A rapid and sensitive extractive spectrophotometric determination of copper(II) in pharmaceutical and environmental samples using benzildithiosemicarbazone.

Benzildithiosemicarbazone (BDTSC) is proposed as a sensitive and selective analytical reagent for the extractive spectrophotometric determination of copper(II). BDTSC reacts with copper(II) in the pH range 1.0-7.0 to form a yellowish complex. Beer's law is obeyed in the concentration range 0.5-0.4 microg cm(-3). The yellowish Cu(II)-BDTSC complex in chloroform shows a maximum absorbance at 380 nm, with molar absorptivity and Sandell's sensitivity values of 1.63 x 10(4) dm3 mol(-1) cm(-1) and 0.00389 microg cm(-2), respectively. A repetition of the method is checked by finding the relative standard deviation (RSD) (n = 10), which is 0.6%. The composition of the Cu(II)-BDTSC complex is established as 1:1 by slope analysis, molar ratio and Asmus' methods. An excellent linearity with a correlation coefficient value of 0.98 is obtained for the Cu(II)-BDTSC complex. The instability constant of the complex calculated from Edmond and Birnbaum's method is 7.70 x 10(-4) and that of Asmus' method is 7.66 x 10(-4), at room temperature. The method is successfully employed for the determination copper(II) in pharmaceutical and environmental samples. The reliability of the method is assured by analyzing the standard alloys (BCS 5g, 10g, 19e, 78, 32a, 207 and 179) and by inter-comparison of experimental values, using an atomic absorption spectrometer.     

Growth and study of single crystals of (Na,K)NbO<Subscript>3</Subscript> solid solutions

(Na, K)NbO₃ crystals with a perovskite structure and a KNbO₃ content up to 40 mol % were grown from flux with the use of the solvent NaBO₂. The dielectric measurements of the crystals grown revealed phase transitions that had never been observed before in ceramic samples.     

粒子分辨CCT方法中的δ电子效应

提出了切伦科夫相关时间测量(CCT)中初始粒子在辐射体里产生的δ电子的干扰问题,以及降低干扰的方法. 通过模拟计算给出了北京τ-C工厂探测器初步设计中CCT的π/K分辨本领.     

Linear optical switching in a FLC/waveguide composite device

A fast electrooptic modulation in a polymer waveguide using a ferroelectric liquid crystal has been proposed. In this device, the surface stabilized ferroelectric liquid crystal and the soft mode ferroelectric liquid crystal are used as an active material on the passive polymer waveguide, and electrooptic switching is realized by controlling the total reflection at the polymer waveguide-liquid crystal interface. The response time is of the order of several microseconds. The analogue electrooptic modulation in the waveguide is realized using the field induced linear molecular tilt of the electroclinic effect in the soft mode ferroelectric liquid crystal.     

超稳Y沸石制备技术对沸石铝分布的影响 Ⅱ.均匀铝分布的超稳Y沸石的制备

对水热处理后得到的USY沸石作进一步的酸处理以及采用改进的氟硅酸盐溶液骨架富硅工艺,分别得到了经XPS剖面分析证实为铝分布均匀的超稳Y沸石HAY-Ⅰ和HAY-Ⅱ。IR分析表明,在酸处理过程中从USY沸石中去掉的那部分非骨架铝类与3690cm~(-1)处羟基有关,仍残留在HAY-Ⅰ沸石中的那部分非骨架铝类与3670cm~(-1)和3600cm~(-1)处羟基有关。XRD和化学分析表明HAY-Ⅰ沸石仍含有约50％的非骨架铝类,而HAY-Ⅱ沸石则基本上不含非骨架铝类,HAY-Ⅱ沸石还显示更高的结晶保留度。DTA分析表明,HAY-Ⅰ和HAY-Ⅱ两种沸石的热稳定性均高于USY沸石。