石墨纸对带散热装置压电变压器磨损改善研究

压电变压器的散热问题限制了其在高功率场合的应用。接触式散热装置为压电变压器提供了良好的散热途径,对其功率密度带来了革命性的提升,同时,也带来了压电变压器表面电极的摩擦、磨损问题。因此,该文提出在压电变压器和散热装置中插入厚22μm石墨纸垫片的方式。实验结果表明,持续工作80h时,使用石墨纸垫片方式的电极磨损是直接接触电极磨损的53%。两种方式的散热装置温升无明显差别,对减缓压电变压器电极磨损的研究有一定的参考意义。     

Effect of Microstructure of TiO2 Thin Films on Optical Band Gap Energy

TiO2 coatings are prepared on fused silica with conventional electron beam evaporation deposition. After annealed at different temperatures for four hours, the spectra and XRD patterns of TiO2 thin film are obtained. XRD patterns reveal that only anatase phase can be observed in TiO2 coatings regardless of the different annealing temperatures, and with the increasing annealing temperature, the grain size gradually increases. The relationship between the energy gap and microstructure of anatase is determined and discussed. The quantum confinement effect is observed that with the increasing grain size of TiO2 thin film, the band gap energy shifts from 3.4 eV to3.21 eV. Moreover, other possible influence of the TiO2 thin-film microstructure, such as surface roughness and thin film absorption, on band gap energy is also expected.     

Wideband Antireflection Film Fabricated by Glancing Angle Deposition

Graded-index ZrO2 films has been fabricated on K9 glass by glancing angle deposition. Because the index mismatch at the interface has been reduced, the film results in wideband high-transmission antireflection. From 400nm to 1200nm, the film reflection is lower than 0.8% and the lowest value is 0.2% at 432nm.     

Interface roughness, surface roughness and soft X-ray reflectivity of Mo/Si multilayers with different layer number

A series of Mo/Si multilayers with the same periodic length and different periodic number were prepared by magnetron sputtering, whose top layers were respectively Mo layer and Si layer. Periodic length and interface roughness of Mo/Si multilayers were determined by small angle X-ray diffraction (SAXRD). Surface roughness change curve of Mo/Si multilayer with increasing layer number was studied by atomic force microscope (AFM). Soft X-ray reflectivity of Mo/Si multilayers was measured in National Synchrotron Radiation Laboratory (NSRL). Theoretical and experimental results show that the soft X-ray reflectivity of Mo/Si multilayer is mainly determined by periodic number and interface roughness, surface roughness has little effect on reflectivity.     

Laser-induced damage of 1064-nm narrow-band interference filters under different laser modes

The laser-induced damage behavior of narrow-band interference filters was investigated with a Nd:YAG laser at 1064 nm under single-pulse mode and free-running laser mode. The absorption measurement of such coatings has been performed by surface thermal lensing (STL) technique. The relationship between damage morphology and absorption under the two different laser modes was studied in detail. The explanation was given by the standing-wave distribution theory.     

半导体激光自混频干涉式传感器中的干涉与调制

应用F-P模型，阐述了半导体激光自混频干涉式传感器的干涉与调制过程，同时给出了相应的计算．     

抽运光与信号光的光强重叠因子和掺铒玻璃波导放大器的增益特性

在掺铒玻璃波导放大器（EDWA）的三能级速率-传输方程中,考虑两次离子交换工艺中波导掩模窗口宽度w不同所导致的抽运光、信号光模场与光强分布的不同,讨论不同w对EDWA增益特性的影响,得到光强分布的数值解.引入描述波导中抽运光和信号光的归一化光强重叠因子,对EDWA的传统近似解提出修正,得到了修正解,使其更加接近光强分布的数值解.模拟结果表明,在条波导长度为4 cm、抽运光波长为980 nm、功率为80 mW、信号光波长为1534 nm、功率为-10 dBm条件下,不同w所导致EDWA的增益差别可达297 dB.修正解的结果比传统近似解更加接近光强分布的数值解.修正解对于EDWA的理论研究、器件设计具有指导作用. 关键词： 集成光学 掺铒玻璃波导放大器 重叠积分因子 增益     

窄带干涉滤光片抗击不同输出方式激光的损伤特性研究

利用Nd∶YAG调Q单脉冲激光和自由脉冲激光对硬膜窄带干涉滤光片进行激光损伤阈值的测试,并且采用表面热透镜技术测量了滤光片的吸收率。实验发现:窄带干涉滤光片的吸收率和激光损伤阈值强烈依赖于辐照激光波长与窄带干涉滤光片通带的相对位置;在调Q单脉冲激光作用下,不同中心波长的滤光片损伤形貌存在明显的差别,而在自由脉冲激光作用下,各滤光片的损伤形貌则趋于相同,均表现为典型的热熔烧蚀破坏。根据实验结果,结合损伤形貌,通过驻波场理论对激光作用下滤光片内电场分布的分析与模拟,探讨了两种激光模式作用下滤光片的损伤特征和损伤机理的不同特点。