离子速度成像技术研究2-溴戊烷的光解离动力学

运用离子速度成像技术研究了2-溴戊烷分子在～234 nm处的光解离动力学. 通过分析光解产物Br(²P_3/2)(简称Br)和Br(²P_1/2) (简称Br*)的速度影像,分别得到其速度分布和角度分布. Br和Br*的速度分布可以用两个高斯分布拟合,分别对应于2-溴戊烷在～234 nm处两个独立的光解离反应通道. 高能的高斯分量对应于C-Br伸缩振动模式的直接解离,低能的高斯分量对应于弯曲振动和C-Br伸缩振动耦合所导致的解离. 确定出光解离产物Br的相对量子产率为0.892,结合Br和Br*碎片的各项异性参数和溴原子的相对量子产率,讨论了³Q₀、³Q₁和¹Q₁激发态分别对产物Br和Br*的贡献. 通过对比溴代戊烷4种同分异构体光解离过程的差异,讨论了分子烷基分支化对光解机理的影响.     

A bubble detection technique based on light intensity and Mie scattering theory for spinning solution

A novel bubble detection technique based on light intensity and Mie scattering theory for spinning solution is presented theoretically and experimentally. With the light intensity in every direction, the particle or bubble size distribution can be calculated with the Mie scattering theory. The light intensity distribution in every direction, corresponding to the light intensity received by every assumed annulus of the detector has been calculated theoretically. According to the light intensity distribution, the size distribution of bubbles can be deduced. A series of standardized polystyrene micro-sphere (with 7 μm diameter) solution has been used not only as sample for experiments and calibration, but also as the bubbles in the glycerin. Theoretical and experimental results show that the technique can be used for bubble detection, in order to improve the traditional bubble detection scheme, and to lower production costs.     

Synthesis of Fluorescent Gold Nanoclusters Directed by Bovine Serum Albumin and Application for Nitrite Detection

In the present work, gold nanocluster (GNC) induced by bovine serum albumin (BSA) was synthesized as a novel fluorescence probe to detect nitrite (NO₂ ^?) sensitively and selectively. The fluorescence of GNC was found to be quenched effectively by NO₂ ^?. Under the optimum conditions, it was found that the change of fluorescence intensity was proportional with the concentration of NO₂ ^? in the linear range of 0.1–50 μM (R?=?0.9990), with a detection limit (S/N?=?3) of 30 nM. The absorption spectroscopy, circular dichroism (CD), and X-ray photoelectron spectroscopy (XPS) studies were employed to discuss the quenching mechanism. In addition, the present approach was successfully applied in real water samples.     

大气湍流三维波前探测模式层析算法分析

大气湍流三维波前探测是实现多层共轭自适应光学技术的关键和前提. 对湍流三维波前探测中最常用的模式法层析技术进行理论研究与分析, 提出该算法存在原理性限制, 并基于此对模式法层析技术产生误差的原因展开分析, 最后针对不同类型的模式层析重构误差给出数值仿真实验结果.分析表明, 模式层析重构中使用了Zernike分解基的一部分作为新的分解基进行波面拟合, 从而引入模式混淆和模式耦合两个方面的误差; 部分Zernike分解基不相关是避免模式混淆误差的必要条件, 模式耦合误差则无法避免. 最后结合仿真结果提出大视场探测、小区域重构的方法, 很好地抑制了模式耦合误差. 关键词： 三维波前探测 大气层析 模式法 误差分析     

Efficiency and multifractality analysis of CSI 300 based on multifractal detrending moving average algorithm

We apply the multifractal detrending moving average (MFDMA) to investigate and compare the efficiency and multifractality of 5-min high-frequency China Securities Index 300 (CSI 300). The results show that the CSI 300 market becomes closer to weak-form efficiency after the introduction of CSI 300 future. We find that the CSI 300 is featured by multifractality and there are less complexity and risk after the CSI 300 index future was introduced. With the shuffling, surrogating and removing extreme values procedures, we unveil that extreme events and fat-distribution are the main origin of multifractality. Besides, we discuss the knotting phenomena in multifractality, and find that the scaling range and the irregular fluctuations for large scales in the _Fq(s)$F_q\left(s\right)$ vs s$s$ plot can cause a knot.     

一种直接用示波器观测单变量非线性系统状态的新方法

为解决用示波器观测单变量非线性系统难的问题, 本文提出了一种45°线法, 该方法能将随时间变化的连续信号以特殊的方式转换成直角坐标上45°线上的点图, 并可用通用双踪示波器 (模拟或数字均可)直接显示出来, 从而达到直接方便地观测和分析单变量被测系统运行时的各种状态, 如周期稳定态, 局部和全局不稳定态. 文中详细阐述了该方法的机理. 同时, 研究和解决了设计实现该方法物理电路的关键问题, 即从连续变化的信号中提取出能反映系统状态的有用信号. 由于蔡氏电路是典型的非线性系统, 且能随参数的变化产生各种丰富的状态, 本文选用该电路作为被测系统进行了大量的物理实验, 实验结果证实了该方法的有效性和实用性. 关键词： 45°线法 单变量系统 系统状态 双踪示波器     

Surface and interfacial properties of PVDF/acrylic copolymer blends before and after UV exposure

Morphological and chemical properties of both the surface and interface of poly(vinylidene fluoride)/poly(methyl methacrylate)-co-poly(ethyl acrylate) (PVDF/PMMA-co-PEA) blend films have been investigated before and after the samples were exposed to ultraviolet (UV) irradiation using a xenon arc lamp at 50 °C and 9% relative humidity (RH) for 7 months. Surface and interfacial morphologies were studied by atomic force microscopy (AFM). Chemical composition information was obtained by confocal Raman microscopy, attenuated total reflection-FTIR spectroscopy (ATR-FTIR), X-ray photoelectron spectroscopy (XPS), and contact angle measurements. Results show an enrichment of the PVDF material at the air surface, while the acrylic copolymer enriches the interface. Blends having greater than 50% mass fraction of PVDF show little change in the surface morphology after UV exposure for 7 months. However, for a lower PVDF content, blends exhibit significant degradation of PMMA-co-PEA copolymer and a much rougher surface after UV exposure. Microstructural changes in the PVDF spherulites are also observed after UV degradation. It is found that the surface and interfacial morphologies are correlated with the chemical properties.     

Microwave absorption properties of composite powders with low density

The composites of barium ferrite coated on hollow ceramic microspheres were prepared using sol-gel technique. The crystal structure, morphology and microwave absorption properties of composite powders with different weight ratio of microspheres were studied with XRD, EDS, FESEM and vector network analyzer. The results show that the microwave absorption properties of composite powders are greatly improved. The maximum microwave loss of composite powders reaches 31 dB with an amount of 50 wt.% microspheres, and its density is only about 1.80 g/cm³. The effect of hollow ceramic microspheres on the microwave absorption property is also discussed.     

Interfaces between Al2O3 and beta-Ni(1-x)Al(x) alloys: complex structures and Ab initio thermodynamics

A methodology to study the structural stability of binary alloy/Al2O3 interfaces is developed by expanding the conventional ab initio thermodynamics to include the dependence on alloy composition. Results on beta-Ni(1-x)Al(x)/Al2O3 interfaces predict the existence of two types of stable interfaces. The stable interface at equilibrium with Al-rich or strictly 1:1 alloy contains an Al2-terminated Al2O3 surface and continues with NiAl layers, and the interface at equilibrium with Ni-rich alloy has Al accumulation but continues with a Ni-rich and then NiAl layers. Works of separation for the two interfaces are close to each other.     

Structural and magnetic properties of RF sputtered FePt/Fe multilayers

Series of [FePt(4min)/Fe(t_Fe)]₁₀ multilayers have been prepared by RF magnetron sputtering and post-annealing in order to optimize their magnetic properties by structural designs. The structure, surface morphology, composition and magnetic properties of the deposited films have been characterized by X-ray diffractometer (XRD), Rutherford backscattering (RBS), scanning electron microscope (SEM), energy dispersive X-ray spectroscope (EDX) and vibrating sample magnetometer (VSM). It is found that after annealing at temperatures above 500 °C, FePt phase undergoes a phase transition from disordered FCC to ordered FCT structure, and becomes a hard magnetic phase. X-ray diffraction studies on the series of [FePt/Fe]_n multilayer with varying Fe layer thickness annealed at 500 and 600 °C show that lattice constants change with Fe layer thickness and annealing temperature. Both lattice constants a and c are smaller than those of standard ones, and lattice constant a decreases as Fe layer deposition time increases. Only a slight increase in grain size was observed as Fe layer decreased in samples annealed at 500 °C. However, the increase in grain size is large in samples annealed at 600 °C. The coercivities of [FePt/Fe]_n multilayers decrease with Fe layer deposition time, and the energy product (BH)_max reaches a maximum in the samples with Fe layer deposition time of 3 min. Comparison of magnetic properties with structure showed an almost linear relationship between the lattice constant a and the coercivities of the FePt phase.