Giant shot-like voltage noise in high current density Nb–AlOx–Nb superconducting tunnel junctions

The flat voltage noise component of current biased, high-transparency Nb/AlO_x/Nb superconducting tunnel junctions has been investigated at frequencies up to 70 kHz. Several aspects of the analyzed phenomena suggest the presence of current noise effects induced by the discreteness of the charge carriers. At subgap voltages, where excess currents occur, a behavior coherent with a multiple Andreev reflection-assisted transport through the tunnel barrier has been found. However, the measured charge values exceed any theoretical prediction.     

Mode beating in spot-size converter lasers

An anomalous modulation in the wavelength spectrum has been observed in lasers with spot-size converters. This intensity modulation is shown to be caused by beating between the fundamental lasing mode and radiation modes in the taper. This results in a periodic modulation in the net gain spectrum, which causes wavelength jumps between adjacent net gain maxima, and a drive current dependent spectral width that is expected to affect system performance. The amplitude of this spectral modulation is reduced significantly by either using an angled rear-facet which reflects the beating radiation modes away from the laser axis, or by using a nonlinear, adiabatic taper.     

航空兵塔台辅助指挥系统通信分系统技术设计方案

文章详细描述了航空兵机场塔台辅助指挥系统之通信分系统设计的特点与功能、硬件结构、软件设计原则以及接口通信协议等问题。该分系统设计已在航空兵塔台辅助指挥系统研究中得到应用 ,并达到了良好的控制效果。     

X分形晶格上Gauss模型的临界性质

采用实空间重整化群变换的方法,研究了2维和d(d>2)维X分形晶格上Gauss模型的临界性质.结果表明:这种晶格与其他分形晶格一样,在临界点处,其最近邻相互作用参量也可以表示为K=bqiqi(qi是格点i的配位数,bqi是格点i上自旋取值的Gauss分布常数)的形式;其关联长度临界指数v与空间维数d(或分形维数df)有关.这与Ising模型的结果存在很大的差异. 关键词： X分形晶格 重整化群 Gauss模型 临界性质     

Potential for micromachined actuation of ultra-wide continuously tunable optoelectronic devices

Tailored scaling represents a principle of success that, both in nature and in technology, allows the effectiveness of physical effects to be enhanced. Mutation and selection in nature are imitated in technology, e.g. by model calculation and design. Proper scaling of dimensions in natural photonic crystals and our fabricated artificial 1D photonic crystals (DBRs, distributed Bragg reflectors) enable efficient diffractive interaction in a specific spectral range. For our optical microsystems we illustrate that tailored miniaturization may also increase the mechanical stability and the effectiveness of spectral tuning by thermal and electrostatic actuation, since the relative significance of the fundamental physical forces involved considerably changes with scaling. These basic physical principles are rigorously applied in micromachined 1.55-μm vertical-resonator-based devices. We modeled, implemented and characterized 1.55-μm micromachined optical filters and vertical-cavity surface-emitting laser devices capable of wide, monotonic and kink-free tuning by a single control parameter. Tuning is achieved by mechanical actuation of one or several air-gaps that are part of the vertical resonator including two ultra-highly reflective DBR mirrors of strong refractive index contrast: (i) Δn=2.17 for InP/air-gap DBRs (3.5 periods) using GaInAs sacrificial layers and (ii) Δn=0.5 for Si₃N₄/SiO₂ DBRs (12 periods) with a polymer sacrificial layer to implement the air-cavity. In semiconductor multiple air-gap filters, a continuous tuning of >8% of the absolute wavelength is obtained. Varying the reverse voltage (U=0–5 V) between the membranes (electrostatic actuation), a tuning range of >110 nm was obtained for a large number of devices. The correlation of the wavelength and the applied voltage is accurately reproducible without any hysteresis. In two filters, tuning of 127 and 130 nm was observed for about ΔU=7 V. The extremely wide tuning range and the very small voltage required are record values to the best of our knowledge. For thermally actuated dielectric filters based on polymer sacrificial layers, Δλ/ΔU=-7 nm/V is found. Received: 10 May 2002 / Published online: 8 August 2002     

Vibrational Dynamics Studies by Nuclear Resonant Inelastic X-Ray Scattering

Nuclear resonant inelastic X-ray scattering of synchrotron radiation is being applied to ever widening areas ranging from geophysics to biophysics and materials science. Since its first demonstration in 1995 using the ⁵⁷Fe resonance, the technique has now been applied to materials containing ⁸³Kr, ¹⁵¹Eu, ¹¹⁹Sn, and ¹⁶¹Dy isotopes. The energy resolution has been reduced to under a millielectronvolt. This, in turn, has enabled new types of measurements like Debye velocity of sound, as well as the study of origins of non-Debye behavior in presence of other low-energy excitations. The effect of atomic disorder on phonon density of states has been studied in detail. The flux increase due to the improved X-ray sources, crystal monochromators, and time-resolved detectors has been exploited for reducing sample sizes to nano-gram levels, or using samples with dilute resonant nuclei like myoglobin, or even monolayers. Incorporation of micro-focusing optics to the existing experimental setup enables experiments under high pressure using diamond-anvil cells. In this article, we will review these developments. This revised version was published online in August 2006 with corrections to the Cover Date.     

Material tensor parameters of LiNbO3 relevant for electro- and elasto-optics

The complete set of self-consistent parameters of nominally undoped LiNbO₃ crystals of congruent composition that describe the electro-optic, piezoelectric, elasto-optic, elastic, and dielectric response has been determined by numerically evaluating available measurements. The parameters were determined at room temperature and consist of the low-frequency clamped dielectric constants ε^S _ij, elastic stiffness constants at constant electric field C^E _ijkl, piezoelectric stress coefficients e_ijk, elasto-optic constants at constant electric field p^E _ijkl, and clamped electro-optic coefficients r^S _ijk. It is shown that the complete set is required for calculating the effective electro-optic coefficients and dielectric constants in photorefractive applications of LiNbO₃. Received: 4 January 2002 / Revised version: 1 February 2002 / Published online: 14 March 2002     

Low-lying states of trinuclear mixed-valence cluster: [Fe3S4]0

Low-lying energy states of the [Fe₃S₄]⁰ cluster have been calculated by taking into account the double exchange, superexchange and vibronic interaction. It was found that the adiabatic potential of the excited state withS=0 corresponds to the full delocalization of the “excess” charge. From the analysis of experimental data of Mössbauer spectroscopy and the temperature dependence of the magnetic susceptibility the double exchange parametert≥4000 cm^?1 and the vibronic interaction parameter λ₂/2k cm^?1 have been estimated.     

Magnetic anisotropy of textured CrO2 thin films investigated by X-ray magnetic circular dichroism

Highly a-axis-textured CrO₂ films have been deposited on Al₂O₃ (0001) substrates by chemical vapor deposition. CrO₂ has been found to have highly a-axis (010)-oriented columnar growth on a Cr₂O₃ (0001) initial layer. The six-fold surface symmetry of the Cr₂O₃ initial layer leads to three equivalent in-plane orientations of the a-axis-oriented CrO₂ unit cell. We report Cr L_2,3 X-ray magnetic circular dichroism data along the surface normal and at 60° off-normal sample orientation. For a 60° sample alignment, a strong increase of the projected orbital moment could be observed for unoccupied majority t_2g states using moment analysis. Therefore, the c axis is identified as the intrinsic magnetic easy axis of CrO₂. In addition, a small spin moment and a very strong magnetic dipole term T_z have been found. Received: 8 January 2002 / Accepted: 8 January 2002     

The time recovery of the spectroscopic properties of heavily irradiated CdZnTe and CdTe detectors

The time recovery of the spectroscopic capabilities of CdZnTe and CdTe detectors, irradiated with increasing doses of high- and low-energy neutrons, as well as electrons, has been investigated by studying their spectroscopic behavior at different photon energies using leakage current measurements and PICTS (photo-induced current transient spectroscopy) analysis. The detectors were stored at room temperature for up to one year to study the time evolution of their spectroscopic performance and to correlate it with the presence of defective states in the material. We have observed a clear improvement in the material’s detection properties with time, though only in those detectors which have not been severely degraded by the irradiation. The recovery can be associated with a decrease in the concentration of some defective states, thus allowing the assessment of the crucial role these play in determining the charge collection processes in the material and its spectroscopic capabilities. Received: 1 August 2001 / Accepted: 3 August 2001 / Published online: 20 December 2001