基于亚龙YL-236的32×16 LED点阵显示屏的设计

文章介绍了基于亚龙YL-236实验台的32×16点阵显示屏的硬件电路设计、电路驱动、软件设计,实现滚动显示16×16的汉字、8×16的数字、字母。具有结构简单,可控性好,方便实现的优点,具有一定的实际价值。     

红外动态场景生成装置空间分辨率的测试

建立了一套基于刀口灰度图红外探测的实验装置,对红外场景生成器的空间分辨率进行了测试。首先通过被测红外场景生成器产生带有刀口标志的红外图像,然后利用红外热像仪采集红外场景生成器所成的红外图像,通过对采集到的红外热图的数据处理,实现了对红外场景生成器空间分辨率的测量。测得的红外场景生成器的空间分辨率为5lp/mm,标准误差为0.04。     

新型4-羟色胺类化合物的合成及生物活性

以4-羟基吲哚为原料,经吲哚环4位乙酰基化、3位亲电取代、酰胺化和还原加氢等反应合成目标化合物7.通过核磁共振氢谱及碳谱对化合物进行结构表征,并对目标化合物进行体外抗氧化生物活性测试.初步生物活性测试结果表明,化合物7a,7b,7c和7d对DPPH·均有很强的清除作用(清除率为85.25%~90.73%),7e,7f,7g,7h作用较差;目标化合物与Vc相比,对·OH的清除作用稍差,最高清除率25.66%(Vc的最高清除率为34.67),但各化合物整体水平相当;在清除O-2·能力上化合物7a,7d,7g,7h最大清除率(分别为19.34,35.35,27.93和31.74)均强于同等浓度的Vc(17.58).     

煤直接液化油中混合酚的分离研究

利用分子筛择形特点，对煤直接液化油中的混合酚实施高效分离。本研究选取间甲酚和对甲酚作为分离煤直接液化油馏分段混合酚的模型化合物，采用化学液相沉积法对HZSM-5吸附剂的孔口结构进行改变，分析分子筛硅铝比及颗粒粒径对模型化合物间甲酚和对甲酚吸附分离性能的影响，以获得高性能固相吸附剂，并将其应用于180-190℃馏分段混合酚分离。结果表明，当分子筛硅铝比为25、粒径为3-5 μm时，分子筛的孔口结构调节效果最优；当正硅酸乙酯的最小用量为0.2 mL/g时，固相吸附剂的吸附量为0.03 g/g，对甲酚选择性高于95%。由于外表面沉积物对吸附剂的孔口结构变化，导致对甲酚选择性的提高。进一步采用HZSM-5（1）吸附剂对真实煤直接液化油混合酚的分离中发现，苯酚和对甲酚的选择性均达到100%。     

化学法改性煤沥青脱除苯并芘的研究

在管式反应器中采用苯甲酸、聚乙二醇、固体古马隆树脂（S）、液体古马隆树脂（L）为添加剂来降低煤沥青中有害物质苯并芘的含量，以期使得煤沥青可绿色化应用。采用紫外-可见分光光度计分析煤沥青中苯并芘含量。考察了反应温度、反应时间、添加剂添加量、催化剂等工艺条件对添加剂脱除煤沥青中苯并芘的影响。结果表明，不同工艺条件能降低煤沥青中苯并芘的含量。在优化条件下，不同添加剂对苯并芘脱除率由高到低依次为：液体古马隆树脂、聚乙二醇、苯甲酸和固体古马隆树脂。分析其反应机理，这与催化剂的酸性相关，发生亲电取代反应。结果表明，液体古马隆树脂（L）在催化剂存在下对煤沥青中苯并芘脱除率可达73.0%，显示了良好的应用前景。     

Research on the identification performance of UHF RFID system considering the correlation of cascaded channel

The identification rate of UHF RFID system was restricted by multipath propagation effects.The system identification performance was studied considering the correlation coefficient between forward and reverse channels.Based on the generalized Rician fading channel model,the analytical expression of identification rate was derived under independent,full correlation and correlation cases.Compared with the existing analysis,the proposed uniform calculation formula of identification rate was for any correlation coefficient and kinds of channel conditions.The numerical computation and Monte-carlo simulations show that the influences of different correlation coefficients,channel conditions,sensitivity and distance on the identification rate.     

Modeling Impact of ROADM Intra-Node Add/Drop Contention on a Single Node Lightpath Blocking Performance

We propose an analytical model to evaluate the lightpath blocking performance for a single ROADM node with intra-node add/drop contention,in which the number of lightpaths that can be added/dropped with the same wavelength is limited by the add/drop contention factor.Different models of traffic load per nodal degree are considered to validate the effectiveness of the analytical model.The simulation results show that the proposed analytical model is effective in predicting the performance for different values of add/drop contention factor C and for variable offered loads at the node.The add/drop contention factor shows an important impact on the lightpath blocking performance and properly raising the contention factor can significantly improve the lightpath blocking performance.When the add/drop contention factor C exceeds a certain level,the performance of a ROADM with intra-node contention is close to that of a contentionless ROADM.