β-Zn3(PO4)2∶Mn2+,B3+长余辉发光材料的性能

采用高温固相法分别合成了β-Zn3(PO4)2∶Mn2 和不同HBO3含量的β-Zn3(PO4)2∶Mn2 ,B3 红色长余辉材料。XRD结果表明,HBO3的加入对于β-Zn3(PO4)2物相的形成和结晶温度并没有显著影响。从不同样品的激发和发射光谱可以看出,HBO3的加入并没有改变其激发和发射光谱位置,而对其强度有一定影响。对于Zn2.85(P1-x/2O4)2∶Mn20. 15,Bx3 来说,当B3 加入量为x=0.05时发光强度最强;而对其余辉衰减光谱来说,HBO3的加入明显提高了材料的余辉性能,并且当B3 加入量为x=0.1时余辉性能最强,这是由于B3 的不等价取代增加了材料中的陷阱而导致的结果。     

热噪声对约瑟夫森结I-V特性及微波感应台阶的影响研究

采用数值仿真的方法研究了热噪声对约瑟夫森结I-V特性及微波感应台阶的影响。研究表明,热噪声导致约瑟夫森结的I-V特性曲线呈现"圆拱化",也使得微波感应台阶高度减小。得出了取不同约瑟夫森结临界电流和结电阻时,热噪声对台阶的影响规律     

High power single transverse mode operation of a tapered large-mode-area fiber laser

To get high output power with good beam quality, a tapered section is introduced to large-mode-area (LMA) Yb-doped fiber laser. Output characteristics of the fiber laser without tapered section and with tapered section are compared experimentally. When the launched pump power is 119.1 W, 77.9 W with M² 3.08 and 56.4 W with M² 1.14 can be obtained, respectively. The corresponding slope efficiencies are 71.8% and 54.1%, respectively. Although output power of the tapered fiber laser has 30.6% penalty, brightness of it is as much as 5.28 times of the fiber laser without tapered section. Moreover, spectra of them are measured. It is found that tapered section makes lasing wavelength of the fiber laser shorter.     

Performance improvement and wavelength reuse in millimeter-wave radio-over-fiber links incorporating all-fiber optical interleaver

Simultaneous downlink performance improvement and uplink wavelength reuse in a full-duplex millimeter-wave (MMW) radio-over-fiber (RoF) system by using a simple and cost-effective all-fiber optical interleaver are proposed and demonstrated. The MMW RoF downlink performance improvement is based on suppressing optical carrier-to-sideband ratio (OCSR), with which the mechanism is confirmed by theoretic analysis and derived experimental results. Measured results show that, by suppressing OCSR using a fabricated all-fiber optical interleaver, the downlink optical receiver sensitivity is improved about 2.1 dB. The downlink data rate is 1.25 Gbit/s and the carrier frequency is 58.1 GHz; the link consists of 6 km optical single-mode fiber and 1 m wireless connection. On the other hand, with the interleaver suppressing downlink OCSR, simultaneously an optical carrier is recovered from the RoF downlink and is reused for RoF uplink transmission. The uplink is operated at 62.9 GHz and the data rate is the same 1.25 Gbit/s. With the recovered optical carrier, a laser-free remote access point is achieved. The principle, structure, and fabrication of an all-fiber optical interleaver are also presented in this paper.     

Effect of surface modification by thermally oxidization and HF etching on UV photoluminescence emission of porous silicon

Photoluminescence of porous silicon (PS) is instable due perhaps to the nanostructure modification in air. The controllable structure modification processes on the as-prepared PS were conducted by thermal oxidization and/or HF etching. The PL spectra taken from thermally oxidized PS showed a stable photoluminescence emission of 355 nm. The photoluminescence emission taken from both of PS and oxidized porous silicon (OPS) samples etched with HF were instable, which can be reversibly recovered by the HF etching procedure. The mechanism of UV photoluminescence is discussed and attributed to the transformation of luminescence centers from oxygen deficient defects to the oxygen excess defects in the thermal oxidized PS sample and surface absorbed silanol groups on PS samples during the chemical etched procedure.     

Ferromagnetism of MnxLiyZn1−x−yO films

We had prepared Mn-doped ZnO and Li, Mn codoped-ZnO films with different concentrations using spin coating method. Crystal structure and magnetic measurements demonstrate that the impurity phases (ZnMnO₃) are not contributed to room temperature ferromagnetism and the ferromagnetism in Mn-doped ZnO film is intrinsic. Interesting, saturated magnetization decreases with Mn or Li concentration increase, showing that some antiferromagnetism exists in the samples with high Mn or Li concentration. In addition, Mn_0.05Zn_0.95O film annealed in vaccum shows larger ferromagnetism than the as-prepared sample and more oxygen vacancies induced by annealing in reducing atmosphere enhance ferromagnetism, which supports the bound magnetic polaron model on the origin of room temperature ferromagnetism.     

Synthesis, characterization and mechanism of cetyltrimethylammonium bromide bilayer-encapsulated gold nanosheets and nanocrystals

Single-crystal Au nanosheets and fcc gold nanocrystals of uniform size were synthesized by a novel and simple route. The results of field-emission scanning electron microscopy (SEM), transmission electron microscopy (TEM) and X-ray diffraction (XRD) indicated the formation of the single-crystal structure of gold nanosheets and fcc nanocrystals. Energy-dispersive analysis of X-ray (EDAX) showed absorbance of cetyltrimethylammonium bromide (CTAB) molecules onto the surface of gold nanostructures. Moreover, zeta potential measurements showed that CTAB-coated nanostructures were positively charged and the zeta potential remained almost the same upon centrifugation and redispersion of the resulting nanostructures in methanol, confirming the high stability of the surfactant-protected nanocomposites. Evolution of the nanostructures during the reaction was monitored by TEM observations. The results indicated that the formation of the gold nanostructures followed a two-step mechanism with a bilayer CTAB structure on the surface of the gold nanostructures.     

A delay fractioning approach to global synchronization of delayed complex networks with stochastic disturbances

In this Letter, the synchronization problem is investigated for a class of stochastic complex networks with time delays. By utilizing a new Lyapunov functional form based on the idea of ‘delay fractioning’, we employ the stochastic analysis techniques and the properties of Kronecker product to establish delay-dependent synchronization criteria that guarantee the globally asymptotically mean-square synchronization of the addressed delayed networks with stochastic disturbances. These sufficient conditions, which are formulated in terms of linear matrix inequalities (LMIs), can be solved efficiently by the LMI toolbox in Matlab. The main results are proved to be much less conservative and the conservatism could be reduced further as the number of delay fractioning gets bigger. A simulation example is exploited to demonstrate the advantage and applicability of the proposed result.     

Thermal stability of nucleation effect of different β-nucleating agents in isotactic polypropylene

Journal of Thermal Analysis and Calorimetry - The thermal stability of nucleation effect of three highly effective β-nucleating agents, namely an aryl diamide-based nucleating agent (TMB-5), a...