Measurement of dioxygen by electrocatalytic reduction on microelectrodes modified with Nafion and methyl viologen

Nafion/methyl viologen (MV) has been chemically modified on a gold disk microelectrode (GDME). The electrochemistry of the Nafion/MV modified GDME is investigated by cyclic voltammetry (CV). Linear sweep voltammetry (LSV) and differential pulse amperometry (DPA) show that the Nafion/MV modified GDME exhibits very high electrocatalytic activity toward dioxygen reduction with good reproducibility and high sensitivity. The electrocatalytic peak current is found to be linear with the dioxygen concentration in the range of 3.44x10(-7) to 2.59x10(-4) mol l(-1) (at 25 degrees C), with a correlation coefficient of 0.9978. The detection limit (signal/noise=3) is calculated to be 0.19 mumol l(-1). The response time of the microsensor for dioxygen measurement is less than 15 s. For ten parallel measurements for 8.50 mumol l(-1) dioxygen, the relative standard deviation (RSD) is found to be 2.7%. The sensitivity of the microsensor is 0.17 nA mumol(-1) l(-1). This microsensor has been successfully employed to measure the concentration of dioxygen in real samples. The quantity of dioxygen, released from the three kinds of chloroplasts of plant leaves under different illumination, is monitored by the Nafion/MV modified gold microsensor. In order to survey the dioxygen concentration in vivo, a Nafion/MV modified carbon fiber microelectrode (CFME) is fabricated by a modification procedure similar to that of the Nafion/MV GDME. As a preliminary test, the dioxygen levels in the different areas of rat brain are determined by the Nafion/MV modified carbon fiber microsensors. The mechanism of the catalytic reaction is also addressed.     

Effect of the Coil Angle in an Inductively Coupled Plasma Torch: A Novel Two-Dimensional Model

A two-dimensional model has been developed for the calculation of the electromagnetic (EM) fields generated by spiral coil currents, in order to obtain a better representation of the actual configuration used in a typical inductively coupled plasma (ICP) torch. In order to obtain the EM fields in a two-dimensional model, the change of EM field in tangential direction is neglected and the coil is assumed to be a concentric cylinder. In order to justify our assumption, the EM, flow and temperature fields resulting from five-ring coil and concentric cylinder coil are compared and the results are almost the same except for the EM field in the vicinity of the coil. In the case of the spiral coil, the coil current is inclined with respect to the horizontal plane. Therefore current in the cylinder coil is assumed to have the same inclined angle, which is split into tangential and axial components. The axial electric field and hence an axial current in plasma is induced by the axial component of the spiral coil current. Charge density is accumulated in the plasma, since the axial current cannot form a loop. In order to obtain the EM field and the charge distribution in the plasma generated by the spiral coil, the equations of axial vector potential and electrostatic potential have been derived. Due to the swirling Lorentz force (J_z×B_r) an axisymmetrical swirling fluid model is used to simulate the plasma flow in an axisymetrical configuration. With an inclined angle of the coil current being 3.7° and the frequency being 3 MHz, computational results show that the swirling Lorentz force causes plasma swirling with a maximum speed of 3.41 m/s near the plasma center when the injected sheath gas and central gas are not swirling. In these conditions, the real and imaginary parts of the maximum electrostatic potential are 0.95 V and 1.66 V, respectively. When the electrostatic field is neglected, the swirling velocity of the plasma is 3.95 m/s.     

A Novel Green Synthesis of Quinolines through Acid-catalyzed Friedlander Reaction in Ionic Liquids

Quinoline derivatives were efficiently prepared through acid-catalyzed Friedlander reaction in ionic liquid ([bmim] [BF4]). It is shown that the proposed method is operationally simple and environmentally benign in that the reaction media and the catalyst can be recovered and be reused effectively for at least four times.     

手性双氨基醇-Et2Zn催化的不对称直接羟醛缩合反应

以1,3-二溴丙酮和(2'S)-(二苯基羟甲基)-四氢吡咯为原料,合成了两种新型手性氨基醇1,3-双[(2'S)-(二苯基羟甲基)-1-四氢吡咯基]丙酮(3)和1,3-双[(2'S)-(二苯基羟甲基)-1-四氢吡咯基]-2-丙醇(4),总产率分别为39%和35%.手性双氨基醇3-/4-Et2Zn可催化未修饰醛、酮的不对称直接羟醛缩合反应,对映体过量最高9%.     

Novel CaCO3/g-C3N4 composites with enhanced charge separation and photocatalytic activity

A novel CaCO₃/graphitic carbon nitride (g-C₃N₄) photocatalyst was synthesized for the first time via a facile calcination method using CaCO₃ and melamine as precursors. The as-prepared samples were characterized using various techniques, such as scanning and transmission electron microscopy, X-ray diffraction, Brunauer-Emmett-Teller analysis, as well as Fourier-transform infrared, X-ray photoelectron, photoluminescence, and UV–vis diffuse reflectance spectroscopy. The results of the experiments confirm the successful coupling of CaCO₃ to g-C₃N₄. The photocatalytic activity of the synthesized CaCO₃/g-C₃N₄ composites was evaluated by assessing their performance in the photocatalytic degradation of crystal violet (CV) in water under visible light irradiation. The analysis shows that CaCO₃/g-C₃N₄ exhibits higher photocatalytic activity towards CV degradation (76.0%) than pristine g-C₃N₄ (21.6%) and CaCO₃ (23.2%). Radical trapping and electron spin resonance experiments show that hydroxyl radicals (OH) and holes (h⁺) are the key reactive species in the photocatalytic process. The enhanced photocatalytic activity of the composite is mainly attributed to the efficient separation rate of electron-hole pairs achieved through the incorporation of CaCO₃.     

一氧化二氮—乙炔火焰原子吸收法测定镍—镉浸渍液中硅

提出用一氧化二氮-乙炔火焰原子吸收法分析镍-镉浸渍液中硅.方法具有良好的灵敏度,干扰少,重现性好.硅量在5～50μg.ml~(-1)范围内与吸光度呈线性关系.测定样品中硅34.0μg.ml~(-1)(n=10)时,相对标准偏差为2.2%.标准加入回收率在98%～103%范围内,适用于镍-镉浸渍液中硅的分析.     

Influence of the Size of Aromatic Chelate Ligands on the Structures of Cadmium(II) Tetracarboxylates Polymers: From 2D Layered Network to 3D Metal‐Organic Framework

To determine the influence of the size of the aromatic chelate ligands on the frameworks of metal tretracarboxylate polymers, two new coordination polymers [Cd(btc)_0.5 (2,2′‐bpy)] ( 1 ) and [Cd(btc)_0.5(phen)]·H₂O ( 2 ) (H₄btc = biphenyl‐3,3′,4,4′‐tetracarboxylic acid, 2,2′‐bpy = 2,2′‐bipyridine, phen = 1,10‐phenanthroline) have been synthesized under similar hydrothermal conditions. In complex 1 , the dimeric Cd₂ units are linked by bridging btc^4? ligand to form a 2D layered network, whereas complex 2 possesses a 3D metal‐organic framework consisting of the dimeric Cd₂ units. The differences of two metal‐organic frameworks demonstrate that the size of the rigid aromatic chelate ligands have an important effect on the structures of their complexes. Additionally, the two complexes show strong fluorescence in the solid state at room temperature.     

A new reaction for the direct conversion of 4-azido-4-deoxy-D-galactoside into a 4-deoxy-D-erythro-hexos-3-ulose

[reaction: see text] A new one-step reaction has been developed for converting 4-azido-4-deoxy-d-galactoside into 4-deoxy-d-erythro-hexos-3-ulose by phosphoramidites and tetrazole. It is proposed that the new reaction proceeds via an intramolecular Staudinger reaction of the phosphite intermediate and a tetrazole-catalyzed elimination reaction of the resultant phosphorimidate. Tetrazole appears to be playing a unique role by acting as a bifunctional catalyst to facilitate the elimination reaction.     

A synthetic strategy for the preparation of cyclic peptide mimetics based on SET-promoted photocyclization processes

A novel method for the synthesis of cyclic peptide analogues has been developed. The general approach relies on the use of SET-promoted photocyclization reactions of peptides that contain N-terminal phthalimides as light absorbing electron acceptor moieties and C-terminal alpha-amidosilane or alpha-amidocarboxylate centers. Prototypical substrates are prepared by coupling preformed peptides with the acid chloride of N-phthalimidoglycine. Irradiation of these substrates results in the generation of cyclic peptide analogues in modest to good yields. The chemical efficiencies of these processes are not significantly affected by (1) the lengths of the peptide chains separating the phthalimide and alpha-amidosilane or alpha-amidocarboxylate centers and (2) the nature of the penultimate cation radical alpha-heterolytic fragmentation process (i.e., desilylation vs decarboxylation). An evaluation of the effects of N-alkyl substitution on the amide residues in the peptide chain showed that N-alkyl substitution does not have a major impact on the efficiencies of the photocyclization reactions but that it profoundly increases the stability of the cyclic peptide.     

Fingerprint scaling increases the probability of identifying molecules with similar activity in virtual screening calculations.

Results of systematic virtual screening calculations using a structural key-type fingerprint are reported for compounds belonging to 14 activity classes added to randomly selected synthetic molecules. For each class, a fingerprint profile was calculated to monitor the relative occupancy of fingerprint bit positions. Consensus bit patterns were determined consisting of all bits that were always set on in compounds belonging to a specific activity class. In virtual screening calculations, scale factors were applied to each consensus bit position in fingerprints of query molecules. This technique, called "fingerprint scaling", effectively increases the weight of consensus bit positions in fingerprint comparisons. Although overall prediction accuracy was satisfactory using unscaled calculations, scaling significantly increased the number of correct predictions but only slightly increased the rate of false positives. These observations suggest that fingerprint scaling is an attractive approach to increase the probability of identifying molecules with similar activity by virtual screening. It requires the availability of a series of related compounds and can be easily applied to any keyed fingerprint representation that associates bit positions with specific molecular features.