The boron-catalyzed polymerization of dimethylsulfoxonium methylide. A living polymethylene synthesis

Trialkyl and aryl organoboranes catalyze the polymerization of dimethylsulfoxonium methylide (1). The product of the polymerization is a tris-polymethylene organoborane. Oxidation affords linear telechelic alpha-hydroxy polymethylene. The polymer molecular weight was found to be directly proportional to the stoichiometric ratio of ylide/borane, and polydispersities as low as 1.01-1.03 have been realized. Although oligomeric polymethylene has been the most frequent synthetic target of this method, polymeric star organoboranes with molecular weights of 1.5 million have been produced. The average turnover frequency at 120 degrees C in 1,2,4,5-tetrachlorobenzene/toluene is estimated at >6 x 10(6) g of polymethylene (mol boron)(-1) h(-1). The mechanism of the polyhomologation reaction involves initial formation of a zwitterionic organoborane.ylide complex which breaks down in a rate-limiting 1,2-alkyl group migration with concomitant expulsion of a molecule of DMSO. The reaction was found to be first order in the borane catalyst and zero order in ylide. DMSO does not interfere with the reaction. The temperature dependence of the reaction rate yielded the following activation energy parameters (toluene, DeltaH(++) = 23.2 kcal/mol, DeltaS(++) = 12.6 cal deg/mol, DeltaG(++) = 19.5 kcal/mol; THF, DeltaH(++) = 26.5 kcal/mol, DeltaS(++) = 21.5 cal deg/mol, DeltaG(++) = 20.1 kcal/mol).     

含有杂环基侧链的新型聚硅氧烷

含有功能性基团的聚硅氧烷的研究一直是有机硅化学中十分活跃的研究领域之一。当含N、S等杂环引入聚硅氧烷链中后，由于杂环基的生理活性、催化活性及光电特性，因而含不同杂环基团的聚硅氧烷（POS）可分别用作催化剂、光电材料、医学材料等。当用作药物载体时，可提高药物的利用率和靶向性，也可降低某些药物的毒性。含环糊精侧基、冠醚侧基的POS亦可应用于气相色谱固定相、相转移催化剂。本文对近年来有关侧链含有吡啶、咪唑等杂环及环糊精基团等功能性侧基的聚硅氧烷结构、合成、及应用作一详细的评述并进行了展望。     

多壁碳纳米管结构与其电化学容量之间关系的研究

采用化学气相沉积法,通过改变催化剂的成分、碳源、反应和后处理条件来制 备不同管径、管长、石墨化程度的多壁碳纳米管。经电化学容量性能测试、透射电 子显微镜观察和N_2吸附等结构表征,发现管径分布为30.0～40.0 nm、管长越短、 石墨化程度越低、比表面积越大、孔容越大的多壁碳纳米管具有更好的电化学容量 。     

氯离子对铜在玻碳电极上电结晶的影响

采用线性扫描伏安法和计时安培法研究了硫酸铜溶液中铜在玻碳电极上电结晶 的初期行为。在含与不含氯离子的0.05mol·L~(-1) cUso_4-0.5 mol·L~(-1) H_2SO_4电解液中,循环伏安实验结果表明铜在玻碳基体上的沉积没有经过UPD过 程;氯离子明显使Cu的沉积和氧化峰变得尖锐,促进Cu的沉积速度。计时安培实验 结果表明,Cu的电结晶按瞬时成核和三维生长方式进行。氯离子不改变Cu的结晶机 理,但在I～t曲线中,导致电流达最大(I_m)所需的时间t_m减小、晶核数密度和生 长速度增大,从而明显改变Cu沉积层的质量。当Cl~-浓度在10～20mg·L~(-1)范围 内,成核的晶核数密度达较大,即氯离子的最适宜添加量。     

Binding modes of cucurbit[6]uril and cucurbit[7]uril with a series of bis-pyridinium compounds

Binding behaviors of cucurbit[6]uril (CB[6]) and cucurbit[7]uril (CB[7]) with a series of bis-pyridinium compounds N, N’-hexamethylenebis(1-alkyl-4-carbamoyl pyridinium bromide) (HBPB-n) (alkyl chain length, n = 6, 8 and 10) guests were investigated using ¹H-NMR, ESI–MS and single crystal X-ray diffraction methods. The results show that CB[6] and CB[7] can form [2]pseudorotaxanes with HBPB-n easily. When increasing the length of tail alkyl chain, the binding site of CB[6] at guest molecules changed from the tail to the middle part, while CB[7] remained located over the tail chain. As CB[6] and CB[7] were added in HBPB-8 aqueous solution, a [3]pseudorotaxane was formed by the inclusion of the internal middle site in CB[6] and the tail chain in CB[7].     

Enantiomeric separations of four basic drugs containing N-alkyl groups by a RP-HPLC system using SBE-β-CD as chiral mobile phase additive

The chiral separations of four pharmaceutical racemates which contain N-alkyl groups were satisfactorily resolved using SBE-β-CD as a chiral mobile phase additive(CMPA)in a RP-HPLC system(the resolution is 2.701 for ondansetron hydrochloride,1.996 for sulpiride,1.293 for clenbuterol hydrochloride and 0.816 for omeprazole).In addition,the effects of different parameters such as CD type and CD concentration were investigated.The separation mechanism arises through the combination of several potential interactions,including electrostatic interactions as well as hydrogen bonding interactions and hydrophobic inclusion interactions,which allow for the SBE-β-CD–drug complexation with strong stereoselectivity and stability.The resolution also relates to the number and location of N atoms in the enantiomers.This method will be applicable to the isolation of various types of biologically important enantiomers containing N-alkyl groups.     

Comparison of two ultrasound‐enhanced microextractions combined with HPLC for determining acaricides in water

An ultrasound‐enhanced in situ solvent formation microextraction has been developed first time and compared with ultrasound‐enhanced ionic‐liquid‐assisted dispersive liquid–liquid microextraction for the HPLC analysis of acaricides in environmental water samples. A ionic liquid ([C₈MIM][PF₆]) was used as the green extraction solvent through two pathways. The experimental parameters, such as the type and volume of both of the extraction solvent disperser solvent, ultrasonication time, and salt addition, were investigated and optimized. The analytical performance using the optimized conditions proved the feasibility of the developed methods for the quantitation of trace levels of acaricides by obtaining limits of detection that range from 0.54 to 3.68 μg/L. The in situ solvent formation microextraction method possesses more positive characteristics than the ionic‐liquid‐assisted dispersive liquid–liquid microextraction method (except for spirodiclofen determination) when comparing the validation parameters. Both methods were successfully applied to determining acaricides in real water samples.     

Preparation and evaluation of a novel molecularly imprinted SPE monolithic capillary column for the determination of auramine O in shrimp

A novel method combining molecular imprinting and SPE was developed in a capillary column for the determination of auramine O in shrimp. The capillary monolithic column was prepared by UV‐initiated in situ polymerization, using auramine O as template and methacrylic acid and ethylene dimethacrylate as functional monomer and cross‐linker, respectively. The properties of the prepared capillary monolithic column were investigated under the optimized conditions coupled with HPLC, and then the morphologies of the inner polymers were characterized by SEM. The calibration curve was expressed as A = 103C + 19.8 (r = 0.9992) with a linear range of 0.25–25.0 μg/mL, and the recoveries of auramine O at different concentrations in shrimp ranged from 90.5 to 92.4% with RSDs ranging from 2.1 to 4.4%. The capacities of the molecularly imprinted polymer and nonimprinted polymer columns were 0.722 and 0.147 μg/mg, respectively, and the LOD (S/N = 3) of auramine O in shrimp was 17.85 μg/kg. Under the selected conditions, the enrichment factors obtained were higher than 70‐fold. The results indicate that the prepared molecularly imprinted capillary monolithic column was reliable and applicable to the analysis of auramine O in shrimp.     

Ultra‐low friction of fluorine‐doped hydrogenated carbon film with curved graphitic structure

Fluorine‐doped hydrogenated carbon film was grown by chemical vapor deposition technique using CH₄ and CF₄ as feedstock, with a pulse DC‐bias power supply. The structure of as‐deposited film was characterized by transmission electron microscopy and Raman spectra. The results suggested that the film could be considered as composite thin film with curved graphitic structures embedded in amorphous carbon matrix. The mechanical properties and friction coefficient were tested by TI 950 TriboIndenter and UMT‐2 at humidity of 30%, respectively. The results showed that the film exhibited high hardness (~11.04 GPa), good elasticity recovery(~83%) and ultra‐low coefficient of friction (~0.01). Copyright © 2013 John Wiley & Sons, Ltd.     

Two Zinc(II) Coordination Polymers Based on the Ligand 1, 4‐Bis[(2‐methyl‐imidazol‐1‐yl)methyl]benzene: Syntheses,Crystal Structures and Properties

Two coordination polymers (CPs), {[Zn₂(BMB)(5‐AIPA)₂] · 2H₂O}_n( 1 ) and [Zn(BMB)(5‐NIPA)]_n( 2 ) {BMB = 1, 4‐bis[(2‐methyl‐imidazol‐1‐yl)methyl]benzene, 5‐AIPA = 5‐aminoisophthalic acid, 5‐NIPA = 5‐nitroisophthalic acid}, were synthesized under hydrothermal conditions. Compound 1 displays a 2D double‐layer structure, which is packed into a 3D supramolecule by interlayer hydrogen bonds and π–π stacking interactions. Compound 2 displays a threefold interpenetrating 3D network, which is composed of left‐handed helical chains and two types of meso‐helical chains along different directions.