction duration was reduced to a few minutes or even a few seconds.     

Characterization of aerogel prepared high-surface-area alumina: in situ FTIR study of dehydroxylation and pyridine adsorption

Mesoporous high-surface-area alumina was prepared by a modified aerogel procedure. Specific surface areas between 530-685 m(2)g(-1) were obtained after heat treatment at 500 degrees C. Nitrogen adsorption studies have shown that surface areas and pore characteristics change upon decomposition of aluminum hydroxide to oxide as well as upon compaction of oxide powders. The surface area of aluminum hydroxide increased to a maximum, while the pore volume and diameter decreased as the hydroxide was heated to a temperature of 400 degrees C. Heating at higher temperatures resulted in sintering of the particles accompanied by a decline in the surface area. Compaction of activated alumina into pellets was accompanied by a relatively gradual change in the surface area and pore characteristics at pressures below 6.9 x 10(7) Pa, while severe changes took place at a pressure of 1.4 x 10(8) Pa. In situ IR studies of the dehydroxylation of the alumina surface, showed nu(OH) absorptions for isolated surface hydroxy groups centering at 3670, 3714, and 3765 cm(-1), which are shifted to lower frequencies than common literature values. Pyridine was found to adsorb on Al(3+) ions as well as through hydrogen bonding to relatively acidic surface OH groups, and IR spectra indicated the presence of strong Lewis acid sites.     

Determination of hopane biomarkers in Arabian crude oils by gas chromatography-tandem mass spectrometry

Gas chromatography-mass spectrometry with the mass spectrometer operated in the tandem mode at a constant accelerating voltage was used to analyse for triterpanes in Arabian crude oils. Specific molecular parent-daughter ion pairs were selected for quantitative measurements owing to their metastable transitions in the first field-free region. More accurate relative distribution ratios of hydrocarbon biomarkers were determined by this sequential gating technique than by the conventional diagnostic daughter ion mass fragmentogram in common GC-MS. The data and spectra obtained from MS-MS operation may serve as unique “fingerprints” for these regional crudes     

Kinetic studies on the solvolysis and axial ligand substitutions of bis-triphenylphosphine(cyclohexane-1,2-dione-dioximato)ruthenium(II) in non-aqueous solvents

Kinetic studies of ligand substitutions of the six-coordinated Ru^II pseudo-macrocyclic complex [Ru(CHDH)₂- (PPh₃)₂] (CHDH=cyclohexanedione-dioximato) have been spectrophotometrically investigated in a variety of solvents and at 70, 80, 85 and 90°C. The reactions studied are of the form:[(PPh₃)Ru(CHDH)₂(PPh₃)] + L =[(PPh₃)Ru(CHDH)₂L] + PPH₃ where L is imidazole, pyridine, piperidine or thiophene or a solvent molecule (PhCl, PhMe, MeCN, DMSO or DMF). The solvolysis reactions with chlorobenzene and toluene proceed to an equilibrium position favoring the bis-triphenylphosphine complex. All other reactions proceed to completion. From a mechanistic point of view the reactions were found to proceed through the formation of a five coordinate intermediate that possesses little or no discriminating ability towards the incoming nucleophiles. The rate data were thus interpreted in terms of a dissociative (D) or dissociative interchange (Id) mechanism. Activation parameters H and S are reported. Preliminary studies on the solvatochromic behavior of [Ru(CHDH)₂(PPh₃)₂] and the corresponding mixed complexes are discussed.     

Synthesis of 1,2,3-thiadiazolo[4,5-d] pyridazines,A new heterocyclic ring system

A method was developed for the synthesis of 5-carbethoxy-4-formyl-1,2,3-thiadiazole (I), its isomer (II); 5-benzoyl-4-formyl-1,2,3-thiadiazole (III), and its isomer (IV). It was demonstrated that although compounds I, III and IV with hydrazine gave 7H-1,2,3-thiadiazolo[4,5-d]-pyridazin-7-one (XXII), 7-phenyl-1,2,3-thiadiazolo[4,5-d]pyridazine (XXIII) and 4-phenyl-1,2,3-thiadiazolo[4,5-d]pyridazine (XXV), respectively; however, compound I gave its corresponding hydrazone (XXIV).     

Inhibition of Pb-Leaching from Lead Crystal Glass by Coating with Films Prepared by the Sol-Gel Method

The chemical durability of lead glass tumblers (24% PbO) in a 4% (v/v) acetic acid solution before and after coating with sol-gel derived SiO2 films was assessed to determine the extent of reduction in Pb-leaching that can be achieved. It was found that by coating the internal surface of the glass tumblers with 1 ml of 10% TEOS solutions at 100°C and densifying the coating formed at 500°C for 1 h, it was possible to reduce Pb-leaching to about one quarter of that of the uncoated glass.     

Controllable growth of chains and grids from polyoxomolybdate building blocks linked by silver(I) dimers

Molecular growth processes utilizing a beta-octamolybdate synthon and {Ag2} dimers are described and the directing influence of "encapsulating" cations and coordinating solvent is also demonstrated. The growth of two 1D chains, (nBu4N)2n[Ag2Mo8O26]n (1) and (nBu4N)2n[Ag2Mo8O26(CH3CN)2]n (2), is achieved when nBu4N+ ions are used, and the diameter of the chains can be expanded by the coordination of CH3CN solvent (2). The formation of a type of gridlike structure in which 1D chains are crossed-over each other in alternatively packed layers is achieved in DMSO as the solvent; DMSO acts as a linking group to give (nBu4N)2n[Ag2Mo8O26(dmso)2]n (3), which, similar to 1 and 2, still incorporates the Bu4N+ ions that exert an "encapsulating" influence. However, in (HDMF)n[Ag3(Mo8O26)(dmf)4]n (4) the relatively bulky Bu4N+ ions are exchanged for protonated DMF cations, thereby allowing the chains to condense to a 2D array. The building block concept is further enforced by the isolation of a "monomeric" unit (Ph4P)2[Ag2Mo8O26(dmso)4] (5), which is isolated when the Ph4P+ ions are so "encapsulating" as to prevent aggregation of the {Ag-Mo8-Ag} building blocks. The nature of the AgAg dimers in each of the compounds 1-4 is examined by DFT calculations and the interplay between these Ag-Ag interactions and the structure types is described.